About this Journal Submit a Manuscript Table of Contents
Advances in Mechanical Engineering
Volume 2012 (2012), Article ID 519471, 18 pages
http://dx.doi.org/10.1155/2012/519471
Research Article

Modeling and Calibration for Crack Detection in Circular Shafts Supported on Bearings Using Lateral and Torsional Vibration Measurements

Faculty of Engineering and Applied Science, Memorial University of Newfoundland, St. John's, NL, Canada A1B 3X5

Received 10 June 2011; Revised 25 September 2011; Accepted 14 October 2011

Academic Editor: A. Seshadri Sekhar

Copyright © 2012 A. Tlaisi et al. This is an open access article distributed under the Creative Commons Attribution License, which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited.

How to Cite this Article

A. Tlaisi, A. S. J. Swamidas, M. R. Haddara, and A. Akinturk, “Modeling and Calibration for Crack Detection in Circular Shafts Supported on Bearings Using Lateral and Torsional Vibration Measurements,” Advances in Mechanical Engineering, vol. 2012, Article ID 519471, 18 pages, 2012. doi:10.1155/2012/519471