Table of Contents
Conference Papers in Science
Volume 2015 (2015), Article ID 873543, 9 pages
http://dx.doi.org/10.1155/2015/873543
Conference Paper

Investigation of the Wear Resistance Properties of Cr/CrN Multilayer Coatings against Sand Erosion

Chair of Materials and Physical Metallurgy, Brandenburg Technical University, Konrad Wachsmann Allee 17, 03046 Cottbus, Germany

Received 1 August 2014; Accepted 30 September 2014

Academic Editor: Martin Dienwiebel

This Conference Paper is based on a presentation given by Muhammad Naveed at “European Symposium on Friction, Wear, and Wear Protection” held from 6 May 2014 to 8 May 2014 in Karlsruhe, Germany.

Copyright © 2015 Muhammad Naveed et al. This is an open access article distributed under the Creative Commons Attribution License, which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited.

Linked References

  1. R. C. Sirs, “The operation of gas turbine engines in hot & sandy conditions-royal air force experiences in the gulf war,” Tech. Rep. AGARD-CP-558, Paper no. 2, 1994. View at Google Scholar
  2. A. Hamed, W. Tabakoff, and R. Wenglarz, “Erosion and deposition in turbomachinery,” Journal of Propulsion and Power, vol. 22, no. 2, pp. 350–360, 2006. View at Publisher · View at Google Scholar · View at Scopus
  3. J. P. van der Walt and A. Nurick, “Erosion of dust-filtered helicopter turbine engines part I: basic theoretical considerations,” Journal of Aircraft, vol. 32, no. 1, pp. 106–111, 1995. View at Publisher · View at Google Scholar · View at Scopus
  4. L. Swadźba, B. Formanek, H. M. Gabriel, P. Liberski, and P. Podolski, “Erosion- and corrosion-resistant coatings for aircraft compressor blades,” Surface and Coatings Technology, vol. 62, no. 1–3, pp. 486–492, 1993. View at Publisher · View at Google Scholar · View at Scopus
  5. A. Feuerstein and A. Kleyman, “Ti-N multilayer systems for compressor airfoil sand erosion protection,” Surface and Coatings Technology, vol. 204, no. 6-7, pp. 1092–1096, 2009. View at Publisher · View at Google Scholar · View at Scopus
  6. S. Hassani, J. E. Klemberg-Sapieha, M. Bielawski, W. Beres, L. Martinu, and M. Balazinski, “Design of hard coating architecture for the optimization of erosion resistance,” Wear, vol. 265, no. 5-6, pp. 879–887, 2008. View at Publisher · View at Google Scholar · View at Scopus
  7. Q. Yang, D. Y. Seo, L. R. Zhao, and X. T. Zeng, “Erosion resistance performance of magnetron sputtering deposited TiAlN coatings,” Surface and Coatings Technology, vol. 188-189, no. 1–3, pp. 168–173, 2004. View at Publisher · View at Google Scholar · View at Scopus
  8. J. M. Castanho and M. T. Vieira, “Effect of ductile layers in mechanical behaviour of TiAlN thin coatings,” Journal of Materials Processing Technology, vol. 143-144, no. 1, pp. 352–357, 2003. View at Publisher · View at Google Scholar · View at Scopus
  9. T. Grögler, E. Zeiler, A. Franz, O. Plewa, S. M. Rosiwal, and R. F. Singer, “Erosion resistance of CVD diamond-coated titanium alloy for aerospace applications,” Surface and Coatings Technology, vol. 112, no. 1–3, pp. 129–132, 1999. View at Publisher · View at Google Scholar · View at Scopus
  10. A. Leyland and A. Matthews, “Thick Ti/TiN multilayered coatings for abrasive and erosive wear resistance,” Surface and Coatings Technology, vol. 70, no. 1, pp. 19–25, 1994. View at Publisher · View at Google Scholar · View at Scopus
  11. B. Borawski, J. Singh, J. A. Todd, and D. E. Wolfe, “Multi-layer coating design architecture for optimum particulate erosion resistance,” Wear, vol. 271, no. 11-12, pp. 2782–2792, 2011. View at Publisher · View at Google Scholar · View at Scopus
  12. Y. Gachon, P. Ienny, A. Forner, G. Farges, M. C. Sainte Catherine, and A. B. Vannes, “Erosion by solid particles of W/W-N multilayer coatings obtained by PVD process,” Surface and Coatings Technology, vol. 113, no. 1-2, pp. 140–148, 1999. View at Publisher · View at Google Scholar · View at Scopus
  13. N. Panich, P. Wangyao, S. Hannongbua, P. Sricharoenchai, and Y. Sun, “Tribological study of nano-multilayered ultra-hard coatings based on TiB2,” Reviews on Advanced Materials Science, vol. 13, no. 2, pp. 117–124, 2006. View at Google Scholar · View at Scopus
  14. E. Quesnel, Y. Pauleau, P. Monge-Cadet, and M. Brum, “Tungsten and tungsten-carbon PVD multilayered structures as erosion-resistant coatings,” Surface and Coatings Technology, vol. 62, no. 1-3, pp. 474–479, 1993. View at Publisher · View at Google Scholar · View at Scopus
  15. L. Major, J. Morgiel, B. Major et al., “Crystallographic aspects related to advanced tribological multilayers of Cr/CrN and Ti/TiN types produced by pulsed laser deposition (PLD),” Surface and Coatings Technology, vol. 200, no. 22-23, pp. 6190–6195, 2006. View at Publisher · View at Google Scholar · View at Scopus
  16. A. Lousa, J. Romero, E. Martínez, J. Esteve, F. Montalà, and L. Carreras, “Multilayered chromium/chromium nitride coatings for use in pressure die-casting,” Surface and Coatings Technology, vol. 146-147, pp. 268–273, 2001. View at Publisher · View at Google Scholar · View at Scopus
  17. E. Martinez, J. Romero, A. Lousa, and J. Esteve, “Wear behavior of nanometric CrN/Cr multilayers,” Surface and Coatings Technology, vol. 163-164, pp. 571–577, 2003. View at Publisher · View at Google Scholar · View at Scopus
  18. J. Deng, F. Wu, Y. Lian, Y. Xing, and S. Li, “Erosion wear of CrN, TiN, CrAlN, and TiAlN PVD nitride coatings,” International Journal of Refractory Metals and Hard Materials, vol. 35, pp. 10–16, 2012. View at Publisher · View at Google Scholar · View at Scopus
  19. C. A. Johnson, J. A. Ruud, R. Bruce, and D. Wortman, “Relationships between residual stress, microstructure and mechanical properties of electron beam-physical vapor deposition thermal barrier coatings,” Surface and Coatings Technology, vol. 108-109, no. 1–3, pp. 80–85, 1998. View at Publisher · View at Google Scholar · View at Scopus
  20. P. Wieciński, J. Smolik, H. Garbacz, and K. J. Kurzydłowski, “Failure and deformation mechanisms during indentation in nanostructured Cr/CrN multilayer coatings,” Surface and Coatings Technology, vol. 240, pp. 23–31, 2014. View at Publisher · View at Google Scholar · View at Scopus
  21. J. A. Alegría-Ortega, L. M. Ocampo-Carmona, F. A. Suárez-Bustamante, and J. J. Olaya-Flórez, “Erosion-corrosion wear of Cr/CrN multi-layer coating deposited on AISI-304 stainless steel using the unbalanced magnetron (UBM) sputtering system,” Wear, vol. 290-291, pp. 149–153, 2012. View at Publisher · View at Google Scholar · View at Scopus
  22. C. Maurer and U. Schulz, “Solid particle erosion of thick PVD coatings on CFRP,” Wear, vol. 317, no. 1-2, pp. 246–253, 2014. View at Publisher · View at Google Scholar
  23. I. M. Hutchings, “Some comments on the theoritical treatment of erosive particle impacts,” in Proceedings of the 5th International Conference on Erosion by Solid and Liquid, Cambridge University, Cambridge, UK, 1979.
  24. I. Finnie, “Erosion by a stream of solid particles,” Wear, vol. 2, pp. 111–122, 1967. View at Google Scholar
  25. C. Maurer and U. Schulz, “Erosion resistant titanium based PVD coatings on CFRP,” Wear, vol. 302, no. 1-2, pp. 937–945, 2013. View at Publisher · View at Google Scholar · View at Scopus
  26. O. Schroeter, “Herstellung und Chrakterisierung von PVD-Schichten auf Basis der Cr2AlC-MAX-Phase,” in Metallkunde und Werkstofftechnik, Brandenburgische Technische Universität, 2011. View at Google Scholar
  27. P. Wieciński, J. Smolik, H. Garbacz, and K. J. Kurzydłowski, “Erosion resistance of the nanostructured Cr/CrN multilayer coatings on Ti6Al4V alloy,” Vacuum, vol. 107, pp. 277–283, 2014. View at Publisher · View at Google Scholar · View at Scopus
  28. R. Bayón, A. Igartua, X. Fernández et al., “Corrosion-wear behaviour of PVD Cr/CrN multilayer coatings for gear applications,” Tribology International, vol. 42, no. 4, pp. 591–599, 2009. View at Publisher · View at Google Scholar · View at Scopus
  29. L. Zhang, H. Yang, X. Pang, K. Gao, and A. A. Volinsky, “Microstructure, residual stress, and fracture of sputtered TiN films,” Surface and Coatings Technology, vol. 224, pp. 120–125, 2013. View at Publisher · View at Google Scholar · View at Scopus
  30. S. Hassani, M. Bielawski, W. Beres, L. Martinu, M. Balazinski, and J. E. Klemberg-Sapieha, “Predictive tools for the design of erosion resistant coatings,” Surface and Coatings Technology, vol. 203, no. 3-4, pp. 204–210, 2008. View at Publisher · View at Google Scholar · View at Scopus
  31. C. L. Martin, O. O. Ajayi, S. Torrel, N. Demas, A. Erdemir, and R. Wei, “Effect of coating thickness on tribological performance of CrN in dry sliding contact,” in Proceedings of the ASME/STLE International Joint Tribology Conference, pp. 75–77, Denver, Colo, USA, October 2012. View at Publisher · View at Google Scholar · View at Scopus
  32. M. Kot, W. A. Rakowski, Ł. Major, R. Major, and J. Morgiel, “Effect of bilayer period on properties of Cr/CrN multilayer coatings produced by laser ablation,” Surface and Coatings Technology, vol. 202, no. 15, pp. 3501–3506, 2008. View at Publisher · View at Google Scholar · View at Scopus
  33. J. Romero, A. Lousa, E. Martínez, and J. Esteve, “Nanometric chromium/chromium carbide multilayers for tribological applications,” Surface and Coatings Technology, vol. 163-164, pp. 392–397, 2003. View at Publisher · View at Google Scholar
  34. D. M. Marulanda, J. J. Olaya, U. Piratoba, A. Mariño, and E. Camps, “The effect of bilayer period and degree of unbalancing on magnetron sputtered Cr/CrN nano-multilayer wear and corrosion,” Thin Solid Films, vol. 519, no. 6, pp. 1886–1893, 2011. View at Publisher · View at Google Scholar · View at Scopus
  35. Y. Zhou, R. Asaki, W.-H. Soe, R. Yamamoto, R. Chen, and A. Iwabuchi, “Hardness anomaly, plastic deformation work and fretting wear properties of polycrystalline TiN/CrN multilayers,” Wear, vol. 236, no. 1-2, pp. 159–164, 1999. View at Publisher · View at Google Scholar · View at Scopus
  36. M. Liu, M. Tan, G. Liu et al., “The effects of modulation period, modulation ratio, and deposition temperature on microstructure and mechanical properties of ZrB2/W multilayers,” Science China Technological Sciences, vol. 53, no. 9, pp. 2350–2354, 2010. View at Publisher · View at Google Scholar · View at Scopus