Raul E. Bolmaro

Articles in Scholarly Journals [Incomplete List]

  1. Deformation and texture evolution in AZ31 magnesium alloy during uniaxial loading
    Acta Materialia, vol. 54, no. 2, pp. 549–562, 2006
  2. Mechanical spectroscopy of deformed WE43 magnesium alloys
    Materials Science and Engineering: A, vol. 442, no. 1-2, pp. 476–479, 2006
  3. Computational modeling of texture and microstructure evolution in Al alloys deformed by ECAE
    Scripta Materialia, vol. 55, no. 12, pp. 1099–1102, 2006
  4. Obtaining of single phase Cu?Li alloy through an electrodeposition process
    Materials Letters, vol. 59, no. 2-3, pp. 349–354, 2005
  5. Recrystallization textures in fcc materials: A simulation based on micromechanical modeling data
    Scripta Materialia, vol. 53, no. 2, pp. 147–152, 2005
  6. Development of wire drawing textures in Cu–Fe: the influence of macroscopic and microscopic heterogeneities
    Modelling and Simulation in Materials Science and Engineering, vol. 14, no. 1, pp. 1–19, 2005
  7. Growing of crystalline zones in EPDM irradiated with a low neutron flux
    Nuclear Instruments and Methods in Physics Research Section B: Beam Interactions with Materials and Atoms, vol. 225, no. 3, pp. 297–304, 2004
  8. In situ measurements of texture variations during a tensile loading of Mg-alloy AM20 using synchrotron X-ray radiation
    Scripta Materialia, vol. 51, no. 5, pp. 455–460, 2004
  9. Cyclic softening mechanisms of Zry-4 at room temperature: the unlikely influence of texture variations
    Scripta Materialia, vol. 51, no. 6, pp. 617–621, 2004
  10. Cyclic softening mechanisms of Zircaloy-4
    Journal of Nuclear Materials, vol. 326, no. 2-3, pp. 195–200, 2004
  11. A new approach to crystal spin calculation during deformation texture development
    Scripta Materialia, vol. 43, no. 6, pp. 553–559, 2000
  12. Texture development of wire drawn Cu–Fe composites
    Physica B: Condensed Matter, vol. 276-278, no. 1-3, pp. 888–889, 2000
  13. Explicit method for calculating the effective properties and micromechanical stresses: An application to an alumina-SiC composite
    Philosophical Magazine A, vol. 79, no. 6, pp. 1379–1394, 1999
  14. Experiments and Simulations by Self-Consistent Models of Texture Development in Cu–Fe Powder Composites
    Textures and Microstructures, vol. 33, no. 1-4, pp. 125–137, 1999
  15. Influence of the localized initial plastic deformation on the effective thermomechanical response of metal-matrix composites
    Metallurgical and Materials Transactions A, vol. 30, no. 11, pp. 2875–2884, 1999
  16. An iterative approach to mechanical properties of MMCs at the onset of plastic deformation
    Materials Science and Engineering A, vol. 229, no. 1-2, pp. 203–218, 1997
  17. An Eshelby inclusion based model for the study of stresses and plastic strain localization in metal matrix composites II. Fiber reinforcement and lamellar inclusions
    Materials Science and Engineering A, vol. 229, no. 1-2, pp. 192–202, 1997
  18. An Eshelby inclusion-based model for the study of stresses and plastic strain localization in metal matrix composites I: General formulation and its application to round particles
    Materials Science and Engineering A, vol. 229, no. 1-2, pp. 182–191, 1997
  19. Crystal spin in two-sites self consistent models: From kinematics to kinetics
    Computational Materials Science, vol. 9, no. 1-2, pp. 237–250, 1997
  20. Self-Consistent Method to Calculate Fiber Interactions in a SiC/Al2O3 Ceramic Composite
    Journal of the American Ceramic Society, vol. 79, no. 6, pp. 1466–1472, 1996
  21. Finite element method simulations for two-phase material plastic strains
    Materials Science and Engineering A, vol. 196, no. 1-2, pp. 53–63, 1995
  22. Texture development in Ag_Ni powder composites
    Materials Science and Engineering A, vol. 175, no. 1-2, pp. 113–124, 1994
  23. Grain Axes Coincidence Model: Relaxed Constraints and Finite Strains Revisited
    Textures and Microstructures, vol. 22, no. 3, pp. 187–198, 1994
  24. On plastic strain distribution and texture development in fiber composites
    Acta Metallurgica et Materialia, vol. 41, no. 6, pp. 1893–1905, 1993
  25. A comparison of the texture development in pure and simple shear and during path changes
    Scripta Metallurgica et Materialia, vol. 27, no. 12, pp. 1717–1722, 1992
  26. Elastic and anelastic behaviour of icosahedral quasicrystals
    Journal of Materials Science, vol. 24, no. 8, pp. 2975–2980, 1989
  27. Anelastic behaviour of materials under multiaxial strains
    Journal of Materials Science, vol. 23, no. 1, pp. 93–100, 1988
  28. Anelastic behaviour of materials under multiaxial strains
    Journal of Materials Science, vol. 23, no. 1, pp. 371–379, 1988
  29. Anelastic behaviour of materials under multiaxial strains
    Journal of Materials Science, vol. 22, no. 11, pp. 4158–4164, 1987
  30. On the measurement of Young's modulus of tubes by propagation of longitudinal waves
    Journal of Nuclear Materials, vol. 116, no. 2-3, pp. 166–171, 1983
  31. Poisson's ratio in zirconium single crystals
    Journal of Nuclear Materials, vol. 118, no. 1, pp. 78–82, 1983