Using Signal Envelope Detection for Online and  Offline RF MEMS Switch Testing

<table>
							Low-frequency output parameters: 
<i>t<sub>on</sub></i> is the 
total delay time of a rising edge; <i>t<sub>off</sub></i> 
is the total delay time of a falling edge; <i>A<sub>on</sub></i> 
is the envelope amplitude in the “on” state; and <i>A<sub>off</sub></i> is 
the envelope amplitude in the “off” state.
						</table>

VLSI Design

fig9

Figure 9

Figure 9: Using Signal Envelope Detection for Online and  Offline RF MEMS Switch Testing 