Table of Contents
International Journal of Manufacturing Engineering
Volume 2016, Article ID 4680380, 9 pages
http://dx.doi.org/10.1155/2016/4680380
Research Article

Analyzing the Effect of Machining Parameters Setting to the Surface Roughness during End Milling of CFRP-Aluminium Composite Laminates

1Department of Mechanical and Manufacturing Engineering, Universiti Putra Malaysia, 43400 Serdang, Selangor, Malaysia
2Department of Aerospace Engineering, Universiti Putra Malaysia, 43400 Serdang, Selangor, Malaysia

Received 19 September 2015; Revised 18 January 2016; Accepted 8 February 2016

Academic Editor: Thomas R. Kurfess

Copyright © 2016 M. Nurhaniza et al. This is an open access article distributed under the Creative Commons Attribution License, which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited.

Citations to this Article [3 citations]

The following is the list of published articles that have cited the current article.

  • S. Madhu, and M. Balasubramanian, “Influence of Nozzle Design and Process Parameters on Surface Roughness of CFRP Machined by Abrasive Jet,” Materials and Manufacturing Processes, 2016. View at Publisher · View at Google Scholar
  • Ali Riza Motorcu, and Tuncay Bilge, “Laminant Kompozitin Cep Frezelenmesinde Yüzey Pürüzlülüğü Ve Boyutsal Tamlığın Değerlendirilmesi,” Düzce Üniversitesi Bilim ve Teknoloji Dergisi, vol. 6, no. 1, pp. 79–100, 2018. View at Publisher · View at Google Scholar
  • M H M Ghazali, A Z A Mazlan, L M Wei, C T Tying, T S Sze, and N I M Jamil, “Effect of Machining Parameters on the Surface Roughness for Different Type of Materials,” IOP Conference Series: Materials Science and Engineering, vol. 530, pp. 012008, 2019. View at Publisher · View at Google Scholar