Table of Contents Author Guidelines Submit a Manuscript
Research Article
Advances in Materials Science and Engineering
Volume 2019, Article ID 5817594, 1 page
https://doi.org/10.1155/2019/5817594
Corrigendum

Corrigendum to “Representative Stress-Strain Curve by Spherical Indentation on Elastic-Plastic Materials”

1School of Applied Science, Taiyuan University of Science and Technology, Taiyuan 030024, China
2Departamento de Tecnología Química y Ambiental, Tecnología Química y Energética y Tecnología Mecánica, Escuela Superior de Ciencias Experimentales y Tecnología, Universidad Rey Juan Carlos, c/Tulipán s/n Móstoles, Madrid, Spain
3Departamento de Ciencia de Materiales, UPM, E.T.S.I. Caminos, Canales y Puertos, c/ Professor Aranguren s/n, 28040 Madrid, Spain
4School of Mechanical, Electronic and Control Engineering, Beijing Jiaotong University, Beijing 100044, China

Correspondence should be addressed to Chao Chang; moc.361@tsuyt_gnahc_oahc

Received 26 February 2019; Accepted 3 March 2019; Published 3 April 2019

Copyright © 2019 Chao Chang et al. This is an open access article distributed under the Creative Commons Attribution License, which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited.


In the article titled “Representative Stress-Strain Curve by Spherical Indentation on Elastic-Plastic Materials” [1], there was an error in equation (9), which should be corrected as follows:

There was an error in equation (10), which should be corrected as follows:

References

  1. C. Chang, M. A. Garrido, J. Ruiz-Hervias, Z. Zhang, and L.-L. Zhang, “Representative stress-strain curve by spherical indentation on elastic-plastic materials,” Advances in Materials Science and Engineering, vol. 2018, Article ID 8316384, 9 pages, 2018. View at Publisher · View at Google Scholar · View at Scopus