Table of Contents Author Guidelines Submit a Manuscript
Computational Intelligence and Neuroscience
Volume 2014 (2014), Article ID 236072, 7 pages
http://dx.doi.org/10.1155/2014/236072
Research Article

Estimation of Critical Gap Based on Raff’s Definition

1National ITS Center, Research Institute of Highway, Beijing 100088, China
2School of Traffic and Transportation, Dalian Jiaotong University, Dalian 116028, China

Received 26 July 2014; Accepted 5 October 2014; Published 9 November 2014

Academic Editor: Xiaobei Jiang

Copyright © 2014 Rui-jun Guo et al. This is an open access article distributed under the Creative Commons Attribution License, which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited.

Linked References

  1. R. T. Luttinen, “Capacity and level of service at Finnish unsignalized intersections,” Finnra Reports, Finnish Road Administration, Helsinki, Finland, 2004. View at Google Scholar
  2. A. W. Plank and E. A. Catchpole, “A general capacity formula for an uncontrolled intersection,” Traffic Engineering and Control, vol. 25, no. 6, pp. 327–329, 1984. View at Google Scholar
  3. A. Polus, S. S. Lazar, and M. Livneh, “Critical gap as a function of waiting time in determining roundabout capacity,” Journal of Transportation Engineering, vol. 129, no. 5, pp. 504–509, 2003. View at Publisher · View at Google Scholar · View at Scopus
  4. M. M. Hamed, S. M. Easa, and R. R. Batayneh, “Disaggregate gap-acceptance model for unsignalized T-intersections,” Journal of Transportation Engineering, vol. 123, no. 1, pp. 36–42, 1997. View at Publisher · View at Google Scholar · View at Scopus
  5. R. Ashworth, “A note on the selection of gap acceptance criteria for traffic simulation studies,” Transportation Research, vol. 2, no. 2, pp. 171–175, 1968. View at Publisher · View at Google Scholar · View at Scopus
  6. R. Ashworth, “The analysis and interpretation of gap acceptance data,” Transportation Science, vol. 4, no. 3, pp. 270–280, 1970. View at Publisher · View at Google Scholar · View at Scopus
  7. A. J. Miller, “A note on the analysis of gap—acceptance in traffic,” Journal of the Royal Statistical Society, vol. 23, no. 1, pp. 66–73, 1974. View at Publisher · View at Google Scholar · View at Scopus
  8. M. S. Raff and J. W. Hart, A Volume Warrant for Urban Stop Signs, Eno Foundation for Highway Traffic Control, Saugatuck, Conn, USA, 1950.
  9. W. Brilon, R. Koenig, and R. J. Troutbeck, “Useful estimation procedures for critical gaps,” Transportation Research Part A: Policy and Practice, vol. 33, no. 3-4, pp. 161–186, 1999. View at Publisher · View at Google Scholar · View at Scopus
  10. R. H. Hewitt, “Measuring critical gap,” Transportation Science, vol. 17, no. 1, pp. 87–109, 1983. View at Publisher · View at Google Scholar · View at Scopus
  11. Z. Tian, M. Vandehey, B. W. Robinson et al., “Implementing the maximum likelihood methodology to measure a driver's critical gap,” Transportation Research Part A: Policy and Practice, vol. 33, no. 3-4, pp. 187–197, 1999. View at Publisher · View at Google Scholar · View at Scopus
  12. Transportation Research Board, Highway Capacity Manual, National Research Council, Washington, DC, USA, 2000.
  13. N. Wu, “A universal procedure for capacity determination at unsignalized (priority-controlled) intersections,” Transportation Research Part B: Methodological, vol. 35, no. 6, pp. 593–623, 2001. View at Publisher · View at Google Scholar · View at Scopus
  14. R. Akcelik, The Simulation of Priority Intersection System and the Formulation of Vehicular Delay, Istanbul Technical University, Istanbul, Turkey, 1987, (Turkish).
  15. R. Akcelik, “A roundabout case study comparing capacity estimates from alternative analytical models,” in Proceedings of the 2nd Urban Street Symposium, Anaheim, Calif, USA, 2003.
  16. P. Lertworawanich and L. Elefteriadou, “Generalized capacity estimation model for weaving areas,” Journal of Transportation Engineering, vol. 133, no. 3, pp. 166–179, 2007. View at Publisher · View at Google Scholar · View at Scopus
  17. S. Tanyel, A capacity calculation method for roundabouts in Turkey [Ph.D. thesis], Istanbul Technical University, Istanbul, Turkey, 2001, (Turkish).
  18. S. Tanyel and N. Yayla, “A discussion on the parameters of Cowan M3 distribution for Turkey,” Transportation Research Part A: Policy and Practice, vol. 37, no. 2, pp. 129–143, 2003. View at Publisher · View at Google Scholar · View at Scopus
  19. R. S. Drew, Traffic Flow Theory and Control, McGraw-Hill, New York, NY, USA, 1968.
  20. R. C. Cowan, “Useful headway models,” Transportation Research, vol. 9, no. 6, pp. 371–375, 1975. View at Publisher · View at Google Scholar · View at Scopus
  21. R. J. Guo and B. L. Lin, “Gap acceptance at priority-controlled intersections,” Journal of Transportation Engineering, vol. 137, no. 4, pp. 269–276, 2011. View at Publisher · View at Google Scholar · View at Scopus