- About this Journal
- Abstracting and Indexing
- Aims and Scope
- Annual Issues
- Article Processing Charges
- Articles in Press
- Author Guidelines
- Bibliographic Information
- Citations to this Journal
- Contact Information
- Editorial Board
- Editorial Workflow
- Free eTOC Alerts
- Publication Ethics
- Reviewers Acknowledgment
- Submit a Manuscript
- Subscription Information
- Table of Contents
BioMed Research International
Volume 2013 (2013), Article ID 234093, 9 pages
External Mechanical Microstimuli Modulate the Osseointegration of Titanium Implants in Rat Tibiae
1Division of Bone Diseases, Department of Internal Medicine and Faculty of Medicine, University Hospital of Geneva,
1211 Geneva, Switzerland
2Laboratory of Biomaterials, School of Dentistry, University of Geneva, 1205 Geneva, Switzerland
3Laboratory of Applied Mechanics and Reliability Analysis, École Polytechnique Fédérale de Lausanne, 1015 Lausanne, Switzerland
4Division of Bone Diseases, Department of Rehabilitation and Geriatrics, Av de la Roseraie 64, University Hospital of Geneva, 1211 Geneva, Switzerland
Received 12 July 2013; Revised 28 October 2013; Accepted 28 October 2013
Academic Editor: P. Bryant Chase
Copyright © 2013 Giovanna Zacchetti et al. This is an open access article distributed under the Creative Commons Attribution License, which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited.
- R. Dayer, R. Rizzoli, A. Kaelin, and P. Ammann, “Low protein intake is associated with impaired titanium implant osseointegration,” Journal of Bone and Mineral Research, vol. 21, no. 2, pp. 258–264, 2006.
- L. Maïmoun, T. C. Brennan, I. Badoud, V. Dubois-Ferriere, R. Rizzoli, and P. Ammann, “Strontium ranelate improves implant osseointegration,” Bone, vol. 46, no. 5, pp. 1436–1441, 2010.
- R. Dayer, T. C. Brennan, R. Rizzoli, and P. Ammann, “PTH improves titanium implant fixation more than pamidronate or renutrition in osteopenic rats chronically fed a low protein diet,” Osteoporosis International, vol. 21, no. 6, pp. 957–967, 2010.
- K. C. L. Lee, A. Maxwell, and L. E. Lanyon, “Validation of a technique for studying functional adaptation of the mouse ulna in response to mechanical loading,” Bone, vol. 31, no. 3, pp. 407–412, 2002.
- F. M. Lambers, F. A. Schulte, G. Kuhn, D. J. Webster, and R. Müller, “Mouse tail vertebrae adapt to cyclic mechanical loading by increasing bone formation rate and decreasing bone resorption rate as shown by time-lapsed in vivo imaging of dynamic bone morphometry,” Bone, vol. 49, no. 6, pp. 1340–1350, 2011.
- L. Baggi, I. Cappelloni, M. Di Girolamo, F. Maceri, and G. Vairo, “The influence of implant diameter and length on stress distribution of osseointegrated implants related to crestal bone geometry: a three-dimensional finite element analysis,” Journal of Prosthetic Dentistry, vol. 100, no. 6, pp. 422–431, 2008.
- L. M. Vasconcellos, F. N. Oliveira, O. Leite Dde, et al., “Novel production method of porous surface Ti samples for biomedical application,” Journal of Materials Science, vol. 23, no. 2, pp. 357–364, 2012.
- D. L. Cochran, “A comparison of endosseous dental implant surfaces,” Journal of Periodontology, vol. 70, no. 12, pp. 1523–1539, 1999.
- H. W. A. Wiskott, P. Bonhote, J. Cugnoni et al., “Implementation of the “loaded implant” model in the rat using a miniaturized setup—description of the method and first results,” Clinical Oral Implants Research, vol. 23, no. 12, pp. 1352–1359, 2012.
- M. Piccinini, J. Cugnoni, J. Botsis, G. Zacchetti, P. Ammann, and A. Wiskott, “Factors affecting subject-specific finite element models of implant-fitted rat bone specimens. Critical analysis of a technical protocol,” Computer Methods in Biomechanics and Biomedical Engineering, 2013.
- E. Cory, A. Nazarian, V. Entezari, V. Vartanians, R. Müller, and B. D. Snyder, “Compressive axial mechanical properties of rat bone as functions of bone volume fraction, apparent density and micro-ct based mineral density,” Journal of Biomechanics, vol. 43, no. 5, pp. 953–960, 2010.
- P. Ammann, I. Badoud, S. Barraud, R. Dayer, and R. Rizzoli, “Strontium ranelate treatment improves trabecular and cortical intrinsic bone tissue quality, a determinant of bone strength,” Journal of Bone and Mineral Research, vol. 22, no. 9, pp. 1419–1425, 2007.
- S. Hengsberger, P. Ammann, B. Legros, R. Rizzoli, and P. Zysset, “Intrinsic bone tissue properties in adult rat vertebrae: modulation by dietary protein,” Bone, vol. 36, no. 1, pp. 134–141, 2005.
- W. C. Oliver and G. M. Pharr, “An improved technique for determining hardness and elastic modulus using load and displacement sensing indentation experiments,” Journal of Materials Research, vol. 7, no. 6, pp. 1564–1583, 1992.
- G. S. Throckmorton and P. C. Dechow, “In vitro strain measurements in the condylar process of the human mandible,” Archives of Oral Biology, vol. 39, no. 10, pp. 853–867, 1994.
- B. Kaye, C. Randall, D. Walsh, and P. Hansma, “The effect of freezing on the mechanical properties of bone,” Open Bone Journal, vol. 4, pp. 14–19, 2012.
- M. Diefenbeck, “Freezing of rat tibiae at -20°c does not affect the mechanical properties of intramedullary bone/implant-interface: brief report,” The Open Orthopaedics Journal, vol. 5, pp. 219–222, 2011.
- J. W. M. Chow, C. J. Jagger, and T. J. Chambers, “Characterization of osteogenic response to mechanical stimulation in cancellous bone of rat caudal vertebrae,” American Journal of Physiology—Endocrinology and Metabolism, vol. 265, no. 2, part 1, pp. E340–E347, 1993.
- C. J. Jagger, T. J. Chambers, and J. W. M. Chow, “Stimulation of bone formation by dynamic mechanical loading of rat caudal vertebrae is not suppressed by 3-amino-1-hydroxypropylidene-1-bisphosphonate (AHPrBP),” Bone, vol. 16, no. 3, pp. 309–313, 1995.
- R. Dayer, I. Badoud, R. Rizzoli, and P. Ammann, “Defective implant osseointegration under protein undernutrition: prevention by PTH or pamidronate,” Journal of Bone and Mineral Research, vol. 22, no. 10, pp. 1526–1533, 2007.
- D. L. Cochran, R. K. Schenk, A. Lussi, F. L. Higginbottom, and D. Buser, “Bone response to unloaded and loaded titanium implants with a sandblasted and acid-etched surface: a histometric study in the canine mandible,” Journal of Biomedical Materials Research, vol. 40, no. 1, pp. 1–11, 1998.
- S. Lossdörfer, Z. Schwartz, L. Wang et al., “Microrough implant surface topographies increase osteogenesis by reducing osteoclast formation and activity,” Journal of Biomedical Materials Research A, vol. 70, no. 3, pp. 361–369, 2004.
- A. Wennerberg and T. Albrektsson, “Effects of titanium surface topography on bone integration: a systematic review,” Clinical Oral Implants Research, vol. 20, supplement 4, pp. 172–184, 2009.
- M. Ito, S. Ejiri, H. Jinnai et al., “Bone structure and mineralization demonstrated using synchrotron radiation computed tomography (SR-CT) in animal models: preliminary findings,” Journal of Bone and Mineral Metabolism, vol. 21, no. 5, pp. 287–293, 2003.
- H. Jung, H.-J. Kim, S. Hong et al., “Osseointegration assessment of dental implants using a synchrotron radiation imaging technique: a preliminary study,” International Journal of Oral and Maxillofacial Implants, vol. 18, no. 1, pp. 121–126, 2003.
- H. Sarve, B. Friberg, G. Borgefors, and C. B. Johansson, “Introducing a novel analysis technique for osseointegrated dental implants retrieved 29 years postsurgery,” Clinical Implant Dentistry and Related Research, vol. 15, no. 4, pp. 538–549, 2013.
- H. M. Frost, “Wolff's law and bone's structural adaptations to mechanical usage: an overview for clinicians,” Angle Orthodontist, vol. 64, no. 3, pp. 175–188, 1994.
- N. Bonnet, K. N. Standley, E. N. Bianchi et al., “The matricellular protein periostin is required for sost inhibition and the anabolic response to mechanical loading and physical activity,” The Journal of Biological Chemistry, vol. 284, no. 51, pp. 35939–35950, 2009.
- Y.-F. Hsieh and C. H. Turner, “Effects of loading frequency on mechanically induced bone formation,” Journal of Bone and Mineral Research, vol. 16, no. 5, pp. 918–924, 2001.
- A. G. Robling, D. B. Burr, and C. H. Turner, “Skeletal loading in animals,” Journal of Musculoskeletal and Neuronal Interactions, vol. 1, no. 3, pp. 249–262, 2001.
- A. G. Robling, K. M. Duijvelaar, J. V. Geevers, N. Ohashi, and C. H. Turner, “Modulation of appositional and longitudinal bone growth in the rat ulna by applied static and dynamic force,” Bone, vol. 29, no. 2, pp. 105–113, 2001.
- R. A. Hillam and T. M. Skerry, “Inhibition of bone resorption and stimulation of formation by mechanical loading of the modeling rat ulna in vivo,” Journal of Bone and Mineral Research, vol. 10, no. 5, pp. 683–689, 1995.
- T. C. Brennan-Speranza, R. Rizzoli, B. E. Kream, C. Rosen, and P. Ammann, “Selective osteoblast overexpression of IGF-I in mice prevents low protein-induced deterioration of bone strength and material level properties,” Bone, vol. 49, no. 5, pp. 1073–1079, 2011.
- J. M. Lean, A. G. Mackay, J. W. M. Chow, and T. J. Chambers, “Osteocytic expression of mRNA for c-fos and IGF-I: an immediate early gene response to an osteogenic stimulus,” American Journal of Physiology—Endocrinology and Metabolism, vol. 270, no. 6, part 1, pp. E937–E945, 1996.
- C. M. A. Reijnders, N. Bravenboer, A. M. Tromp, M. A. Blankenstein, and P. Lips, “Effect of mechanical loading on insulin-like growth factor-I gene expression in rat tibia,” Journal of Endocrinology, vol. 192, no. 1, pp. 131–140, 2007.
- C. Kesavan, J. E. Wergedal, K.-H. William Lau, and S. Mohan, “Conditional disruption of IGF-I gene in type 1α collagen-expressing cells shows an essential role of IGF-I in skeletal anabolic response to loading,” American Journal of Physiology—Endocrinology and Metabolism, vol. 301, no. 6, pp. E1191–E1197, 2011.