Numerical Simulation Analysis of Unfilled and Filled Reinforced Polypropylene on Thin-Walled Parts Formed Using the Injection-Moulding Process

<table class="table-group" id="tab1"><tr><td><table class="table"><tr><td class="thead-hr" colspan="3"><hr/></td></tr><tr class="thead"><td align="left">Parameters</td><td align="center">Units</td><td align="center">Value</td></tr><tr><td class="thead-hr" colspan="3"><hr/></td></tr><tr><td align="left">Maximum machine injection stroke</td><td align="center">mm</td><td align="center">176.8</td></tr><tr><td align="left">Maximum machine injection rate</td><td align="center">cm<sup>3</sup>/s</td><td align="center">112.1</td></tr><tr><td align="left">Machine screw diameter</td><td align="center">mm</td><td align="center">30</td></tr><tr><td align="left">Maximum machine injection pressure</td><td align="center">MPa</td><td align="center">247</td></tr><tr><td align="left">Maximum machine clamp force</td><td align="center">MPa</td><td align="center">79.80</td></tr><tr class="table-tr"><td colspan="3"><hr class="tbody-hr"/></td></tr></table></td></tr></table>

Specifications of injection-moulding machine.

International Journal of Polymer Science

tab1

Table 1

Table 1: Numerical Simulation Analysis of Unfilled and Filled Reinforced Polypropylene on Thin-Walled Parts Formed Using the Injection-Moulding Process 

Table 1 | Numerical Simulation Analysis of Unfilled and Filled Reinforced Polypropylene on Thin-Walled Parts Formed Using the Injection-Moulding Process 