Table of Contents Author Guidelines Submit a Manuscript
Advances in Civil Engineering
Volume 2009 (2009), Article ID 859217, 18 pages
http://dx.doi.org/10.1155/2009/859217
Research Article

Influence of Excitation on Dynamic System Identification for a Multi-Span Reinforced Concrete Bridge

Department of Civil and Geological Engineering, University of Saskatchewan, 57 Campus Drive, Saskatoon, SK, Canada S7N 5A9

Received 2 March 2009; Revised 11 August 2009; Accepted 28 August 2009

Academic Editor: Amr Elnashai

Copyright © 2009 M. Alwash et al. This is an open access article distributed under the Creative Commons Attribution License, which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited.

Linked References

  1. S. W. Doebling, C. R. Farrar, M. B. Prime, and D. W. Shevitz, “Damage identification and health monitoring of structural and mechanical systems from changes in their vibration characteristics: a literature review,” Tech. Rep. LA 13070-MS, Los Alamos National Laboratory, Los Alamos, NM, USA, 1996. View at Google Scholar
  2. S. W. Doebling, C. R. Farrar, and M. B. Prime, “A summary review of vibration-based damage identification methods,” Shock and Vibration Digest, vol. 30, no. 2, pp. 91–105, 1998. View at Google Scholar · View at Scopus
  3. H. Sohn, C. R. Farrar, F. M. Hemez, D. D. Shunk, D. W. Stinemates, and B. R. Nadler, “A review of structural health monitoring literature: 1996—2001,” Tech. Rep. LA-13976-MS, Los Alamos National Laboratory, Los Alamos, NM, USA, 2003. View at Google Scholar
  4. P. Cawley and R. D. Adams, “The location of defects in structures from measurements of natural frequencies,” Journal of Strain Analysis, vol. 14, no. 2, pp. 49–57, 1979. View at Google Scholar · View at Scopus
  5. O. S. Salawu, “Detection of structural damage through changes in frequency: a review,” Engineering Structures, vol. 19, no. 9, pp. 718–723, 1997. View at Google Scholar · View at Scopus
  6. B. Peeters, System identification and damage detection in civil engineering, Ph.D. thesis, Department of Civil Engineering, Katholieke Universiteit Leuven, Leuven, Belgium, 2000.
  7. C. H. J. Fox, “The location of defects in structures: a comparison of the use of natural frequency and mode shape data,” in Proceedings of the 10th International Modal Analysis Conference, pp. 522–528, Society of Experimental Mechanics, Bethel, Conn, USA, 1992.
  8. O. S. Salawu and C. Williams, “Damage location using vibration mode shapes,” in Proceedings of the 12th International Modal Analysis Conference, pp. 933–939, Society of Experimental Mechanics, Bethel, Conn, USA, 1994.
  9. A. K. Pandey, M. Biswas, and M. M. Samman, “Damage detection from changes in curvature mode shapes,” Journal of Sound and Vibration, vol. 145, no. 2, pp. 321–332, 1991. View at Google Scholar · View at Scopus
  10. Z. Zhang and A. E. Aktan, “The damage indices for constructed facilities,” in Proceedings of the 13th International Modal Analysis Conference, pp. 1520–1529, Society of Experimental Mechanics, Bethel, Conn, USA, 1995.
  11. A. K. Pandey and M. Biswas, “Damage detection in structures using changes in flexibility,” Journal of Sound and Vibration, vol. 169, no. 1, pp. 3–17, 1994. View at Publisher · View at Google Scholar · View at Scopus
  12. D. C. Zimmerman and M. Kaouk, “Structural damage detection using a minimum rank update theory,” Journal of Vibration and Acoustics, vol. 116, no. 2, pp. 222–231, 1994. View at Google Scholar · View at Scopus
  13. J.-T. Kim and N. Stubbs, “Model-uncertainty impact and damage-detection accuracy in plate girder,” Journal of Structural Engineering, vol. 121, no. 10, pp. 1409–1417, 1995. View at Publisher · View at Google Scholar · View at Scopus
  14. J.-T. Kim and N. Stubbs, “Nondestructive crack detection algorithm for full-scale bridges,” Journal of Structural Engineering, vol. 129, no. 10, pp. 1358–1366, 2003. View at Publisher · View at Google Scholar · View at Scopus
  15. P. Hajela and F. J. Soeiro, “Recent developments in damage detection based on system identification methods,” Structural Optimization, vol. 2, no. 1, pp. 1–10, 1990. View at Publisher · View at Google Scholar · View at Scopus
  16. J. R. Casas and A. C. Aparicio, “Structural damage identification from dynamic-test data,” Journal of Structural Engineering, vol. 120, no. 8, pp. 2437–2450, 1994. View at Google Scholar · View at Scopus
  17. D. J. Ewins, Modal Testing: Theory, Practice and Application, Research Studies Press, Hertfordshire, UK, 2nd edition, 2000.
  18. C. R. Farrar, P. J. Cornwell, S. W. Doebling, and M. B. Prime, “Structural health monitoring studies of the Alamosa Canyon and I-40 Bridges,” Tech. Rep. LA-13635-MS, Los Alamos National Laboratory, Los Alamos, NM, USA, 2000. View at Google Scholar
  19. B. Peeters, J. Maeck, and G. De Roeck, “Vibration-based damage detection in civil engineering: excitation sources and temperature effects,” Smart Materials and Structures, vol. 10, no. 3, pp. 518–527, 2001. View at Publisher · View at Google Scholar · View at Scopus
  20. M. F. Green and D. Cebon, “Dynamic response of highway bridges to heavy vehicle loads: theory and experimental validation,” Journal of Sound and Vibration, vol. 170, no. 1, pp. 51–78, 1994. View at Publisher · View at Google Scholar · View at Scopus
  21. C. E. Ventura, A. J. Felber, and S. F. Stiemer, “Determination of the dynamic characteristics of the Colquitz River Bridge by full-scale testing,” Canadian Journal of Civil Engineering, vol. 23, no. 2, pp. 536–548, 1996. View at Google Scholar · View at Scopus
  22. W. Krebs and R. Cantieni, “Analysis of dynamic wheel load signals in the frequency domain,” International Journal of Vehicle Design, vol. 6, no. 1, pp. 287–309, 1999. View at Google Scholar · View at Scopus
  23. B. Peeters and G. De Roeck, “Stochastic system identification for operational modal analysis: a review,” Journal of Dynamic Systems, Measurement and Control, vol. 123, no. 4, pp. 659–667, 2001. View at Google Scholar · View at Scopus
  24. K. P. Jackson, Reliability-based load management of the Red Deer River Bridge, M.S. thesis, University of Saskatchewan, 2007.
  25. J. R. Billing, “Dynamic loading and testing of bridges in Ontario,” Canadian Journal of Civil Engineering, vol. 11, no. 4, pp. 833–843, 1984. View at Google Scholar · View at Scopus
  26. B. Bakht and S. G. Pinjarkar, “Review of dynamic testing of highway bridges,” Structural Research Report SRR-89-01, Ministry of Transportation of Ontario, Downsview, Canada, 1989. View at Google Scholar
  27. J. L. Humar and A. M. Kashif, “Dynamic response of bridges under travelling loads,” Canadian Journal of Civil Engineering, vol. 20, pp. 287–298, 1993. View at Google Scholar
  28. P. Paultre, O. Chaallal, and J. Proulx, “Bridge dynamics and dynamic amplification factors—a review of analytical and experimental findings,” Canadian Journal of Civil Engineering, vol. 19, pp. 260–278, 1992. View at Google Scholar
  29. P. Paultre, J. Proulx, and M. Talbot, “Dynamic testing procedures for highway bridges using traffic loads,” Journal of Structural Engineering, vol. 121, no. 2, pp. 362–376, 1995. View at Google Scholar · View at Scopus
  30. A. V. Pesterev, L. A. Bergman, and C. A. Tan, “A novel approach to the calculation of pothole-induced contact forces in MDOF vehicle models,” Journal of Sound and Vibration, vol. 275, no. 1-2, pp. 127–149, 2004. View at Publisher · View at Google Scholar · View at Scopus
  31. T.-C. Pan and J. Li, “Dynamic vehicle element method for transient response of coupled vehicle-structure systems,” Journal of Structural Engineering, vol. 128, no. 2, pp. 214–223, 2002. View at Publisher · View at Google Scholar · View at Scopus
  32. T.-L. Wang, D. Huang, M. Shahawy, and K. Huang, “Dynamic response of highway girder bridges,” Computers and Structures, vol. 60, no. 6, pp. 1021–1027, 1996. View at Publisher · View at Google Scholar · View at Scopus
  33. R. J. Jiang, F. T. K. Au, and Y. K. Cheung, “Identification of vehicles moving on continuous bridges with rough surface,” Journal of Sound and Vibration, vol. 274, no. 3–5, pp. 1045–1063, 2004. View at Publisher · View at Google Scholar · View at Scopus
  34. Y. Chen, M. Q. Feng, and C.-A. Tan, “Modeling of traffic excitation for system identification of bridge structures,” Computer-Aided Civil and Infrastructure Engineering, vol. 21, no. 1, pp. 57–66, 2006. View at Publisher · View at Google Scholar · View at Scopus
  35. A. Pavic, R. Pimentel, and P. Waldron, “Instrumented sledge hammer impact excitation: worked examples,” in Proceedings of IMAC-XVI, pp. 929–935, Kissimmee, Fla, USA, 1997.
  36. M. W. Trethewey and J. A. Cafeo, “Tutorial: signal processing aspects of structural impact testing,” The International Journal of Analytical and Experimental Modal Analysis, vol. 7, no. 2, pp. 129–149, 1992. View at Google Scholar · View at Scopus
  37. ISO, “ISO Standard 7626-5: Vibration and Shock—Experimental Determination of Mechanical Mobility—Part 5: Measurements using impact excitation with an exciter which is not attached to the structure,” International Organization for Standardization, Geneva, Switzerland, 1994.
  38. C. R. Farrar, T. A. Duffey, P. J. Cornwell, and S. W. Doebling, “Excitation methods for bridge structures,” in Proceedings of the 17th International Modal Analysis Conference (IMAC '99), pp. 1063–1068, Kissimmee, Fla, USA, 1999.
  39. Z. Zhang, “Error study of bridge tests for the purpose of structure identification,” in Proceedings of the 12th International Modal Analysis Conference (IMAC '94), pp. 433–441, Honolulu, Hawaii,USA, 1994.
  40. J. M. W. Brownjohn, P. Moyo, P. Omenzetter, and Y. Lu, “Assessment of highway bridge upgrading by dynamic testing and finite-element model updating,” Journal of Bridge Engineering, vol. 8, no. 3, pp. 162–172, 2003. View at Publisher · View at Google Scholar · View at Scopus
  41. Earth Tech, “Strengthening project of Red Deer River Bridge on Provincial Highway,” Tech. Rep. 9, Saskatchewan Highways and Transportation, Earth Tech, Saskatoon, Canada, 2001. View at Google Scholar
  42. L. Hermans and H. van der Auweraer, “Modal testing and analysis of structures under operational conditions: industrial applications,” Mechanical Systems and Signal Processing, vol. 13, no. 2, pp. 193–216, 1999. View at Publisher · View at Google Scholar · View at Scopus
  43. S. D. Stearns and R. A. David, Signal Processing Algorithms in MATLAB, Prentice-Hall, Upper Saddle River, NJ, USA, 1996.
  44. C. Y. Shih, Y. G. Tsuei, R. J. Allemang, and D. L. Brown, “Complex mode indication function and its applications to spatial domain parameter estimation,” Mechanical Systems and Signal Processing, vol. 2, no. 4, pp. 367–377, 1988. View at Google Scholar · View at Scopus
  45. A. B. Siddique, B. F. Sparling, and L. D. Wegner, “Assessment of vibration-based damage detection for an integral abutment bridge,” Canadian Journal of Civil Engineering, vol. 34, no. 3, pp. 438–452, 2007. View at Publisher · View at Google Scholar · View at Scopus
  46. ANSYS, ANSYS Release 9.0., ANSYS, Canonsburg, Pa, USA, 2005.
  47. R. W. Clough and J. Penzien, Dynamics of Structures, McGraw-Hill, New York, NY, USA, 2nd edition, 1975.
  48. A. K. Chopra, Dynamics of Structures: Theory and Applications to Earthquake Engineering, Prentice-Hall, Upper Saddle River, NJ, USA, 1995.
  49. B. Van den Branden, B. Peeters, and G. De Roeck, “Introduction to MACEC 2, modal analysis on civil engineering constructions,” Department of Civil Engineering, Katholieke Universiteit, Leuven, Belgium, 1999.
  50. T. H. T. Chan and C. O'Conner, “Vehicle model for highway bridge impact,” Journal of Structural Engineering, vol. 116, pp. 1772–1791, 1990. View at Google Scholar