Table of Contents Author Guidelines Submit a Manuscript
Advances in Tribology
Volume 2017, Article ID 1035017, 9 pages
https://doi.org/10.1155/2017/1035017
Research Article

Extruded and Injection Moulded Virgin PA 6/6 as Abrasion Resistant Material

1Soete Laboratory, Department of Mechanical Construction and Production, Ghent University, Technologiepark 903, 9052 Zwijnaarde, Belgium
2Institute for Mechanical Engineering Technology, Faculty of Mechanical Engineering, Szent István University, Gödöllo 2100, Hungary
3Laboratory of Tribology, Universidade Federal do Rio Grande do Sul, Porto Alegre, RS, Brazil

Correspondence should be addressed to J. Sukumaran; moc.liamtoh@1bocaj_re

Received 9 February 2017; Accepted 27 April 2017; Published 24 May 2017

Academic Editor: Sandhyarani Biswas

Copyright © 2017 J. Sukumaran et al. This is an open access article distributed under the Creative Commons Attribution License, which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited.

How to Cite this Article

J. Sukumaran, R. Keresztes, G. Kalácska, H. Almaliki, P. D. Neis, and P. De Baets, “Extruded and Injection Moulded Virgin PA 6/6 as Abrasion Resistant Material,” Advances in Tribology, vol. 2017, Article ID 1035017, 9 pages, 2017. https://doi.org/10.1155/2017/1035017.