Research Letters in Signal Processing
Volume 2008 (2008), Article ID 970461, 4 pages
doi:10.1155/2008/970461
Research Letter

NLOS Mitigation for TOA Location Based on a Modified Deterministic Model

Hong Tang,1,2 Yongwan Park,2 and Tianshuang Qiu1

1School of Electronic and Information Engineering, Dalian University of Technology, Dalian 116024, China
2Mobile Communication Laboratory, Yeungnam University, Kyongsan-city, Kyongbuk 712-749, South Korea

Received 13 February 2008; Accepted 15 April 2008

Academic Editor: A. G. Constantinides

Copyright © 2008 Hong Tang et al. This is an open access article distributed under the Creative Commons Attribution License, which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited.

Abstract

Wireless location becomes difficult due to contamination of measured time-of-arrival (TOA) caused by non-line-of-sight. In this letter, TOA measurements seen at base stations are adjusted by scale factors, and a modified deterministic model is built. An effective numerical solution is proposed to resolve the scale factors and mobile position. A simulation comparison of four algorithms indicates that the proposed algorithm outperforms the other three algorithms.

1. Introduction

For outdoor wireless location, most time-of-arrival- (TOA-) based algorithms are derived from deterministic model. The mobile position is commonly modeled as the intersection of a set of circles defined by TOA ranges. Non-line-of-sight (NLOS) propagation is one of the major concerns. The field trials in [1] performed by Nokia showed that the positive range error due to NLOS is up to a thousand meters in some channel environments. NLOS is a key problem to improve location accuracy.

In recent years, very important contributions to the TOA-based location have been made to compute the mobile position using TOA measurements. And the least-square (LS) criterion is often used to compute the estimate of mobile position, which is optimal if the residual follows Gaussian distribution. For example, the “time of arrival data fusion" based on LS criterion in [2] is a closed-form solution for mobile position. A constrained nonlinear LS approach was proposed in [3] to minimize the residual. In [4], the quadric programming technique is used to find the ML estimation of the mobile position subjected to constraint from the inequalities introduced due to NLOS propagation. In the range scaling algorithm (RSA) in [5], the NLOS is mitigated using TOA adjustment by scaling NLOS-corrupted TOA measurements using factors that are estimated from a constrained nonlinear optimization process. But RSA is only valid for three base stations (BSs) scenario, and the optimization process is very complex.

In this letter, scale factors are employed to adjust TOA measurements seen at base stations, and a modified deterministic model is proposed. An effective solution is used to resolve the mobile position, which does not require prior knowledge of NLOS distribution or time-based history measurements.

2. Deterministic Model for TOA-Based Location

It is assumed that BSs are involved in the location process. The TOA-based range measurements are modeled as (1) where is the pseudorange between the BS and mobile station (MS), is the LOS distance, and is the excess distance due to NLOS. is the sum of other errors caused by system delay, synchronization error, measurement noise, and so forth. Let the mobile position be and let the position of the BS be . Define as the residual, where denotes the norm operator, and represents the distance between vectors and . A generalized estimator normally used for TOA in determinate models is(2) where is the index set of BSs. is an optimal function of the residual. The determinate model in [3] was chosen as where is the weight reflecting the reliability of the signal received at BS , and in [6] was selected as a robust function with more tolerance for outliers. To locate mobile position in presence of NLOS propagation, an alternative way is to shift view to in a modified deterministic model.

3. A Modified Deterministic Model and Numerical Solution

The fact that NLOS propagation causes positive range error means that the following inequality holds: (3) In order to change (3) into equality, let be the scale factor on the range measurements, which yields (4) Each must be less than or equal to one. Furthermore, each has a lower bound. For example, three BSs are involved in the location process, as seen in Figure 1. The mobile must lie in the overlapped region formed by and . Let be the lower bound of . We find that . In a similar way, we get and . Thus, must be constrained by (5)

970461.fig.001
Figure 1: The geometry of three circles shows the constraints on the scale factors.

Define as the modified residual in this letter. This residual will be zero or sufficient small if the scale factors are selected accurately. Thus, the modified deterministic model is defined as (6) Subject to (7) Let the objective function which is minimized for TOA location be (8)

Clearly, (8) will be exactly zero with the true scale factors and true position. The sequential quadratic programming (SQP) technique is employed to study the performance surface of the objective function. We find that it has many local minimums in the overlapped region, and these minimums skirt the true mobile position.

Because of the difficulty in determining a closed-form solution for (8), we propose a numerical solution to resolve the scale factors and mobile position by the following steps.

(1) Compute the lower bound for . (2) Generate a random variable over with a predefined distribution. The predefined distribution of is different in different channel environments. Typically, the channel environments can be classified as open area, mountains, suburban, urban, and bad urban. (3) Let the scale factors equal for and compute the mobile position as follows.Equation (8) is quadratic about and . Calculate the derivatives with respect to and , and let the derivatives be zero. The estimate of the mobile position is (9) An interesting result from (9) is that the mobile position estimate is the linear combinations of the positions of all BSs. The tap weight of each linear combination is . However, we must note that (9) is not the closed-form solution because and are still functions of and . Following the similar steepest descendent technique as illustrated in [3], the estimate of mobile position is (10) where and are the step sizes, and is the iteration number. (4) Substitute the scale factors and mobile position estimate into (8), and calculate the exact value of . (5) Repeat steps, (2)–(4) times. We get a set of the scale factors , a set of mobile position and a set of exact value of objective function . (6) Find the minimum in , where is the index. Then, in is the final estimate for mobile position, and in are the final estimates for scale factors.

The random variable controls the step size of the scale factors while we search them in solution space. Without any prior knowledge, we apply the same on each scale factor in step (3) to limit the solution space. In step (6), both the scale factors and the mobile position that minimizes the objective function are taken as the final estimates. This scheme to select scale factors is reasonable because it follows the physical meaning of the modified deterministic model. Clearly, the final estimates cannot make the objective function exactly zero. But, they can guarantee it to be a relatively small number. A notable advantage of the numerical process is that compared to the complex nonlinear optimization processes as illustrated in RSA [5], the complexity to search the scale factors is reduced. In addition, the proposed algorithm can be applied to the scenarios of more than three BSs; however, RSA is difficult to be applied in these scenarios.

4. Simulations

The simulations are conducted in a cellular network composed of hexagonal cells with radius of 1000 meters. The mobile station is assumed uniformly distributed in the central cell. And the mobile position is computed based on TOA measurements from the six nearest BSs. In scenario 1, the excess range due to NLOS propagation is modeled as positive random variables over meters, generated according to CDSM [5, 7]. To study the performance in a high NLOS environment, the “reverse” CDSM is used. Without knowledge of the channel environment, the variable in the proposed algorithm is uniformly generated over , and the number of attempts is 10, that is, . The range error is caused by system delay, synchronization error, measurement noise and is typically smaller in magnitude than NLOS error. As an example, is modeled as a Gaussian variable with mean 100 meters and variance 30 meters. The performances are compared with the LS algorithm, that is, “time of arrival data fusion" algorithm in [2], the algorithm in [3], and the Huber-estimator mentioned in [6]. The root mean square errors of the four algorithms with the two NLOS models are shown in Figure 2.

970461.fig.002
Figure 2: The root mean square errors with CDSM and reverse CDSM.

In scenario 2, another model considered is a range-dependent NLOS model [8]. The NLOS error is proportional to the BS-MS range, that is, the NLOS error for the th BS is taken to be , where is a proportionality constant. The root mean square errors with the proportional NLOS model are shown in Figure 3. It is found that the performance of the other three algorithms degrade greatly with increasing and the proposed algorithm is robust with .

970461.fig.003
Figure 3: The root mean square errors with range-dependent model.

5. Conclusions

A modified deterministic model with a new residual is built to compute the mobile position. Due to the difficulty to find a closed-form solution, an effective numerical solution is proposed to resolve the scale factors and the mobile position. A simulation comparison among four algorithms is conducted to evaluate their performance. The results indicate that the proposed algorithm can deal with NLOS effectively and is simple to be implemented.

Acknowledgments

The authors are very grateful to the anonymous reviewers for their useful comments. The authors wish to thank the Regional Innovation Center (RIC) of Yeungnam University partially funding this research.

References

  1. M. I. Silventoinen and T. Rantalainen, “Mobile station emergency locating in GSM,” in Proceedings of the IEEE International Conference on Personal Wireless Communications (ICPWC '96), p. 232, New Delhi, India, February 1996.
  2. A. H. Sayed, A. Tarighat, and N. Khajehnouri, “Network-based wireless location: challenges faced in developing techniques for accurate wireless location information,” IEEE Signal Processing Magazine, vol. 22, no. 4, 24 pages, 2005.
  3. J. Caffery, Jr. and G. L. Stuber, “Subscriber location in CDMA cellular networks,” IEEE Transactions on Vehicular Technology, vol. 47, no. 2, 406 pages, 1998.
  4. X. Wang, Z. Wang, and B. O'Dea, “A TOA-based location algorithm reducing the errors due to non-line-of-sight (NLOS) propagation,” IEEE Transactions on Vehicular Technology, vol. 52, no. 1, 112 pages, 2003.
  5. S. Venkatraman, J. Caffery, Jr., and H.-R. You, “A novel ToA location algorithm using LoS range estimation for NLoS environments,” IEEE Transactions on Vehicular Technology, vol. 53, no. 5, 1515 pages, 2004.
  6. G.-L. Sun and W. Guo, “Bootstrapping M-estimators for reducing errors due to non-line-of-sight (NLOS) propagation,” IEEE Communications Letters, vol. 8, no. 8, 509 pages, 2004.
  7. R. B. Ertel and J. H. Reed, “Angle and time of arrival statistics for circular and elliptical scattering models,” IEEE Journal on Selected Areas in Communications, vol. 17, no. 11, 1829 pages, 1999.
  8. S. Venkatraman, J. Caffery, Jr., and H.-R. You, “A novel ToA location algorithm using LoS range estimation for NLoS environments,” IEEE Transactions on Vehicular Technology, vol. 53, no. 5, 1515 pages, 2004.