Table of Contents Author Guidelines Submit a Manuscript
Retracted

This article has been retracted at the request of the authors. The paper was found to include incorrect figures and data, affecting the validity of the conclusions.

View the original article here.

References

  1. Y. Geng, R. Ma, B. Chen, and W. Zhang, “A design of double broadband MIMO antenna,” International Journal of Antennas and Propagation, vol. 2015, Article ID 952137, 6 pages, 2015.
International Journal of Antennas and Propagation
Volume 2015 (2015), Article ID 952137, 6 pages
http://dx.doi.org/10.1155/2015/952137
Research Article

A Design of Double Broadband MIMO Antenna

College of Physics and Electronics, Shanxi University, Taiyuan 030006, China

Received 22 September 2015; Revised 22 October 2015; Accepted 16 November 2015

Academic Editor: Jaume Anguera

Copyright © 2015 Yanfeng Geng et al. This is an open access article distributed under the Creative Commons Attribution License, which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited.

Abstract

The MIMO antenna applied to LTE mobile system should be miniaturization and can work in the current communication frequency band; isolation between each antenna unit also should be good so as to reduce loss of radio wave energy and improve the antenna performance of the MIMO system. This paper puts forward the design scheme of a broadband MIMO double antenna. And the design of antenna unit and debugging and related technical measures, such as bending antenna bracket, are both presented; the integration design of high isolation of ultra broadband MIMO antenna is realized on the plate with the volume of 100 × 52 × 0.8 mm3; antenna working bands are 698 MHz~960 MHz and 1710 MHz~2700 MHz; in the whole spectrum, the 10 dB of port isolation can be basically achieved; in low frequency band, the isolation degree of antenna port can reach 12 dB.