Table of Contents
International Journal of Manufacturing Engineering
Volume 2016 (2016), Article ID 7213148, 9 pages
http://dx.doi.org/10.1155/2016/7213148
Research Article

Impacts of Wear and Geometry Response of the Cutting Tool on Machinability of Super Austenitic Stainless Steel

School of Engineering, Deakin University, 75 Pigdons Rd, Waurn Ponds, VIC 3216, Australia

Received 8 July 2016; Revised 12 September 2016; Accepted 27 September 2016

Academic Editor: Rene Romero-Troncoso

Copyright © 2016 Mohanad Alabdullah et al. This is an open access article distributed under the Creative Commons Attribution License, which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited.

How to Cite this Article

Mohanad Alabdullah, Ashwin Polishetty, and Guy Littlefair, “Impacts of Wear and Geometry Response of the Cutting Tool on Machinability of Super Austenitic Stainless Steel,” International Journal of Manufacturing Engineering, vol. 2016, Article ID 7213148, 9 pages, 2016. doi:10.1155/2016/7213148