Table of Contents
Journal of Waste Management
Volume 2014 (2014), Article ID 517219, 14 pages
http://dx.doi.org/10.1155/2014/517219
Research Article

Response Surfaces for Fresh and Hardened Properties of Concrete with E-Waste (HIPS)

Department of Civil Engineering, National Institute of Technology, Tiruchirappalli, Tamil Nadu 620015, India

Received 17 July 2014; Accepted 10 September 2014; Published 25 September 2014

Academic Editor: Milva Pepi

Copyright © 2014 K. Senthil Kumar and K. Baskar. This is an open access article distributed under the Creative Commons Attribution License, which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited.

Linked References

  1. R. Widmer, H. Oswald-Krapf, D. Sinha-Khetriwal, M. Schnellmann, and H. Böni, “Global perspectives on e-waste,” Environmental Impact Assessment Review, vol. 25, no. 5, pp. 436–458, 2005. View at Publisher · View at Google Scholar · View at Scopus
  2. P. Rekacewicz, “UNEP/GRID-Arendal. Who Gets the Trash? ‘Basel Action Network: Vital Waste Graphics’,” 2014, http://www.grida.no/graphicslib/detail/who-gets-the-trash_10c0 and http://maps.grida.no/go/graphic/who_gets_the_trash.
  3. 2014, http://toxicslink.org/, http://toxicslink.org/docs/06040_repsumry.pdf.
  4. Central Pollution Control Board (CPCB), New Delhi, India, March 2013, http://cpcb.nic.in/e_Waste.php.
  5. E-Waste in India, 2011, http://rajyasabha.nic.in/rsnew/publication_electronic/E-Waste_in_india.pdf .
  6. P. Kiddee, R. Naidu, and M. H. Wong, “Electronic waste management approaches: an overview,” Waste Management, vol. 33, no. 5, pp. 1237–1250, 2013. View at Publisher · View at Google Scholar · View at Scopus
  7. B. H. Robinson, “E-waste: an assessment of global production and environmental impacts,” Science of the Total Environment, vol. 408, no. 2, pp. 183–191, 2009. View at Publisher · View at Google Scholar · View at Scopus
  8. Waste Electrical and Electronic Equipment, “The EU and India: sharing best practices,” 2013, http://eeas.europa.eu/delegations/india/documents/eu_india/final_e_waste_book_en.pdf.
  9. K. S. Kumar and K. Baskar, “Recycling of E-plastic waste as a construction material in developing countries,” Journal of Material Cycles and Waste Management, 2014. View at Publisher · View at Google Scholar
  10. M. Yeheyis, K. Hewage, M. S. Alam, C. Eskicioglu, and R. Sadiq, “An overview of construction and demolition waste management in Canada: a lifecycle analysis approach to sustainability,” Clean Technologies and Environmental Policy, vol. 15, no. 1, pp. 81–91, 2013. View at Publisher · View at Google Scholar · View at Scopus
  11. M. Shahria Alam, E. Slater, and A. H. M. Muntasir Billah, “Green concrete made with RCA and FRP scrap aggregate: fresh and hardened properties,” Journal of Materials in Civil Engineering, vol. 25, no. 12, pp. 1783–1794, 2013. View at Publisher · View at Google Scholar · View at Scopus
  12. O. Çakır, “Experimental analysis of properties of recycled coarse aggregate (RCA) concrete with mineral additives,” Construction and Building Materials, vol. 68, pp. 17–25, 2014. View at Publisher · View at Google Scholar
  13. G. Andreu and E. Miren, “Experimental analysis of properties of high performance recycled aggregate concrete,” Construction and Building Materials, vol. 52, pp. 227–235, 2014. View at Publisher · View at Google Scholar · View at Scopus
  14. A. M. Ghaly and M. S. Gill, “Compression and deformation performance of concrete containing postconsumer plastics,” Journal of Materials in Civil Engineering, vol. 16, no. 4, pp. 289–296, 2004. View at Publisher · View at Google Scholar · View at Scopus
  15. Y. W. Choi, D. J. Moon, Y. J. Kim, and M. Lachemi, “Characteristics of mortar and concrete containing fine aggregate manufactured from recycled waste polyethylene terephthalate bottles,” Construction and Building Materials, vol. 23, no. 8, pp. 2829–2835, 2009. View at Publisher · View at Google Scholar · View at Scopus
  16. Y.-W. Choi, D.-J. Moon, J.-S. Chung, and S.-K. Cho, “Effects of waste PET bottles aggregate on the properties of concrete,” Cement and Concrete Research, vol. 35, no. 4, pp. 776–781, 2005. View at Publisher · View at Google Scholar · View at Scopus
  17. R. Siddique and T. R. Naik, “Properties of concrete containing scrap-tire rubber: an overview,” Waste Management, vol. 24, no. 6, pp. 563–569, 2004. View at Publisher · View at Google Scholar · View at Scopus
  18. E. Ganjian, M. Khorami, and A. A. Maghsoudi, “Scrap-tyre-rubber replacement for aggregate and filler in concrete,” Construction and Building Materials, vol. 23, no. 5, pp. 1828–1836, 2009. View at Publisher · View at Google Scholar · View at Scopus
  19. A. Palos, N. A. D'Souza, C. T. Snively, and R. F. Reidy III, “Modification of cement mortar with recycled ABS,” Cement and Concrete Research, vol. 31, no. 7, pp. 1003–1007, 2001. View at Publisher · View at Google Scholar · View at Scopus
  20. R. Wang, T. Zhang, and P. Wang, “Waste printed circuit boards nonmetallic powder as admixture in cement mortar,” Materials and Structures, vol. 45, no. 10, pp. 1439–1445, 2012. View at Publisher · View at Google Scholar · View at Scopus
  21. R. Wang and C. Meyer, “Performance of cement mortar made with recycled high impact polystyrene,” Cement and Concrete Composites, vol. 34, no. 9, pp. 975–981, 2012. View at Publisher · View at Google Scholar · View at Scopus
  22. R. Lakshmi and S. Nagan, “Utilization of waste E plastic particles in cementitious mixtures,” Journal of Structural Engineering, vol. 38, no. 1, pp. 26–35, 2011. View at Google Scholar · View at Scopus
  23. B. W. Colbert and Z. You, “Properties of modified asphalt binders blended with electronic waste powders,” Journal of Materials in Civil Engineering, vol. 24, no. 10, pp. 1261–1267, 2012. View at Publisher · View at Google Scholar · View at Scopus
  24. C. H. Chen, R. Huang, J. K. Wu, and C. C. Yang, “Waste E-glass particles used in cementitious mixtures,” Cement and Concrete Research, vol. 36, no. 3, pp. 449–456, 2006. View at Publisher · View at Google Scholar · View at Scopus
  25. Z. Hui and W. Sun, “Study of properties of mortar containing cathode ray tubes (CRT) glass as replacement for river sand fine aggregate,” Construction and Building Materials, vol. 25, no. 10, pp. 4059–4064, 2011. View at Publisher · View at Google Scholar · View at Scopus
  26. T.-C. Ling and C.-S. Poon, “Utilization of recycled glass derived from cathode ray tube glass as fine aggregate in cement mortar,” Journal of Hazardous Materials, vol. 192, no. 2, pp. 451–456, 2011. View at Publisher · View at Google Scholar · View at Scopus
  27. T.-C. Ling, C.-S. Poon, W.-S. Lam, T.-P. Chan, and K. K.-L. Fung, “Utilization of recycled cathode ray tubes glass in cement mortar for X-ray radiation-shielding applications,” Journal of Hazardous Materials, vol. 199-200, pp. 321–327, 2012. View at Publisher · View at Google Scholar · View at Scopus
  28. T.-C. Ling and C.-S. Poon, “Use of recycled CRT funnel glass as fine aggregate in dry-mixed concrete paving blocks,” Journal of Cleaner Production, vol. 68, pp. 209–215, 2014. View at Publisher · View at Google Scholar · View at Scopus
  29. D. Romero, J. James, R. Mora, and C. D. Hays, “Study on the mechanical and environmental properties of concrete containing cathode ray tube glass aggregate,” Waste Management, vol. 33, no. 7, pp. 1659–1666, 2013. View at Publisher · View at Google Scholar · View at Scopus
  30. G. Sua-iam and N. Makul, “Use of limestone powder during incorporation of Pb-containing cathode ray tube waste in self-compacting concrete,” Journal of Environmental Management, vol. 128, pp. 931–940, 2013. View at Publisher · View at Google Scholar · View at Scopus
  31. IS 12269-1987, Specification for 53 Grade Ordinary Portland Cement, Bureau of Indian Standards, New Delhi, India, 1987.
  32. IS 2386 (Part I-IV), “Methods of test for aggregates for concrete,” Indian Standard, Bureau of Indian Standards, New Delhi, India, 1963. View at Google Scholar
  33. IS 10262-2009, Concrete Mix Proportioning-Guidelines, Bureau of Indian Standards, New Delhi, India, 2009.
  34. IS 456-2000, Plain and Reinforced Concrete—Code of Practice, Bureau of Indian Standards, New Delhi, India.
  35. “Indian standard code of practice—methods of test for strength of concrete,” Tech. Rep. IS 516-1959, Bureau of Indian Standards, New Delhi, India, 2013.
  36. Bureau of Indian Standards, “Indian standard methods of sampling and analysis of concrete,” IS 1199-1959, Bureau of Indian Standards, New Delhi, India, 1999. View at Google Scholar
  37. D. C. Montgomery, Design and Analysis of Experiments, John Wiley & Sons, New York, NY, USA, 5th edition, 2001.