|
S0, S3, S6: | Operative state of Phytoremediation process. |
S1, S2, S4, S5: | Failure state of Phytoremediation process. |
Sj: | Water Quality Parameter COD range 100-2000 mg L−1 |
Ps: | C. vulgaris is in unreactive mode (standby mode) |
Po: | C. vulgaris is in reactive mode. |
S1F: | Failure due to low range of j. |
S2F: | Failure due to high range of j. |
TEi: | Textile Effluent in different concentration |
where i = 1-5(10%, 25%, 50%,75%,100%). |
P1: | Probability of j ≥ lower range of COD. |
P2: | Probability of j ≤ upper range of COD |
P3: | Probability of TEi in required concentration when i = 1-3. |
P4: | Probability in 500 mg L−1 C. vulgaris required amount. |
q1: | Failure Probability of i not greater than lower range of parameters. |
q2: | Failure Probability of i not less than upper range of parameters. |
q3: | Failure Probability of TEi of concentration when i = 4 & 5. |
q4: | Failure probability of C. vulgaris amount less than 500 mg. |
XTP: | Success state of treatment of TE. |
XTF: | Failure state due to TE of concentration i = 4 & 5. |
XFP: | Failure state due to algae with less amount. |
r1: | Replacement cost due to failure in initial stage (S1F and S2F). |
r2: | Replacement cost due to failure in treatment stage (XTF and XFP). |
|