Research Article
Studying and Optimizing the Effect of Process Parameters on Machining Vibration in Turning Process of AISI 1040 Steel
Table 2
Design of the experiments and results of vibration and chip frequency.
| | Std order | Run order | Cutting speed (mm/s) | Depth of cut (mm) | Feed rate (ft/rot) | Vibration (Volt) | Chip frequency (Hz) |
| | 1 | 1 | 50 | 2 | 0.22 | 0.091 | 2099.8 | | 12 | 2 | 50 | 1.5 | 0.16 | 0.0702 | 1005.3 | | 3 | 3 | 200 | 1.5 | 0.16 | 0.157 | 6980.2 | | 8 | 4 | 125 | 1.5 | 0.8 | 0.10631 | 7291.1 | | 6 | 5 | 125 | 0.79 | 0.16 | 0.07371 | 9002.4 | | 11 | 6 | 125 | 2.21 | 0.16 | 0.1212 | 1144.06 | | 13 | 7 | 125 | 1.5 | 0.16 | 0.10253 | 5545.4 | | 7 | 8 | 125 | 1.5 | 0.16 | 0.10223 | 5466.1 | | 10 | 9 | 125 | 1.5 | 0.16 | 0.10235 | 5720.8 | | 15 | 10 | 125 | 1.5 | 0.16 | 0.10217 | 5512.3 | | 14 | 11 | 200 | 1 | 0.22 | 0.1308 | 6781.3 | | 4 | 12 | 200 | 2 | 0.1 | 0.1606 | 2215.18 | | 5 | 13 | 50 | 1 | 0.1 | 0.06 | 2022.3 | | 9 | 14 | 125 | 1.5 | 0.24 | 0.11875 | 1484.18 | | 2 | 15 | 125 | 1.5 | 0.16 | 0.10212 | 4925.4 |
|
|
