Table of Contents Author Guidelines Submit a Manuscript
Mathematical Problems in Engineering
Volume 2012, Article ID 593568, 17 pages
http://dx.doi.org/10.1155/2012/593568
Research Article

Single-Stage Coupled-Inductor Sepic-Type HB-LED Driver with Soft Switching for Universal Line Input

1Department of Electronic Engineering, National Kaohsiung First University of Science and Technology, Kaohsiung City 811, Taiwan
2Department of Electrical Engineering, Far East University, Tainan City 744, Taiwan

Received 5 January 2012; Revised 20 May 2012; Accepted 20 May 2012

Academic Editor: Ricardo Femat

Copyright © 2012 Chih-Lung Shen and Kuo-Kuang Chen. This is an open access article distributed under the Creative Commons Attribution License, which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited.

Linked References

  1. M. Ilic and D. Maksimovic, “Averaged switch modeling of the interleaved zero current transition buck converter,” in Proceedings of the IEEE Power Electronics Specialists Conference, 2005, pp. 2158–2163, 2005.
  2. J. Rajagopalan, F. C. Lee, and P. Nora, “A general technique for derivation of average current mode control laws for single-phase power-factor-correction circuits without input voltage sensing,” IEEE Transactions on Power Electronics, vol. 14, no. 4, pp. 663–672, 1999. View at Google Scholar · View at Scopus
  3. D. Maksimovic, J. Yungtaek, and R. Erickson, “Nonlinear-carrier control for high power factor boost rectifiers,” in Proceedings of the IEEE Applied Power Electronics Conference and Exposition, vol. 2, pp. 635–641, March 1995. View at Scopus
  4. C. Jingquan, D. Maksimović, and R. W. Erickson, “Analysis and design of a low-stress buck-boost converter in universal-input PFC applications,” IEEE Transactions on Power Electronics, vol. 21, no. 2, pp. 320–329, 2006. View at Publisher · View at Google Scholar · View at Scopus
  5. L. Petersen and R. W. Erickson, “Reduction of voltage stresses in buck-boost-type power factor correctors operating in boundary conduction mode,” in Proceedings of the IEEE Applied Power Electronics Conference and Exposition, vol. 2, pp. 664–670, February 2003. View at Scopus
  6. J. M. Kwon, W. Y. Choi, J. J. Lee, E. H. Kim, and B. H. Kwon, “Continuous-conduction-mode SEPIC converter with low reverse-recovery loss for power factor correction,” Proceedings of the IEE Proceedings of Electric Power Applications, vol. 153, no. 5, pp. 673–681, 2006. View at Publisher · View at Google Scholar · View at Scopus
  7. H. Y. Kanaan, K. Al-Haddad, G. Sauriole, and R. Chaffaï, “Practical design of a SEPIC power factor corrector with DC-voltage regulation,” in Proceedings of the International Symposium on Industrial Electronics (ISIE '06), pp. 964–969, July 2006. View at Publisher · View at Google Scholar · View at Scopus
  8. H. Y. Kanaan, K. Al-Haddad, and F. Fnaiech, “Switching-function-based modeling and control of a SEPIC power factor correction circuit operating in continuous and discontinuous current modes,” in Proceedings of the IEEE International Conference on Industrial Technology (ICIT '04), vol. 1, pp. 431–437, December 2004. View at Scopus
  9. T. Tanitteerapan and S. Mori, “Simplified input current waveshaping technique by using inductor voltage sensing for high power factor isolated sepic, cuk and flyback rectifiers,” in Proceedings of the IEEE Applied Power Electronics Conference and Exposition, vol. 2, pp. 1208–1214, March 2002. View at Scopus
  10. R. Zane and D. Maksimovic, “Nonlinear-carrier control for high-power-factor rectifiers based on flyback, cuk or sepic converters,” in Proceedings of the IEEE Applied Power Electronics Conference and Exposition, vol. 2, pp. 814–820, March 1996. View at Scopus
  11. N. Jayaram and D. Maksimovic, “Power factor correctors based on coupled-inductor sepic and cuk converters with nonlinear-carrier control,” in Proceedings of the IEEE Applied Power Electronics Conference and Exposition, vol. 1, pp. 468–474, February 1998. View at Scopus
  12. C. Jingquan and C. Chin, “Analysis and design of SEPIC converter in boundary conduction mode for universal-line power factor correction applications,” in Proceedings of the IEEE Power Electronics Specialists Conference, vol. 2, pp. 742–747, June 2001. View at Scopus
  13. S. Singh and B. Singh, “Voltage controlled PFC SEPIC converter fed PMBLDCM drive for an air-conditioner,” in Proceedings of the IEEE Power Electronics, Drives and Energy Systems, pp. 1–6, December 2010. View at Publisher · View at Google Scholar · View at Scopus