Table of Contents Author Guidelines Submit a Manuscript
Journal of Applied Mathematics
Volume 2013, Article ID 615608, 10 pages
http://dx.doi.org/10.1155/2013/615608
Research Article

Parameter Matching Analysis of Hydraulic Hybrid Excavators Based on Dynamic Programming Algorithm

1School of Mechatronics, Harbin Institute of Technology, Harbin 150080, China
2College of Automation, Harbin Engineering University, Harbin 150001, China
3Department of Engineering, Faculty of Engineering and Science, University of Agder, 4898 Grimstad, Norway

Received 26 July 2013; Revised 2 September 2013; Accepted 3 September 2013

Academic Editor: Baocang Ding

Copyright © 2013 Wei Shen et al. This is an open access article distributed under the Creative Commons Attribution License, which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited.

Linked References

  1. Q. Xiao and Q. Wang, “Parameter matching method for hybrid power system of hydraulic excavator,” China Journal of Highway and Transport, vol. 21, no. 1, pp. 121–126, 2008. View at Google Scholar · View at Scopus
  2. T. Li, D. Zhao, H. Kang, and Z. Zhang, “Parameter matching of parallel hybrid power loaders,” Journal of Jilin University, vol. 42, no. 4, pp. 916–921, 2012. View at Google Scholar
  3. H. Li, H. Liu, H. Gao, and P. Shi, “Reliable fuzzy control for active suspension systems with actuator delay and fault,” IEEE Transactions on Fuzzy Systems, vol. 20, no. 2, pp. 342–357, 2012. View at Publisher · View at Google Scholar · View at Scopus
  4. H. Li, J. Yu, C. Hilton, and H. Liu, “Adaptive sliding mode control for nonlinear active suspension systems using T-S fuzzy model,” IEEE Transactions on Industrial Electronics, vol. 60, no. 8, pp. 3328–3338, 2013. View at Google Scholar
  5. S. M. Aceves, J. R. Smith, L. J. Perkins et al., “Optimization of CNG series hybrid concept vehicle,” SAE Paper 960234, SAE, Warrendale, Pa, USA, 1996. View at Google Scholar
  6. B. Wu, C. C. Lin, Z. Filipi, H. Peng, and D. Assanis, “Optimal power management for a hydraulic hybrid delivery truck,” Vehicle System Dynamics, vol. 42, no. 1-2, pp. 23–40, 2004. View at Publisher · View at Google Scholar · View at Scopus
  7. A. brahma, Y. Guezennec, and G. Rizzoni, “Optimal energy management in series hybrid electric vehicles,” Proceedings of American Control Conference, vol. 1, no. 6, pp. 60–64, 2000. View at Google Scholar
  8. C. Lin, Z. Filipi, L. Louca, H. Peng, D. Assanis, and J. Stein, “Modelling and control of a medium-duty hybrid electric truck,” International Journal of Heavy Vehicle Systems, vol. 11, no. 3-4, pp. 349–370, 2004. View at Publisher · View at Google Scholar · View at Scopus
  9. B. Wu, C. Lin, Z. Filipi et al., “Optimization of power management strategies for a hydraulic hybrid medium truck,” in Proceedings of the 2002 Advanced Vehicle Control Conference, Hiroshima, Japan, 2002.
  10. Z. Filipi, L. Louca, B. Daran et al., “Combined optimisation of design and power management of the hydraulic hybrid propulsion system for the 6 × 6 medium truck,” International Journal of Heavy Vehicle Systems, vol. 11, no. 3-4, pp. 372–402, 2004. View at Publisher · View at Google Scholar · View at Scopus
  11. M. Cross and Z. Filipi, “Series hydraulic hybrid propulsion for a light truck optimizing the thermostatic power management,” in Proceedings of the 8th International Conference on Engines for Automobile, SAE Technical Paper 2007-24-0080, Capris, Italy, 2007.
  12. D. Feng, Study on power management strategies for a series hydraulic hybrid vehicle [Doctor thesis], University of Electronic Science and Technology of China, Chengdou, China, 2009.
  13. T. J. Kim, Optimal control: an effective method for designing hydraulic hybrid vehicles [M.S. thesis], Purdue University, West Lafayette, Ind, USA, 2011.
  14. W. Shen and J. Jiang, “Analysis and development of the hydraulic secondary regulation system based on the CPR,” in Proceedings of theInternational Conference on Fluid Power and Mechatronics (FPM '11), pp. 117–122, August 2011. View at Publisher · View at Google Scholar · View at Scopus
  15. P. A. J. Achten, F. Zhao, and G. E. M. Vael, “Transforming future hydraulics: a new design of a hydraulic transformer,” in Proceedings of the 5th Scandinavian International Conference on Fluid Power, Linköping, Sweden, May 1997.
  16. W. Shen and J. Jiang, “Analysis of energy recovery efficiency of hydraulic hybrid excavator,” Journal of South China University of Technology, vol. 40, no. 1, pp. 82–87, 2012. View at Publisher · View at Google Scholar · View at Scopus
  17. K. K. Ahn, T. H. Ho, and Q. T. Dinh, “A study on energy saving potential of hydraulic on energy saving potential of hydraulic control system using switching type closed loop constant pressure system,” in Proceedings of the 7th JFPS International Symposium on Fluid Power, pp. 317–322, 2008.
  18. W. Shen, J. Jiang, and H. R. Karimi, “Observer-based robust control for hydraulic velocity control system,” Mathematical Problems in Engineering, vol. 2013, Article ID 689132, 9 pages, 2013. View at Publisher · View at Google Scholar
  19. W. Shen and J. Jiang, “Study on control performance and energy recovery efficiency of hydraulic hybrid excavator,” ICIC Express Letters, vol. 5, no. 12, pp. 4439–4444, 2011. View at Google Scholar · View at Scopus
  20. J. Zimmerman and M. Ivantysynova, “The effect of system pressure level on the energy consumption of displacement controlled actuator systems,” in Proceedings of the 5th FPNI PhD Symposium, pp. 77–92, Krakow, Poland, 2008.
  21. J. Zimmerman, Toward optimal multi-actuator displacement controlled mobile hydraulic system [Ph.D. thesis], School of Mechanical Engineering, Purdue University, West Lafayette, Ind, USA, 2012.
  22. J. Zimmerman, R. Hippalgaonkar, and M. Ivantysynova, “Optimal control for the series-paralleld displacement controlled hydraulic hybrid excavator,” in Proceedings of the ASME 2011 Dynamic Systems and Control Conference, vol. October 2011, pp. 1–8.
  23. P. A. J. Achten, G. E. M. Vael, and F. Zhao, “The Innas hydraulic transformer—the key to the hydrostatic common pressure rail,” SAE Paper 2000-01-2561, SAE, Warrendale, Pa, USA.
  24. L. Chen and C. Gao, “Fast discrete bilinear interpolation algorithm,” Computer Engineering and Design, vol. 28, no. 15, pp. 3787–3790, 2007. View at Google Scholar