Table of Contents Author Guidelines Submit a Manuscript
Discrete Dynamics in Nature and Society
Volume 2016 (2016), Article ID 8352317, 9 pages
http://dx.doi.org/10.1155/2016/8352317
Research Article

The Coupling Effect Research of Ash Deposition and Condensation in Low Temperature Flue Gas

1School of Energy & Power Engineering, Shandong University, Jinan 250061, China
2Jinan Institute of Measurement and Testing, Jinan 250002, China
3College of Physics Science & Technology, Jinan University, Jinan 250022, China

Received 5 March 2016; Accepted 11 April 2016

Academic Editor: Jingchao Zhang

Copyright © 2016 Lei Ma et al. This is an open access article distributed under the Creative Commons Attribution License, which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited.

Linked References

  1. Y. Yang, C. Xu, G. Xu, Y. Han, Y. Fang, and D. Zhang, “A new conceptual cold-end design of boilers for coal-fired power plants with waste heat recovery,” Energy Conversion and Management, vol. 89, pp. 137–146, 2015. View at Publisher · View at Google Scholar · View at Scopus
  2. C.-F. You and X. C. Xu, “Coal combustion and its pollution control in China,” Energy, vol. 35, no. 11, pp. 4467–4472, 2010. View at Publisher · View at Google Scholar · View at Scopus
  3. F. Vélez, F. Chejne, G. Antolin, and A. Quijano, “Theoretical analysis of a transcritical power cycle for power generation from waste energy at low temperature heat source,” Energy Conversion and Management, vol. 60, pp. 188–195, 2012. View at Publisher · View at Google Scholar · View at Scopus
  4. V.-D. Stevanovic, T. Wala, S. Muszynski, M. Milic, and M. Jovanovic, “Efficiency and power upgrade by an additional high pressure economizer installation at an aged 620 MWe lignite-fired power plant,” Energy, vol. 66, no. 1, pp. 907–918, 2014. View at Publisher · View at Google Scholar · View at Scopus
  5. Y. Suzukawa, S. Sugiyama, Y. Hino, M. Ishioka, and I. Mori, “Heat transfer improvement and NOx reduction by highly preheated air combustion,” Energy Conversion and Management, vol. 38, no. 10–13, pp. 1061–1071, 1997. View at Publisher · View at Google Scholar · View at Scopus
  6. N. S. Harding and D. C. O'Connor, “Ash deposition impacts in the power industry,” Fuel Processing Technology, vol. 88, no. 11-12, pp. 1082–1093, 2007. View at Publisher · View at Google Scholar · View at Scopus
  7. A. Herz, M. R. Malayeri, and H. Müller-Steinhagen, “Fouling of roughened stainless steel surfaces during convective heat transfer to aqueous solutions,” Energy Conversion and Management, vol. 49, no. 11, pp. 3381–3386, 2008. View at Publisher · View at Google Scholar · View at Scopus
  8. Y.-T. Shi, M. Gao, G.-H. Tang, F.-Z. Sun, and W.-Q. Tao, “Experimental research of CFB ash deposition on helical finned tubes,” Applied Thermal Engineering, vol. 37, pp. 420–429, 2012. View at Publisher · View at Google Scholar · View at Scopus
  9. M. Shimogori, T. Mine, N. Ohyatsu, N. Takarayama, and Y. Matsumura, “Effects of fine ash particles and alkali metals on ash deposition characteristics at the initial stage of ash deposition determined in 1.5 MWth pilot plant tests,” Fuel, vol. 97, pp. 233–240, 2012. View at Publisher · View at Google Scholar · View at Scopus
  10. Y.-J. Kim and S.-S. Kim, “Experimental study of particle deposition onto a circular cylinder in high-temperature particle-laden flows,” Experimental Thermal and Fluid Science, vol. 5, no. 1, pp. 116–123, 1992. View at Publisher · View at Google Scholar · View at Scopus
  11. J. Barroso, J. Ballester, L. M. Ferrer, and S. Jiménez, “Study of coal ash deposition in an entrained flow reactor: influence of coal type, blend composition and operating conditions,” Fuel Processing Technology, vol. 87, no. 8, pp. 737–752, 2006. View at Publisher · View at Google Scholar · View at Scopus
  12. H.-B. Vuthaluru and D.-H. French, “Investigations into the air heater ash deposit formation in large scale pulverised coal fired boiler,” Fuel, vol. 140, pp. 27–33, 2015. View at Publisher · View at Google Scholar · View at Scopus
  13. L. Yan, R. P. Gupta, and T. F. Wall, “The implication of mineral coalescence behaviour on ash formation and ash deposition during pulverised coal combustion,” Fuel, vol. 80, no. 9, pp. 1333–1340, 2001. View at Publisher · View at Google Scholar · View at Scopus
  14. F. Li, F. Sun, and Y. Shi, “Hot-state experiment on double-pipe heat exchanger under coupled effect of fouling and acid,” CIESC Journal, vol. 65, no. 8, pp. 2876–2881, 2014. View at Publisher · View at Google Scholar · View at Scopus
  15. A. Nuntaphan and T. Kiatsiriroat, “Thermal behavior of spiral fin-and-tube heat exchanger having fly ash deposit,” Experimental Thermal and Fluid Science, vol. 31, no. 8, pp. 1103–1109, 2007. View at Publisher · View at Google Scholar · View at Scopus
  16. Y.-G. Wang, Q.-X. Zhao, Z.-X. Zhang, Z.-C. Zhang, and W.-Q. Tao, “Mechanism research on coupling effect between dew point corrosion and ash deposition,” Applied Thermal Engineering, vol. 54, no. 1, pp. 102–110, 2013. View at Publisher · View at Google Scholar · View at Scopus
  17. Y.-L. He, H. Han, S.-Z. Tang, and T. Zhou, “Sulfuric acid deposition characteristics of H-type finned tube bank with 10 rows,” International Journal of Heat and Mass Transfer, vol. 81, pp. 137–141, 2015. View at Publisher · View at Google Scholar · View at Scopus
  18. A. Bahadori, “Estimation of combustion flue gas acid dew point during heat recovery and efficiency gain,” Applied Thermal Engineering, vol. 31, no. 8-9, pp. 1457–1462, 2011. View at Publisher · View at Google Scholar · View at Scopus