- About this Journal ·
- Abstracting and Indexing ·
- Aims and Scope ·
- Article Processing Charges ·
- Articles in Press ·
- Author Guidelines ·
- Bibliographic Information ·
- Citations to this Journal ·
- Contact Information ·
- Editorial Board ·
- Editorial Workflow ·
- Free eTOC Alerts ·
- Publication Ethics ·
- Reviewers Acknowledgment ·
- Submit a Manuscript ·
- Subscription Information ·
- Table of Contents
ISRN Materials Science
Volume 2013 (2013), Article ID 679820, 9 pages
An Overview of Semisolid Processing of Aluminium Alloys
Department of Mechanical and Materials Engineering, Faculty of Engineering and Built Environment, Universiti Kebangsaan Malaysia, 43600 Selangor, Malaysia
Received 9 November 2012; Accepted 19 December 2012
Academic Editors: Z. Ma, E. J. Nassar, and R. Rodríguez
Copyright © 2013 M. S. Salleh et al. This is an open access article distributed under the Creative Commons Attribution License, which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited.
Citations to this Article [7 citations]
The following is the list of published articles that have cited the current article.
- M. N. Mohammed, M. Z. Omar, J. Syarif, Z. Sajuri, M. S. Salleh, and K. S. Alhawari, “Microstructural Evolution during DPRM Process of Semisolid Ledeburitic D2 Tool Steel,” The Scientific World Journal, vol. 2013, pp. 1–7, 2013.
- M.S. Salleh, M.Z. Omar, J. Syarif, K.S. Alhawari, and M.N. Mohammed, “Microstructure and Mechanical Properties of Thixoformed A319 Aluminium Alloy,” Materials & Design, 2014.
- Manish Kumar, Sudip K. Samanta, Pradip Dutta, and Debashis Ghosh, “Semisolid Processing of A380 Al Alloy Using Cooling Slope,” Materials and Manufacturing Processes, vol. 29, no. 4, pp. 422–428, 2014.
- M.S. Salleh, M.Z. Omar, and J. Syarif, “The Effects of Mg Addition on the Microstructure and Mechanical Properties of Thixoformed Al-5%Si-Cu alloys,” Journal of Alloys and Compounds, 2014.
- Melika Özer, Neşet Akar, Kadir Kocatepe, and Mehmet Erdoğan, “Effects of the thixocasting injection velocity on tensile properties of an A357 Al alloy,” Materials Testing, vol. 57, no. 9, pp. 790–794, 2015.
- Amit Regmi, Hiroki Shintaku, Tsutomu Sasaki, and Seiichi Koshizuka, “Flow simulation and solidification phenomena of AC4CH aluminum alloy in semi-solid forging process by explicit MPS method,” Computational Particle Mechanics, 2015.
- Prosenjit Das, Sudip K. Samanta, and Pradip Dutta, “Rheological Behavior of Al-7Si-0.3Mg Alloy at Mushy State,” Metallurgical and Materials Transactions B, 2015.