Table of Contents Author Guidelines Submit a Manuscript
Journal of Nanomaterials
Volume 2015, Article ID 231672, 8 pages
http://dx.doi.org/10.1155/2015/231672
Research Article

Surge-Resistant Nanocomposite Enameled Wire Using Silica Nanoparticles with Binary Chemical Compositions on the Surface

1Department of Nano Science & Technology, Sejong Polymer Research Center, Sejong University, Seoul 05006, Republic of Korea
2Center for Thermometry, Division of Physical Metrology, Korea Research Institute of Standards and Science, Daejeon 34113, Republic of Korea

Received 12 August 2015; Revised 26 October 2015; Accepted 27 October 2015

Academic Editor: John Zhanhu Guo

Copyright © 2015 Jeseung Yoo et al. This is an open access article distributed under the Creative Commons Attribution License, which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited.

Linked References

  1. H. Kikuchi and H. Hanawa, “Inverter surge resistant enameled wire with nanocomposite insulating material,” IEEE Transactions on Dielectrics and Electrical Insulation, vol. 19, no. 1, pp. 99–106, 2012. View at Publisher · View at Google Scholar · View at Scopus
  2. A. T. Hoang, Y. V. Serdyuk, and S. M. Gubanski, “Electrical characterization of a new enamel insulation,” IEEE Transactions on Dielectrics and Electrical Insulation, vol. 21, no. 3, pp. 1291–1301, 2014. View at Publisher · View at Google Scholar · View at Scopus
  3. Y. Luo, G. Wu, J. Liu et al., “PD characteristics and microscopic analysis of polyimide film used as turn insulation in inverter-fed motor,” IEEE Transactions on Dielectrics and Electrical Insulation, vol. 21, no. 5, pp. 2237–2244, 2014. View at Publisher · View at Google Scholar · View at Scopus
  4. N. Hayakawa, F. Shimizu, and H. Okubo, “Estimation of partial discharge inception voltage of magnet wires under inverter surge voltage by volume-time theory,” IEEE Transactions on Dielectrics and Electrical Insulation, vol. 19, no. 2, pp. 550–557, 2012. View at Publisher · View at Google Scholar · View at Scopus
  5. H. Kikuchi, H. Hanawa, and Y. Honda, “Development of polyamide-imide/silica nanocomposite enameled wire,” Electronics and Communications in Japan, vol. 96, no. 6, pp. 41–48, 2013. View at Publisher · View at Google Scholar · View at Scopus
  6. T. Ozaki, T. Imai, F. Sawa, T. Shimizu, and F. Kanemitsu, “Partial discharge resistant enameled wire,” in Proceedings of the International Symposium on Electrical Insulating Materials, vol. 1, pp. 184–187, IEEE, Kitakyushu, Japan, June 2005. View at Scopus
  7. T. Tanaka, G. C. Montanari, and R. Mülhaupt, “Polymer nanocomposites as dielectrics and electrical insulation- perspectives for processing technologies, material characterization and future applications,” IEEE Transactions on Dielectrics and Electrical Insulation, vol. 11, no. 5, pp. 763–784, 2004. View at Publisher · View at Google Scholar · View at Scopus
  8. J. C. Fothergill, J. K. Nelson, and M. Fu, “Dielectric properties of epoxy nanocomposites containing TiO2, Al2O3 and ZnO fillers,” in Proceedings of the IEEE Electrical Insulation and Dielectric Phenomena, Annual Report Conference (CEIDP '04), pp. 406–409, usa, October 2004. View at Publisher · View at Google Scholar · View at Scopus
  9. M. Kozako, R. Kido, N. Fuse, Y. Ohki, T. Okamoto, and T. Tanaka, “Difference in surface degradation due to partial discharges between polyamide nanocomposite and microcomposite [electrical insulation applications],” in Proceedings of the Annual Report Conference on Electrical Insulation and Dielectric Phenomena (CEIDP '04), pp. 398–401, IEEE, Vancouver, Canada, October 2004. View at Publisher · View at Google Scholar
  10. J. K. Nelson, J. C. Fothergill, L. A. Dissado, and W. Peasgood, “Towards an understanding of nanometric dielectrics,” in Proceedings of the Annual Report Conference on Electrical Insulation and Dielectric Phenomena (CEIDP '02), pp. 295–298, IEEE, October 2002. View at Publisher · View at Google Scholar
  11. Y. Nakamura, H. Inano, S. Hiroshima, T. Hirose, M. Hamaguchi, and H. Okubo, “Partial discharge resistant aging mechanism of nanocomposite enamel wires under repetitive surge voltage condition,” in Proceedings of the Annual Report Conference on Electrical Insulation and Dielectric Phenomena (CEIDP '08), pp. 375–378, Quebec, Canada, October 2008. View at Publisher · View at Google Scholar · View at Scopus
  12. M. Son, Y. Ha, M.-C. Choi et al., “Microstructure and properties of polyamideimide/silica hybrids compatibilized with 3-aminopropyltriethoxysilane,” European Polymer Journal, vol. 44, no. 7, pp. 2236–2243, 2008. View at Publisher · View at Google Scholar · View at Scopus
  13. X. Ma, N.-H. Lee, H.-J. Oh, J.-S. Hwang, and S.-J. Kim, “Preparation and characterization of silica/polyamide-imide nanocomposite thin films,” Nanoscale Research Letters, vol. 5, no. 11, pp. 1846–1851, 2010. View at Publisher · View at Google Scholar · View at Scopus
  14. F. M. John, E. S. Howard, and J. Z. Edmund, “Polyester-polyimide wire enamel,” Google Patents, 1969.
  15. H. Kikuchi, Y. Yukimori, and S. Itonaga, “Inverter-surge-resistant enameled wire based on nano-composite insulating material,” Hitachi Cable Review, vol. 21, pp. 55–62, 2002. View at Google Scholar
  16. B. Gornicka and E. Prociow, “Polyester and polyesterimide compounds with nanofillers for impregnating of electrical motors,” Acta Physica Polonica A, vol. 115, no. 4, pp. 842–845, 2009. View at Google Scholar · View at Scopus
  17. Y. Uozumi, Y. Kikuchi, N. Fukumoto, M. Nagata, Y. Wakimoto, and T. Yoshimitsu, “Characteristics of partial discharge and time to breakdown of nanocomposite enameled wire,” in Proceedings of the Annual Report—Conference on Electrical Insulation and Dielectric Phenomena (CEIDP '07), pp. 228–231, Vancouver, Canada, 2007.
  18. K. Inuzuka, H. Inano, N. Hayakawa, T. Hirose, M. Hamaguchi, and H. Okubo, “Partial discharge characteristics of nanocomposite enameled wire for inverter-fed motor,” in Proceedings of the Conference on Electrical Insulation and Dielectric Phenomena (CEIDP '06), pp. 594–597, IEEE, Kansas, Mo, USA, October 2006. View at Publisher · View at Google Scholar · View at Scopus
  19. M. Mesaki and H. Goda, “Hybrid composites of polyamide-imide and silica applied to wire insulation,” in Proceedings of the Electrical Insulation Conference and Electrical Manufacturing & Coil Winding Conference, pp. 1–4, IEEE, Cincinnati, Ohio, USA, October 2001. View at Publisher · View at Google Scholar
  20. S. Al-Kandary, A. A. M. Ali, and Z. Ahmad, “New polyimide-silica nano-composites from the sol-gel process using organically-modified silica network structure,” Journal of Materials Science, vol. 41, no. 10, pp. 2907–2914, 2006. View at Publisher · View at Google Scholar · View at Scopus
  21. H. T. Wang, W. Zhong, P. Xu, and Q. Du, “Properties of polyimide/silica nanohybrids from silicic acid oligomer,” Macromolecular Materials and Engineering, vol. 289, no. 9, pp. 793–799, 2004. View at Publisher · View at Google Scholar · View at Scopus
  22. Y. Kim, S.-Y. Park, S. Y. Kwon, S.-J. Kim, J. Kim, and Y.-S. Seo, “Enhanced thermal resistance of nanocomposite enameled wire prepared from surface modified silica nanoparticle,” Thermochimica Acta, vol. 542, pp. 62–68, 2012. View at Publisher · View at Google Scholar · View at Scopus
  23. B.-K. Chen, C.-T. Su, M.-C. Tseng, and S.-Y. Tsay, “Preparation of polyetherimide nanocomposites with improved thermal, mechanical and dielectric properties,” Polymer Bulletin, vol. 57, no. 5, pp. 671–681, 2006. View at Publisher · View at Google Scholar · View at Scopus