Table of Contents
ISRN Metallurgy
Volume 2012, Article ID 195654, 8 pages
http://dx.doi.org/10.5402/2012/195654
Research Article

Densification Behaviour in the Fabrication of Al-Fe Metal Matrix Composite Using Powder Metallurgy Route

1Department of Materials Science and Metallurgical Engineering, University Institute of Engineering & Technology, CSJM University, Kanpur 208024, India
2Department of Metallurgical and Materials Engineering, Indian Institute of Technology Kharagpur, Kharagpur 721302, India

Received 19 September 2012; Accepted 8 October 2012

Academic Editors: Y. S. Chang and S. C. Wang

Copyright © 2012 Siddhartha Tiwari et al. This is an open access article distributed under the Creative Commons Attribution License, which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited.

Citations to this Article [2 citations]

The following is the list of published articles that have cited the current article.

  • G H Majzoobi, K Rahmani, and A Atrian, “Temperature effect on mechanical and tribological characterization of Mg–SiC nanocomposite fabricated by high rate compaction,” Materials Research Express, vol. 5, no. 1, pp. 015046, 2018. View at Publisher · View at Google Scholar
  • Rodrigo S. Bonatti, Yuri A. Meyer, Ausdinir D. Bortolozo, Diego Costa, and Wislei R. Osório, “Morphology and size effects on densification and mechanical behavior of sintered powders from Al-Si and Al-Cu casting alloys,” Journal of Alloys and Compounds, 2019. View at Publisher · View at Google Scholar