Table of Contents Author Guidelines Submit a Manuscript
International Journal of Analytical Chemistry
Volume 2017, Article ID 4975714, 5 pages
https://doi.org/10.1155/2017/4975714
Research Article

Preparation and Anticorrosion of Octadecyl Trichlorosilane SAMs for Copper Surface

1Institute of Fine Chemicals, Heze University, Heze, Shandong 274015, China
2Department of Chemistry and Chemical Engineering, Heze University, Heze, Shandong 274015, China

Correspondence should be addressed to Xue Shouqing; moc.361@gniquohseux

Received 25 April 2017; Revised 2 August 2017; Accepted 20 August 2017; Published 14 December 2017

Academic Editor: Adil Denizli

Copyright © 2017 Xue Shouqing and Liu Xiaohui. This is an open access article distributed under the Creative Commons Attribution License, which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited.

Abstract

The self-assembled monolayer (SAM) was prepared using octadecyl trichlorosilane (OTS) in distilled solution on the copper surface. The effect of inhibitor concentration on the rate of inhibition efficiency and corrosion rate in corrosion medium on copper by using polarization curves, electrochemical impedance spectroscopy (EIS), scanning electron microscope (SEM) was studied. The results showed that OTS SAMs exhibit the better corrosion resistance; the corrosion potential of copper OTS SAMs protection increased by about 1.02 V, while the corrosion current density decreased to 0.59 A/cm2. The corrosion rate is minimized and flattened and can reach 9.2% while the inhibition efficiency reached 95.4%, when the corrosion inhibitor has concentration of 40 ppm.