Table of Contents Author Guidelines Submit a Manuscript
Journal of Combustion
Volume 2016 (2016), Article ID 8205945, 7 pages
Research Article

Influence of Environmentally Friendly and High-Efficiency Composite Additives on Pulverized Coal Combustion in Cement Industry

1Hubei Key Laboratory of Coal Conversion and New Carbon Materials, Wuhan University of Science and Technology, Wuhan 430081, China
2State Key Laboratory of Coal Combustion, Huazhong University of Science and Technology, Wuhan 430074, China
3School of Resource and Environmental Engineering, Wuhan University of Science and Technology, Wuhan 430081, China

Received 17 January 2016; Revised 5 March 2016; Accepted 21 March 2016

Academic Editor: Dimitrios C. Rakopoulos

Copyright © 2016 Zhiyong Wang et al. This is an open access article distributed under the Creative Commons Attribution License, which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited.


4 kinds of chemical reagents and 3 kinds of industrial wastes were selected as burning additives for 2 kinds of coals in cement industry. The work focused on the replacement of partial chemical reagents by industrial wastes, which not only reduced the cost and took full advantage of industrial wastes, but also guaranteed the high combustion efficiency and removed the and SO2 simultaneously. The experiments were carried out in DTF. The combustion residues were analyzed by SEM and XRD. The results showed that the burnout rate was increased after adding the additives; meanwhile, the and SO2 release concentration were reduced, but the degree of action varied for different additives and coals. The substitute of chemical reagents by industrial wastes was very effective; overall, the cold-rolled iron oxide worked better than others; the particles surface was tougher and the peaks of crystalline phase were lower than raw coal, which indicated that the additives played good roles in combustion process.