Table of Contents Author Guidelines Submit a Manuscript
International Journal of Aerospace Engineering
Volume 2019, Article ID 5167575, 16 pages
https://doi.org/10.1155/2019/5167575
Research Article

A Research Study for the Design of a Portable and Configurable Ground Test System for the A400M Aircraft

Escuela Politécnica Superior, Departamento de Tecnología Electrónica, Universidad de Sevilla, C/Virgen de África 7, 41011 Seville, Spain

Correspondence should be addressed to Iñigo Monedero; se.su@oredenomi

Received 16 January 2019; Revised 28 August 2019; Accepted 17 September 2019; Published 11 November 2019

Academic Editor: Paolo Castaldi

Copyright © 2019 Diego F. Larios et al. This is an open access article distributed under the Creative Commons Attribution License, which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited.

Linked References

  1. S. Sahoo, L. Priyadarshini, and G. Shekhar, “Flight test instrumentation system for a typical prototype civil aircraft,” International Journal of Control Theory and Applications, vol. 8, no. 3, pp. 977–983, 2015. View at Google Scholar
  2. W. T. Dickinson, “Flight-testing equipment for large aircraft,” SAE Technical Papers, vol. 51, pp. 139–147, 1943. View at Publisher · View at Google Scholar · View at Scopus
  3. A. Doig, “Test equipment for rapid automatic check-out and Evaluation,” Aircraft Engineering and Aerospace Technology, vol. 40, no. 4, pp. 32–37, 1968. View at Publisher · View at Google Scholar · View at Scopus
  4. S. Kelly, “The use of IEEE standards to develop test program sets to support in-service legacy equipment,” in 2015 IEEE AUTOTESTCON, pp. 256–260, National Harbor, MD, USA, November 2015. View at Publisher · View at Google Scholar · View at Scopus
  5. R. Luckner, L. Dalldorff, and R. Reichel, “A utility aircraft for remote sensing missions with a high-precision automatic flight control system,” in 2014 IEEE International Conference on Aerospace Electronics and Remote Sensing Technology, pp. 1–11, Yogyakarta, Indonesia, November 2014. View at Publisher · View at Google Scholar · View at Scopus
  6. M. Nowakowski, “Measuring and recording systems used in flight tests of aircraft,” Solid State Phenomena, vol. 180, pp. 222–231, 2012. View at Publisher · View at Google Scholar · View at Scopus
  7. L. Michaels, S. Pagerit, A. Rousseau et al., “Model-based systems engineering and control system development via virtual hardware-in-the-loop simulation,” in SAE 2010-01-2325, SAE Convergence Conference, Detroit, MI, USA, October 2010. View at Publisher · View at Google Scholar · View at Scopus
  8. R. Ramya, K. Selvi, and K. Murali, “Real-time simulation and performance analysis of multimachine power systems using dSPACE simulator,” SIMULATION, vol. 92, no. 1, pp. 63–75, 2016. View at Publisher · View at Google Scholar · View at Scopus
  9. O. Sercekman and A. T. Kutay, “A model based approach for sensor fault detection in civil aircraft control surface,” in 2018 IEEE/ION Position, Location and Navigation Symposium (PLANS), pp. 715–729, Monterey, CA, USA, April 2018. View at Publisher · View at Google Scholar · View at Scopus
  10. G. Pagliuca, T. Kipouros, and M. A. Savill, “Surrogate modelling for wing planform multidisciplinary optimisation using model-based engineering,” International Journal of Aerospace Engineering, vol. 2019, Article ID 4327481, 15 pages, 2019. View at Publisher · View at Google Scholar
  11. V. Bayer, S. Kunath, R. Niemeier, and J. Horwege, “Signal-based metamodels for predictive reliability analysis and virtual testing,” Advances in Science, Technology and Engineering Systems Journal, vol. 3, no. 1, pp. 342–347, 2018. View at Publisher · View at Google Scholar · View at Scopus
  12. K. H. Ibrahim, G. M. El-Bayoumi, and A. H. Kassem, “PIL simulation of integrated autopilot and path following algorithms for MAVs using Arduino target,” in AIAA Guidance, Navigation, and Control Conference, Grapevine, TX, USA, January 2017. View at Publisher · View at Google Scholar
  13. B. Yuksek, E. Saldiran, A. Cetin, R. Yeniceri, and G. Inalhan, “A model based flight control system design approach for micro aerial vehicle using integrated flight testing and HIL simulation,” in AIAA Scitech 2019 Forum, San Diego, CA, USA, January 2019. View at Publisher · View at Google Scholar
  14. R. McNeal and M. Belkhayat, “Standard tools for hardware-in-the-loop (HIL) modeling and simulation,” in 2007 IEEE Electric Ship Technologies Symposium, Arlington, VA, USA, May 2007. View at Publisher · View at Google Scholar · View at Scopus
  15. “IEEE 1014-1987 - IEEE standard for a versatile backplane bus: VMEbus,” August 2019, https://standards.ieee.org/standard/1014-1987.html.
  16. “PXI Systems Alliance,” August 2019, http://www.pxisa.org/.
  17. I. O. Loskutov, P. V. Nekrasov, I. I. Shvetsov-Shilovskiy, D. V. Boychenko, and V. M. Uzhegov, “SEFI cross-section evaluation by fault injection software approach and hardware detection,” in 2017 IEEE 30th International Conference on Microelectronics (MIEL), Nis, Serbia, October 2017. View at Publisher · View at Google Scholar · View at Scopus
  18. K. Moore and D. Owen, “The BRIC - a new generation of PXI switch products [ATE system applications],” in Proceedings AUTOTESTCON 2003. IEEE Systems Readiness Technology Conference, Anaheim, CA, USA, September 2003. View at Publisher · View at Google Scholar
  19. C. Chen, “Small aircraft CAN bus signal acquisition equipment,” in 2010 International Conference on Computer, Mechatronics, Control and Electronic Engineering, Changchun, China, August 2010. View at Publisher · View at Google Scholar · View at Scopus
  20. P. M. Lister, “The impact of COTS on a ground support system procurement,” in 17th DASC. AIAA/IEEE/SAE. Digital Avionics Systems Conference. Proceedings (Cat. No.98CH36267), pp. D27/1–D27/7, Bellevue, WA, USA, October-November 1998. View at Publisher · View at Google Scholar
  21. J. S. Monson, M. Wirthlin, and B. Hutchings, “A fault injection analysis of Linux operating on an FPGA-embedded platform,” International Journal of Reconfigurable Computing, vol. 2012, Article ID 850487, 11 pages, 2012. View at Publisher · View at Google Scholar · View at Scopus
  22. G. Afonso, R. B. Atitallah, N. Belanger, M. Rubio, and J.-L. Dekeyser, “An efficient design methodology for hybrid avionic test systems,” in 2010 IEEE 15th Conference on Emerging Technologies & Factory Automation (ETFA 2010), Bilbao, Spain, September 2010. View at Publisher · View at Google Scholar · View at Scopus
  23. G. Afonso, R. B. Atitallah, N. Belanger, M. Rubio, S. Stilkerich, and J. L. Dekeyser, “Toward generic and adaptive avionic test systems,” in 2011 NASA/ESA Conference on Adaptive Hardware and Systems (AHS), pp. 287–294, San Diego, CA, USA, June 2011. View at Publisher · View at Google Scholar · View at Scopus
  24. T.-M. Shih and H.-C. Chang, “A DSP FPGA based hardware-in-the-loop testing platform,” in 2010 11th International Conference on Control Automation Robotics & Vision, pp. 1980–1985, Singapore, Singapore, December 2010. View at Publisher · View at Google Scholar · View at Scopus
  25. T. Slaughter and C. Stroud, “Fault injection emulation for field programmable analog arrays,” in Southwest Symposium on Mixed-Signal Design, 2003, Las Vegas, NV, USA, February 2003. View at Publisher · View at Google Scholar · View at Scopus
  26. G. W. Greenwood, D. Hunter, and E. Ramsden, “Fault recovery in linear systems via intrinsic evolution,” in Proceedings. 2004 NASA/DoD Conference on Evolvable Hardware, 2004, Seattle, WA, USA, June 2004. View at Publisher · View at Google Scholar · View at Scopus