Table of Contents
Journal of Thermodynamics
Volume 2012 (2012), Article ID 574596, 8 pages
http://dx.doi.org/10.1155/2012/574596
Research Article

Numerical Analysis of Flow Field and Heat Transfer of 2D Wavy Ducts and Optimization by Entropy Generation Minimization Method

Department of Mechanical Engineering, Marvdasht Branch, Islamic Azad University, Marvdasht 73711-13119, Iran

Received 2 July 2011; Revised 10 November 2011; Accepted 13 November 2011

Academic Editor: Felix Sharipov

Copyright © 2012 Ouldouz Nourani Zonouz and Mehdi Salmanpour. This is an open access article distributed under the Creative Commons Attribution License, which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited.

Linked References

  1. B. Sunden and S. Trollheden, “Periodic laminar flow and heat transfer in a corrugated two-dimensional channel,” International Communications in Heat and Mass Transfer, vol. 16, no. 2, pp. 215–225, 1989. View at Google Scholar · View at Scopus
  2. T. Nishimura and S. Matsune, “Vortices and wall shear stresses in asymmetric and symmetric channels with sinusoidal wavy walls for pulsatile flow at low Reynolds numbers,” International Journal of Heat and Fluid Flow, vol. 19, no. 6, pp. 583–593, 1998. View at Publisher · View at Google Scholar · View at Scopus
  3. G. Fabbri, “Heat transfer optimization in corrugated wall channels,” International Journal of Heat and Mass Transfer, vol. 43, no. 23, pp. 4299–4310, 2000. View at Google Scholar · View at Scopus
  4. G. Fabbri and R. Rossi, “Analysis of the heat transfer in the entrance region of optimised corrugated wall channel,” International Communications in Heat and Mass Transfer, vol. 32, no. 7, pp. 902–912, 2005. View at Publisher · View at Google Scholar · View at Scopus
  5. C. Y. Cheng and C. C. Wang, “Forced convection in micropolar fluid flow over a wavy surface,” Numerical Heat Transfer A, vol. 37, no. 3, pp. 271–287, 2000. View at Google Scholar · View at Scopus
  6. S. Ergin, M. Ota, and H. Yamaguchi, “Numerical study of periodic turbulent flow through a corrugated duct,” Numerical Heat Transfer A, vol. 40, no. 2, pp. 139–156, 2001. View at Publisher · View at Google Scholar · View at Scopus
  7. M. Vasudevaiah and K. Balamurugan, “Heat transfer of rarefied gases in a corrugated microchannel,” International Journal of Thermal Sciences, vol. 40, no. 5, pp. 454–468, 2001. View at Publisher · View at Google Scholar · View at Scopus
  8. B. Niceno and E. Nobile, “Numerical analysis of fluid flow and heat transfer in periodic wavy channels,” International Journal of Heat and Fluid Flow, vol. 22, no. 2, pp. 156–167, 2001. View at Publisher · View at Google Scholar · View at Scopus
  9. A. Ali and Y. Hanaoka, “Experimental study on laminar flow forced-convection in a channel with upper V-corrugated plate heated by radiation,” International Journal of Heat and Mass Transfer, vol. 45, no. 10, pp. 2107–2117, 2002. View at Publisher · View at Google Scholar · View at Scopus
  10. C. Zimmerer, P. Gschwind, G. Gaiser, and V. Kottke, “Comparison of heat and mass transfer in different heat exchanger geometries with corrugated walls,” Experimental Thermal and Fluid Science, vol. 26, no. 2-4, pp. 269–273, 2002. View at Publisher · View at Google Scholar · View at Scopus
  11. A. M. Guzman and C. H. Amon, “Transition to chaos in converging-diverging channel flows: ruelle-takens-newhouse scenario,” Physics of Fluids A, vol. 6, no. 6, pp. 1994–2002, 1994. View at Google Scholar · View at Scopus
  12. A. M. Guzman and C. H. Amon, “Dynamical flow characterization of transitional and chaotic regimes in converging-diverging channels,” Journal of Fluid Mechanics, vol. 321, pp. 25–57, 1996. View at Google Scholar · View at Scopus
  13. A. M. Guzman and C. H. Amon, “Convective heat transfer and flow mixing in converging-diverging channel flows,” in Proceedings of the ASME International Mechanical Engineering Congress and Exposition, pp. 61–68, November 1998, HTD-Vol. 361-1.
  14. C. C. Wang and C. K. Chen, “Forced convection in a wavy-wall channel,” International Journal of Heat and Mass Transfer, vol. 45, no. 12, pp. 2587–2595, 2002. View at Publisher · View at Google Scholar · View at Scopus
  15. S. Savino, G. Comini, and C. Nonino, “Three-dimensional analysis of convection in two-dimensional wavy channels,” Numerical Heat Transfer A, vol. 46, no. 9, pp. 869–890, 2004. View at Publisher · View at Google Scholar · View at Scopus
  16. M. Z. Hossain and A. K. M. Islam, “Fully developed flow structures and heat transfer in sine-shaped wavy channels,” International Communications in Heat and Mass Transfer, vol. 31, no. 6, pp. 887–896, 2004. View at Publisher · View at Google Scholar · View at Scopus
  17. H. M. Metwally and R. M. Manglik, “Enhanced heat transfer due to curvature-induced lateral vortices in laminar flows in sinusoidal corrugated-plate channels,” International Journal of Heat and Mass Transfer, vol. 47, no. 10-11, pp. 2283–2292, 2004. View at Publisher · View at Google Scholar · View at Scopus
  18. P. Naphon, “Laminar convective heat transfer and pressure drop in the corrugated channels,” International Communications in Heat and Mass Transfer, vol. 34, no. 1, pp. 62–71, 2007. View at Publisher · View at Google Scholar · View at Scopus
  19. P. Naphon, “Heat transfer characteristics and pressure drop in channel with V corrugated upper and lower plates,” Energy Conversion and Management, vol. 48, no. 5, pp. 1516–1524, 2007. View at Publisher · View at Google Scholar · View at Scopus
  20. P. Naphon, “Effect of corrugated plates in an in-phase arrangement on the heat transfer and flow developments,” International Journal of Heat and Mass Transfer, vol. 51, no. 15-16, pp. 3963–3971, 2008. View at Publisher · View at Google Scholar · View at Scopus
  21. M. Gradeck, B. Hoareau, and M. Lebouche, “Local analysis of heat transfer inside corrugated channel,” International Journal of Heat and Mass Transfer, vol. 48, no. 10, pp. 1909–1915, 2005. View at Publisher · View at Google Scholar · View at Scopus
  22. Y. Islamoglu and C. Parmaksizoglu, “The effect of channel height on the enhanced heat transfer characteristics in a corrugated heat exchanger channel,” Applied Thermal Engineering, vol. 23, no. 8, pp. 979–987, 2003. View at Publisher · View at Google Scholar · View at Scopus
  23. Y. Islamoglu and A. Kurt, “Heat transfer analysis using ANNs with experimental data for air flowing in corrugated channels,” International Journal of Heat and Mass Transfer, vol. 47, no. 6-7, pp. 1361–1365, 2004. View at Publisher · View at Google Scholar · View at Scopus
  24. Y. Islamoglu and C. Parmaksizoglu, “Numerical investigation of convective heat transfer and pressure drop in a corrugated heat exchanger channel,” Applied Thermal Engineering, vol. 24, no. 1, pp. 141–147, 2004. View at Publisher · View at Google Scholar · View at Scopus
  25. S. Kuhn and P. R. V. Rohr, “Experimental investigation of mixed convective flow over a wavy wall,” International Journal of Heat and Fluid Flow, vol. 29, no. 1, pp. 94–106, 2008. View at Publisher · View at Google Scholar
  26. S. W. Chang, A. W. Lees, and T. C. Chou, “Heat transfer and pressure drop in furrowed channels with transverse and skewed sinusoidal wavy walls,” International Journal of Heat and Mass Transfer, vol. 52, no. 19-20, pp. 4592–4603, 2009. View at Publisher · View at Google Scholar · View at Scopus
  27. S. W. Chang, A. W. Lees, T. M. Liou, and G. F. Hong, “Heat transfer of a radially rotating furrowed channel with two opposite skewed sinusoidal wavy walls,” International Journal of Thermal Sciences, vol. 49, no. 5, pp. 769–785, 2010. View at Publisher · View at Google Scholar · View at Scopus
  28. M. V. Pham, F. Plourde, and S. K. Doan, “Turbulent heat and mass transfer in sinusoidal wavy channels,” International Journal of Heat and Fluid Flow, vol. 29, no. 5, pp. 1240–1257, 2008. View at Publisher · View at Google Scholar · View at Scopus
  29. Y. Sui, C. J. Teo, P. S. Lee, Y. T. Chew, and C. Shu, “Fluid flow and heat transfer in wavy microchannels,” International Journal of Heat and Mass Transfer, vol. 53, no. 13-14, pp. 2760–2772, 2010. View at Publisher · View at Google Scholar