Table of Contents
Journal of Aerodynamics
Volume 2014, Article ID 574520, 5 pages
http://dx.doi.org/10.1155/2014/574520
Research Article

Calibration Technique for Recovery of Short Duration Aerodynamic Force

Department of Mechanical Engineering, Indian Institute of Technology Guwahati, Guwahati 781039, India

Received 3 October 2013; Revised 18 January 2014; Accepted 19 January 2014; Published 4 March 2014

Academic Editor: Noor A. Ahmed

Copyright © 2014 Niranjan Sahoo and P. Ramesh Babu. This is an open access article distributed under the Creative Commons Attribution License, which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited.

Linked References

  1. R. Kumme and M. J. Dixon, “The results of comparisons between two different dynamic force measurement systems,” Measurement, vol. 10, no. 3, pp. 140–144, 1992. View at Google Scholar · View at Scopus
  2. Y. Fujii, “Toward dynamic force calibration,” Measurement, vol. 42, no. 7, pp. 1039–1044, 2009. View at Publisher · View at Google Scholar · View at Scopus
  3. R. Kumme, “Investigation of the comparison method for the dynamic calibration of force transducers,” Measurement, vol. 23, no. 4, pp. 239–245, 1998. View at Google Scholar · View at Scopus
  4. L. Bernstein, “Force measurement in short-duration hypersonic facilities,” AGARDograph 214, 1975. View at Google Scholar
  5. T. Bruns, R. Kumme, M. Kobusch, and M. Peters, “From oscillation to impact: the design of a new force calibration device at PTB,” Measurement, vol. 32, no. 1, pp. 85–92, 2002. View at Publisher · View at Google Scholar · View at Scopus
  6. N. Sahoo, D. R. Mahapatra, G. Jagadeesh, S. Gopalakrishnan, and K. P. J. Reddy, “An accelerometer balance system for measurement of aerodynamic force coefficients over blunt bodies in a hypersonic shock tunnel,” Measurement Science and Technology, vol. 14, no. 3, pp. 260–272, 2003. View at Publisher · View at Google Scholar · View at Scopus
  7. N. Sahoo, K. Suryavamshi, K. P. J. Reddy, and D. J. Mee, “Dynamic force balances for short-duration hypersonic testing facilities,” Experiments in Fluids, vol. 38, no. 5, pp. 606–614, 2005. View at Publisher · View at Google Scholar · View at Scopus
  8. N. Sahoo, D. R. Mahapatra, G. Jagadeesh, S. Gopalakrishnan, and K. P. J. Reddy, “Design and analysis of a flat accelerometer-based force balance system for shock tunnel testing,” Measurement, vol. 40, no. 1, pp. 93–106, 2007. View at Publisher · View at Google Scholar · View at Scopus
  9. D. J. Mee, “Dynamic calibration of force balances for impulse hypersonic facilities,” Shock Waves, vol. 12, no. 6, pp. 443–455, 2003. View at Publisher · View at Google Scholar · View at Scopus
  10. A. L. Smith and D. J. Mee, “Dynamic strain measurement using piezoelectric polymer film,” Journal of Strain Analysis for Engineering Design, vol. 31, no. 6, pp. 463–465, 1996. View at Google Scholar · View at Scopus
  11. R. P. Reed, “Convolution and deconvolution in measurement and control: part 7—system transient response characterization for convolution and deconvolution,” Measurements and Control, vol. 189, pp. 69–83, 1998. View at Google Scholar
  12. Y. Fujii and H. Fujimoto, “Proposal for an impulse response evaluation method for force transducers,” Measurement Science and Technology, vol. 10, no. 4, pp. N31–N33, 1999. View at Publisher · View at Google Scholar · View at Scopus
  13. S. R. Sanderson and J. M. Simmons, “Drag balance for hypervelocity impulse facilities,” AIAA journal, vol. 29, no. 12, pp. 2185–2191, 1991. View at Google Scholar · View at Scopus
  14. S. L. Tuttle, D. J. Mee, and J. M. Simmons, “Drag measurements at Mach 5 using a stress wave force balance,” Experiments in Fluids, vol. 19, no. 5, pp. 336–341, 1995. View at Publisher · View at Google Scholar · View at Scopus
  15. C. Jessen and H. Grönig, “A new principle for a short-duration six component balance,” Experiments in Fluids, vol. 8, no. 3-4, pp. 231–233, 1989. View at Publisher · View at Google Scholar · View at Scopus