- About this Journal ·
- Abstracting and Indexing ·
- Aims and Scope ·
- Article Processing Charges ·
- Articles in Press ·
- Author Guidelines ·
- Bibliographic Information ·
- Citations to this Journal ·
- Contact Information ·
- Editorial Board ·
- Editorial Workflow ·
- Free eTOC Alerts ·
- Publication Ethics ·
- Submit a Manuscript ·
- Subscription Information ·
- Table of Contents

ISRN Condensed Matter Physics

Volume 2012 (2012), Article ID 596357, 4 pages

http://dx.doi.org/10.5402/2012/596357

## Investigation of Structural Phase Transition of PbS

High Pressure Research Laboratory, Department of Physics, Barkatullah University, Bhopal 462026, India

Received 29 August 2012; Accepted 11 October 2012

Academic Editors: J. Jeffries, M. Kato, K. Matsuhira, and L. Pusztai

Copyright © 2012 Purvee Bhardwaj. This is an open access article distributed under the Creative Commons Attribution License, which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited.

#### Abstract

The high-pressure structural phase transition of semiconductor PbS has been investigated, using the three body potential (TBP) model. Phase transition pressures are associated with a sudden collapse in volume. The phase transition pressures and related volume collapses obtained from this model show a generally good agreement with available results. Moreover, the elastic properties of PbS are also investigated.

#### 1. Introduction

In current years, IV–VI semiconductors are one of the most important narrow gap materials in electronics. These semiconductors are widely applied in fundamental information of solid-state electronic device fabrication. In this group of semiconductors, lead chalcogenides PbX ( = S, Se, and Te) are primarily semiconducting materials [1]. Lead chalcogenides are well known to be good materials for thermoelectric due to their low thermoconductivity. Lead chalcogenides remain one of the basic materials of modern infrared optoelectronics [2].

The structural high pressure behaviour of lead chalcogenides has paid considerable interest from both theoretical and experimental works [3–10]. Among these lead chalcogenides the lead sulphide PbS is useful as detector in infrared radiation. PbS crystallizes in the rocksalt (NaCl) type () structure at normal condition. First-order phase transition of PbS has been studied using high-pressure X-ray diffraction [4–7]. The ab initio electronic study of pressure induced structural phase transition of lead sulphide has been carried out by Bencherif et al. [8]. Phase transformation and conductivity in nanocrystal PbS under pressure have been investigated by Jiang et al. [9]. Zhang et al. investigated the elastic properties of PbS [10]. First-principles study of to phase transition in PbS has been performed by Bhambhani et al. [11].

It seems from the above literature that the present compound is less studied; we applied the three-body potential (TBP) model to the present compound for studying the high-pressure phase transition and volume collapse. The need of inclusion of three-body interaction forces was emphasized by many workers for the betterment of results [12, 13]. The model and calculation is given in Section 2 and the result and discussion is given in Section 3.

#### 2. Model and Calculation

Application of pressure directly results in compression leading to the increased charge transfer (or three body interaction effect [14]) due to the deformation of the overlapping electron shell of the adjacent ions (or nonrigidity of ions) in solids.

These effects have been included in the Gibbs free energy as a function of pressure and three body interactions (TBI) [14], which are the most dominant among the many body interactions. Here, is the internal energy of the system equivalent to the lattice energy at temperature near zero, is pressure, is volume, and is the entropy. The Gibbs free energies for rock salt () and CsCl () structures at temperature are given by the following equations: With and as unit cell volumes for and phases, respectively. The first terms in (1) are lattice energies for and structures and they are expressed as follows: Here, and as the Madelung constants for NaCl and CsCl structure, respectively. and are the overall van der Waal coefficients of () phases, are the Pauling coefficients. Ze is the ionic charge and b () are the hardness (range) parameters, are the nearest neighbour separations for NaCl (CsCl) structure is the three body force parameter.

These lattice energies consists of long-range Coulomb energy (first term), three-body interactions corresponding to the nearest neighbour separation (second term), vdW (van der Waal) interaction (third term), and energy due to the overlap repulsion represented by Hafemeister and Flygare (HF) type potential and extended up to the second neighbour ions (remaining terms).

#### 3. Results and Discussion

The input data of the crystal are listed in Table 1. The Gibbs free energies contain three-model parameters . The values of these parameters have been estimated using the first- and second-order space derivatives of the lattice energy given as follows [15–20]:

The values of computed model parameters have been given in Table 1. With these model parameters and the minimization technique, the phase transition pressure of the present compound has been computed.

##### 3.1. Structural Properties

The present compound is stable in NaCl structure at normal condition and high pressure it transforms to body centre CsCl structure. We have followed the technique of minimization of Gibbs free energies of NaCl and CsCl phases. We have minimized and given by (2) at different pressures in order to obtain the interionic separations and corresponding to and phases associated with minimum energies. The phase transition pressure () is the pressure at which approaches zero. At these compounds undergo a transition associated with a sudden collapse in volume. Figure 1 shows our present computed phase transition pressure for NaCl-type to CsCl-type structures in PbS at 19.8 GPa. The present phase transition pressure pointed up by arrows in Figure 1. The value of phase transition pressure has been listed in Table 2 and compared with experimental [4] and other theoretical results [8]. It is remarkable to note from the Table 2 that the phase transition pressure (), obtained from present model is in closer agreement with experimental than others theoretical results [8].

In addition, the pressure volume behaviour of the present compound has also been studied. At the phase transition pressure there is a sudden collapse in volume has been occurred. This type of transition shows the first-order phase transition. The computed value of volume collapse for lead sulphide has been given in Table 2. The compression curve has been plotted in Figure 2 for PbS. The NaCl and CsCl phases have been shown in this figure.

##### 3.2. Elastic Properties

Elastic constants supply useful information concerning with the change in the character of covalent and ionic forces induced in the crystal as it is subjected to the phase transformation. We have calculated the second-order elastic constants, bulk modulus, and pressure derivative of bulk modulus for lead sulphide. The information of second-order elastic constants (SOECs) and their pressure derivatives are important for the understanding of the interatomic forces in solids. The expressions of second order elastic constants are expressed as [14–19] follows:

Using model parameters , pressure derivatives of bulk modulus have been computed whose expressions are as follows: The values of , , and have been evaluated from the knowledge of , and vdW coefficients.

The calculated values of second order elastic constants and pressure derivative of bulk modulus have been given in Table 3. We have compared our results with experimental [7] and other theoretical results [10]. The present calculated values are in good agreement with experimental results than others theoretical calculation [10]. In addition, to reproduce the correct sign of the elastic constants, the value of Cauchy discrepancy have also been calculated. Due to including the charge transfer effect, the present model able to explain the Cauchy discrepancy (). The two-body potential model failed to explain the Cauchy discrepancy (). The value of pressure derivative of bulk modulus has been compared with the first principle calculation [11]. The present value of is comparable with the others result [11]. The value of shear modulus () has also been calculated by the present model for PbS. The value of S is given in Table 3.

#### 4. Conclusion

In conclusion, we have applied Three Body Potential (TBP) model (including the charge transfer effect) to investigate the structural and mechanical properties of PbS. The results are summarized as follows.(1)The present compound crystallizes in six-fold-coordinated NaCl-type structure () at normal conditions and under pressure, they transform to the eight-fold-coordinated CsCl-type structure ().(2)During the NaCl to CsCl phase transition, the volume discontinuity in pressure volume phase diagram identifies the occurrence of first-order phase transition.(3)The present calculated phase transition pressure and volume collapses are in general in good agreement with the available data.(4)The calculated values of second-order elastic constants, their pressure derivatives, and Cauchy discrepancy () are in general better than theoretical results and good agreement with the available experimental results.(5)Our model able to explain the previous drawbacks of Cauchy discrepancy () in the second-order elastic constants.

Finally, it may be concluded that there is generally a good agreement of three-body potential (TBP) model with the available experimental data than others theoretical values. Consequently the present model has successfully predicted the compression curves and phase diagrams giving the phase transition pressure, associated volume collapse correctly for the present compound. The present approach may also applied for other semiconductors of the same group. Moreover, the present model is able to explain the Cauchy discrepancy. The calculated values of Cauchy discrepancy () have been given in Table 3 for the present compound.

#### References

- S. P. Zimin, E. S. Gorlachev, I. I. Amirov, H. Zogg, E. Ambramof, and P. H. O. Rappl, “Sputtering rates of lead chalcogenide-based ternary solid solutions during inductively coupled argon plasma treatment,”
*Semicondutor Science & Technology*, vol. 26, Article ID 105003, 5 pages, 2011. View at Publisher · View at Google Scholar - S. Kumar and M. J. M. Khan, “Schottky barrier junctions of gold with lead chalcogenides: growth and characteristics,”
*Chalcogenide Letters*, vol. 9, no. 3, pp. 99–103, 2012. - R. Dornhaus, G. Nimtz, and B. Schlicht,
*Narrow Gap Semiconductors*, Springer, Berlin, Germany, 1985. - T. Chattopadhyay, H. G. von Schnering, W. A. Grosshans, and W. B. Holzapfel, “High pressure X-ray diffraction study on the structural phase transitions in PbS, PbSe and PbTe with synchrotron radiation,”
*Physica B+C*, vol. 139-140, pp. 356–360, 1986. View at Scopus - J. Maclean, P. D. Hatton, R. O. Piltz, J. Crain, and R. J. Cernik, “Structural studies of semiconductors at very high pressures,”
*Nuclear Instruments and Methods in Physics Research B*, vol. 97, no. 1–4, pp. 354–357, 1995. View at Scopus - A. Onodera, Y. Fujii, and S. Sugai, “Polymorphism and amorphism at high pressure,”
*Physica B+C*, vol. 139-140, pp. 240–245, 1986. View at Scopus - O. Madelung, M. Schulz, and H. Weiss,
*Landolt-Bornstei*, vol. 17 of*New Series*, Springer, Berlin, Germany, 1983. - Y. Bencherif, A. Boukra, A. Zaoui, and M. Ferhat, “High-pressure phases of lead chalcogenides,”
*Materials Chemistry and Physics*, vol. 126, no. 3, pp. 707–710, 2011. View at Publisher · View at Google Scholar · View at Scopus - J. Z. Jiang, L. Gerward, R. Secco, D. Frost, J. S. Olsen, and J. Truckenbrodt, “Phase transformation and conductivity in nanocrystal PbS under pressure,”
*Journal of Applied Physics*, vol. 87, no. 5, pp. 2658–2660, 2000. View at Scopus - Y. Zhang, X. Ke, C. Chen, J. Yang, and P. R. C. Kent, “Thermodynamic properties of PbTe, PbSe, and PbS: first-principles study,”
*Physical Review B*, vol. 80, no. 2, Article ID 024304, 12 pages, 2009. View at Publisher · View at Google Scholar - P. Bhambhani, N. Munjal, G. Sharma, V. Vyas, B. K. Sharma, and B. K. :, “First-principles study of B1 to B2 phase transition in PbS,”
*Journal of Physics*, vol. 377, Conference 1, Article ID 012068, 2012. View at Publisher · View at Google Scholar - C. E. Sims, G. D. Barrera, N. L. Allan, and W. C. Mackrodt, “Thermodynamics and mechanism of the B1-B2 phase transition in group-I halides and group-II oxides,”
*Physical Review B*, vol. 57, no. 18, pp. 11164–11172, 1998. View at Scopus - S. Froyen and M. L. Cohen, “Structural properties of NaCl and KCl under pressure,”
*Journal of Physics C*, vol. 19, no. 15, pp. 2623–2632, 1986. View at Publisher · View at Google Scholar - R. K. Singh, “Many body interactions in binary ionic solids,”
*Physics Reports*, vol. 85, no. 5, pp. 259–401, 1982. View at Scopus - P. Bhardwaj, S. Singh, and N. K. Gaur, “Structural and elastic properties of barium chalcogenides (BaX, X=O, Se, Te) under high pressure,”
*Central European Journal of Physics*, vol. 6, no. 2, pp. 223–229, 2008. View at Publisher · View at Google Scholar · View at Scopus - P. Bhardwaj, S. Singh, and N. K. Gaur, “Structural, elastic and thermophysical properties of divalent metal oxides with NaCl structure,”
*Materials Research Bulletin*, vol. 44, no. 6, pp. 1366–1374, 2009. View at Publisher · View at Google Scholar · View at Scopus - S. Singh and P. Bhardwaj, “Structural phase stability and elastic behavior of III-V scandium pnictides,”
*Physica B*, vol. 406, no. 8, pp. 1615–1621, 2011. View at Publisher · View at Google Scholar · View at Scopus - P. Bhardwaj and S. Singh, “Structural analysis of partially covalent lanthanide and actinide bismuthides with phase-transition pressures below 14 GPa,”
*Physica Status Solidi B*, vol. 249, no. 1, pp. 38–49, 2012. View at Publisher · View at Google Scholar - P. Bhardwaj, “Structural and thermophysical properties of cadmium oxide,”
*ISRN Thermodynamics*, vol. 2012, Article ID 798140, 4 pages, 2012. View at Publisher · View at Google Scholar - P. Bhardwaj, “Structural study of transition metal carbides,”
*Acta Physica Polonica A*, vol. 122, no. 1, pp. 138–141, 2012.