Table of Contents
Laser Chemistry
Volume 2008, Article ID 976205, 6 pages
http://dx.doi.org/10.1155/2008/976205
Research Article

Three-Dimensional Modeling of the Heat-Affected Zone in Laser Machining Applications

1Institute of Materials Science and Applied Research, Saulėtekio 9, 2040 Vilnius, Lithuania
2Altechna Co. Ltd., Konstitucijos Avenue 23C-604, 08105 Vilnius, Lithuania
3Laser Research Center, Vilnius University, Saulėtekio 10, 10223 Vilnius, Lithuania
4Research Institute for Electronic Science, Hokkaido University, N21W10, Kitaku, Sapporo 001-0021, Japan

Received 5 May 2008; Accepted 16 September 2008

Academic Editor: Stavros Pissadakis

Copyright © 2008 Martynas Beresna et al. This is an open access article distributed under the Creative Commons Attribution License, which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited.

Linked References

  1. K. M. Davis, K. Miura, N. Sugimoto, and K. Hirao, “Writing waveguides in glass with a femtosecond laser,” Optics Letters, vol. 21, no. 21, pp. 1729–1731, 1996. View at Google Scholar
  2. M. Will, S. Nolte, B. N. Chichkov, and A. Tünnermann, “Optical properties of waveguides fabricated in fused silica by femtosecond laser pulses,” Applied Optics, vol. 41, no. 21, pp. 4360–4364, 2002. View at Publisher · View at Google Scholar
  3. H. Zhang, S. M. Eaton, J. Li, and P. R. Herman, “Femtosecond laser direct writing of multiwavelength Bragg grating waveguides in glass,” Optics Letters, vol. 31, no. 23, pp. 3495–3497, 2006. View at Publisher · View at Google Scholar
  4. A. H. Nejadmalayeri and P. R. Herman, “Rapid thermal annealing in high repetition rate ultrafast laser waveguide writing in lithium niobate,” Optics Express, vol. 15, no. 17, pp. 10842–10854, 2007. View at Publisher · View at Google Scholar
  5. Z. Wang, K. Sugioka, Y. Hanada, and K. Midorikawa, “Optical waveguide fabrication and integration with a micro-mirror inside photosensitive glass by femtosecond laser direct writing,” Applied Physics A, vol. 88, no. 4, pp. 699–704, 2007. View at Publisher · View at Google Scholar
  6. S. Pissadakis, R. Böhme, and K. Zimmer, “Sub-micron periodic structuring of sapphire by laser induced backside wet etching technique,” Optics Express, vol. 15, no. 4, pp. 1428–1433, 2007. View at Publisher · View at Google Scholar
  7. S. Yliniemi, S. Honkanen, A. Ianoul, A. Laronche, and J. Albert, “Photosensitivity and volume gratings in phosphate glasses for rare-earth-doped ion-exchanged optical waveguide lasers,” Journal of the Optical Society of America B, vol. 23, no. 12, pp. 2470–2478, 2006. View at Publisher · View at Google Scholar
  8. S. Juodkazis, V. Mizeikis, S. Matsuo, K. Ueno, and H. Misawa, “Three-dimensional micro- and nano-structuring of materials by tightly focused laser radiation,” Bulletin of the Chemical Society of Japan, vol. 81, no. 4, pp. 411–448, 2008. View at Publisher · View at Google Scholar
  9. S. Juodkazis, V. Mizeikis, and H. Misawa, “Three-dimensional structuring of resists and resins by direct laser writing and holographic recording,” in Photoresponsive Polymers I, vol. 213 of Advances in Polymer Science, pp. 157–206, Springer, Berlin, Germany, 2008. View at Publisher · View at Google Scholar · View at PubMed
  10. E. Vanagas, J.-Y. Ye, M. Li, M. Miwa, S. Juodkazis, and H. Misawa, “Analysis of stress induced by a three-dimensional recording in glass,” Applied Physics A, vol. 81, no. 4, pp. 725–727, 2005. View at Publisher · View at Google Scholar
  11. S. Juodkazis, H. Misawa, E. Vanagas, and M. Li, “Thermal effects and breakdown in laser microfabrication,” in Proceedings of the 4th International Congress on Laser Advanced Materials Processing (LAMP '06), pp. 6–60, Kyoto, Japan, May 2006.
  12. W. J. Reichman, D. M. Krol, L. Shah et al., “A spectroscopic comparison of femtosecond-laser-modified fused silica using kilohertz and megahertz laser systems,” Journal of Applied Physics, vol. 99, no. 12, Article ID 123112, 5 pages, 2006. View at Publisher · View at Google Scholar
  13. M. Watanabe, S. Juodkazis, J. Nishii, S. Matsuo, and H. Misawa, “Microfabrication by a high-fluence femtosecond exposure: mechanism and applications,” in Photon Processing in Microelectronics and Photonics, K. Sugioka, M. C. Gower, R. F. Haglund et al., Eds., vol. 4637 of Proceedings of SPIE, pp. 159–168, San Jose, Calif, USA, January 2002. View at Publisher · View at Google Scholar
  14. S. Juodkazis, H. Misawa, and I. Maksimov, “Thermal accumulation effect in three-dimensional recording by picosecond pulses,” Applied Physics Letters, vol. 85, no. 22, pp. 5239–5241, 2004. View at Publisher · View at Google Scholar
  15. S. Juodkazis and H. Misawa, “Laser processing of sapphire by strongly focused femtosecond pulses,” Applied Physics A, vol. 93, no. 4, pp. 857–861, 2008. View at Publisher · View at Google Scholar
  16. I. Miyamoto, A. Horn, J. Gottmann, D. Wortmann, and F. Yoshino, “Fusion welding of glass using femtosecond laser pulses with high-repetition rates,” Journal of Laser Micro/Nanoengineering, vol. 2, no. 1, pp. 57–63, 2007. View at Google Scholar
  17. W. Watanabe, S. Onda, T. Tamaki, and K. Itoh, “Direct joining of glass substrates by 1 kHz femtosecond laser pulses,” Applied Physics B, vol. 87, no. 1, pp. 85–89, 2007. View at Publisher · View at Google Scholar
  18. E. E. Gamaly, S. Juodkazis, K. Nishimura et al., “Laser-matter interaction in the bulk of a transparent solid: confined microexplosion and void formation,” Physical Review B, vol. 73, no. 21, Article ID 214101, 15 pages, 2006. View at Publisher · View at Google Scholar
  19. S. Juodkazis, K. Nishimura, S. Tanaka et al., “Laser-induced microexplosion confined in the bulk of a sapphire cystal: evidence of multimegabar pressures,” Physical Review Letters, vol. 96, no. 16, Article ID 166101, 4 pages, 2006. View at Publisher · View at Google Scholar
  20. S. Juodkazis, K. Nishimura, H. Misawa et al., “Control over the crystalline state of sapphire,” Advanced Materials, vol. 18, no. 11, pp. 1361–1364, 2006. View at Publisher · View at Google Scholar
  21. S. Kobyakov, A. Kamińska, A. Suchocki, D. Galanciak, and M. Malinowski, “Nd3+-doped yttrium aluminum garnet crystal as a near-infrared pressure sensor for diamond anvil cells,” Applied Physics Letters, vol. 88, no. 23, Article ID 234102, 2 pages, 2006. View at Publisher · View at Google Scholar
  22. G. A. Torchia, P. F. Meilán, A. Rodenas, D. Jaque, C. Mendez, and L. Roso, “Femtosecond laser written surface waveguides fabricated in Nd:YAG ceramics,” Optics Express, vol. 15, no. 20, pp. 13266–13271, 2007. View at Publisher · View at Google Scholar
  23. G. A. Torchia, A. Rodenas, A. Benayas, E. Cantelar, L. Roso, and D. Jaque, “Highly efficient laser action in femtosecond-written Nd:yttrium aluminum garnet ceramic waveguides,” Applied Physics Letters, vol. 92, no. 11, Article ID 111103, 3 pages, 2008. View at Publisher · View at Google Scholar
  24. T. H. Courtney, Mechanical Behavior of Materials, McGraw-Hill International Editions: Material Science/Metallurgy Series, McGraw-Hill, New York, NY, USA, 2nd edition, 2000.
  25. S. Nolte, C. Momma, H. Jacobs et al., “Ablation of metals by ultrashort laser pulses,” Journal of the Optical Society of America B, vol. 14, no. 10, pp. 2716–2722, 1997. View at Publisher · View at Google Scholar
  26. A. Marcinkevicius, S. Juodkazis, S. Matsuo, V. Mizeikis, and H. Misawa, “Application of Bessel beams for microfabrication of dielectrics by femtosecond laser,” Japanese Journal of Applied Physics, vol. 40, no. 11A, pp. L1197–L1199, 2001. View at Publisher · View at Google Scholar
  27. W. Yang, P. G. Kazansky, and Y. P. Svirko, “Non-reciprocal ultrafast laser writing,” Nature Photonics, vol. 2, no. 2, pp. 99–104, 2008. View at Publisher · View at Google Scholar