Table of Contents Author Guidelines Submit a Manuscript
International Journal of Antennas and Propagation
Volume 2013 (2013), Article ID 704847, 6 pages
Research Article

Multiband Printed Asymmetric Dipole Antenna for LTE/WLAN Applications

1Department of Electronic Engineering, Jinwen University of Science and Technology, 23154 No. 99, An-Chung Road, Hsin-Tien, New Taipei City, Taiwan
2Wieson Corp. Tech., 221 No. 276, Section 1, Datong Road, Sijihih, New Taipei City, Taiwan
3Department of Electronic Engineering, National Taiwan University of Science and Technology, 10608 No. 43, Section 4, Keelung Road, Da’an, Taipei, Taiwan

Received 16 September 2013; Accepted 7 December 2013

Academic Editor: Xiao Ping Chen

Copyright © 2013 Chia-Mei Peng et al. This is an open access article distributed under the Creative Commons Attribution License, which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited.


The ability of a single layer strip fed printed asymmetric dipole antenna, which is composed of top-loading, asymmetric coplanar waveguide (ACPW) and stepped-feeding structure, to operate at three wide frequency bands (698~960 MHz, 1710~2620 MHz, and 5150~5850 MHz) to cover WLAN and LTE operation has been demonstrated. A prototype of the proposed antenna with 57.5 mm in length, 0.4 mm in thickness, and 5 mm in width is fabricated and experimentally investigated. The experimental results indicate that the VSWR 2.5 : 1 bandwidths achieved were 74.3%, 40.8%, and 18.2% at 700 MHz, 2450 MHz, and 5500 MHz, respectively. Experimental results are shown to verify the validity of theoretical work.