Table of Contents Author Guidelines Submit a Manuscript
Mathematical Problems in Engineering
Volume 2014, Article ID 787382, 15 pages
http://dx.doi.org/10.1155/2014/787382
Research Article

Improvement of Energy Density in Single Stator Interior Permanent Magnet Using Double Stator Topology

1Department of Electrical and Electronics, Faculty of Engineering, Universiti Putra Malaysia, Malaysia
2Faculty of Electrical Engineering, Universiti Teknikal Malaysia, Melaka, Malaysia
3Institute of Advanced Technology (ITMA), Universiti Putra Malaysia, 43400 Serdang, Selangor, Malaysia
4CIARG, School of Engineering, Taylor’s University, 47500 Selangor, Malaysia
5Nagano National College of Technology, 716 Tokuma, Nagano 381-8550, Japan
6Shinshu University, 500 Wakasato, Nagano 380-8553, Japan

Received 18 October 2013; Revised 15 March 2014; Accepted 21 March 2014; Published 23 April 2014

Academic Editor: Sergio Preidikman

Copyright © 2014 Raja Nor Firdaus et al. This is an open access article distributed under the Creative Commons Attribution License, which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited.

Linked References

  1. S. Bentouati, Z. Q. Zhu, and D. Howe, “Influence of design parameters on the starting torque of a single-phase PM brushless DC motor,” IEEE Transactions on Magnetics, vol. 36, no. 5, pp. 3533–3536, 2000. View at Publisher · View at Google Scholar · View at Scopus
  2. S. Lizhi, F. Qi, and S. Jing, “Drive of single-phase brushless DC motors based on torque analysis,” IEEE Transactions on Magnetics, vol. 43, no. 1, pp. 46–50, 2007. View at Publisher · View at Google Scholar · View at Scopus
  3. W. Wang, H. Wang, and H. R. Karimi, “Study on the characteristics of electromagnetic noise of axial flux permanent magnet synchronous motor,” Abstract and Applied Analysis, vol. 2014, Article ID 764105, 8 pages, 2014. View at Publisher · View at Google Scholar
  4. C. P. Liu, T. K. Lin, Y. H. Chang et al., “Performance of a single-phase DC brushless motor utilizing the ferromagnetic base material,” Journal of Magnetism and Magnetic Materials, vol. 209, no. 1–3, pp. 176–179, 2000. View at Publisher · View at Google Scholar · View at Scopus
  5. B. Singh and S. Singh, “State of the art on permanent magnet brushless DC motor drives,” Journal of Power Electronics, vol. 9, no. 1, pp. 1–17, 2009. View at Google Scholar · View at Scopus
  6. H. B. Ertan, B. Daǧ, and G.-A. Capolino, “Calculation of parameters of single-phase PM motor for design optimization,” IEEE Transactions on Energy Conversion, vol. 20, no. 3, pp. 538–548, 2005. View at Publisher · View at Google Scholar · View at Scopus
  7. M. Norhisam, K. Alias, R. N. Firdaus, S. Mahmod, N. Mariun, and J. Abdul Razak, “Comparison on thrust characteristic of linear oscillatory actuators,” in Proceedings of the IEEE International Conference on Power and Energy, pp. 470–475, Kuala Lumpur, Malaysia, November 2006. View at Publisher · View at Google Scholar · View at Scopus
  8. R. N. Firdaus, M. Norhisam, N. Mariun, I. Aris, M. Nirei, and H. Wakiwaka, “Torque characteristics of single phase brushless dc permanent magnet motor,” Journal of the Japan Society of Applied Electromagnetic and Mechanics, vol. 19, pp. S95–S98, 2011. View at Google Scholar
  9. C. C. Hwang, C. M. Chang, S. P. Cheng, C. K. Chan, C. T. Pan, and T. Y. Chang, “Comparison of performances between IPM and SPM motors with rotor eccentricity,” Journal of Magnetism and Magnetic Materials, vol. 282, no. 1–3, pp. 360–363, 2004. View at Publisher · View at Google Scholar · View at Scopus
  10. T. J. Kim, S. M. Hwang, K. T. Kim, W. B. Jung, and C. U. Kim, “Comparison of dynamic responses for IPM and SPM motors by considering mechanical and magnetic coupling,” IEEE Transactions on Magnetics, vol. 37, no. 4, pp. 2818–2820, 2001. View at Publisher · View at Google Scholar · View at Scopus
  11. C. Feng, X. Jing, G. Bin, C. Shukang, and Z. Jiange, “Double-stator permanent magnet synchronous in-wheel motor for hybrid electric drive system,” IEEE Transactions on Magnetics, vol. 45, no. 1, pp. 278–281, 2009. View at Publisher · View at Google Scholar · View at Scopus
  12. Y. Wang, M. Cheng, M. Chen, Y. Du, and K. T. Chau, “Design of high torque density double stator permanent brushless motors,” IEEE Transactions on Magnetics, vol. 5, no. 3, 313 pages, 2010. View at Google Scholar
  13. S. Niu, K. T. Chau, J. Li, and W. Li, “Eddy-current analysis of double-stator inset-type permanent magnet brushless machines,” IEEE Transactions on Applied Superconductivity, vol. 20, no. 3, pp. 1097–1101, 2010. View at Publisher · View at Google Scholar · View at Scopus
  14. M. Norhisam, S. Ridzuan, R. N. Firdaus, C. V. Aravind, H. Wakiwaka, and M. Nirei, “Comparative evaluation on power speed density of portable permanent magnet generator for agricultural application,” Progress in Electromagnetics Research, vol. 129, pp. 345–363, 2012. View at Google Scholar
  15. M. Norhisam, M. Norafiza, M. Shafiq et al., “Design and analysis of slot type embedded permanent magnet generator,” Journal of Industrial Technology, vol. 18, no. 1, pp. 1–14, 2009. View at Google Scholar
  16. G. H. Kang, J. Hur, H. G. Sung, and J. P. Hong, “Optimal design of spoke type bldc motor considering irreversible demagnetization of permanent magnet,” in Proceedings of the 6th International Conference on Electrical Machines and Systems, pp. 234–237, 2003.
  17. D. Lin, P. Zhou, and Z. J. Cendes, “Analytical prediction of cogging torque in spoke type permanent magnet motors,” in Proceedings of the International Conference on Electrical Machines, pp. 1–5, September 2008. View at Publisher · View at Google Scholar · View at Scopus
  18. K. Boughrara, R. Ibtiouen, and T. Lubin, “Analytical prediction of magnetic field in parallel double excitation and spoke-type permanent-magnet machines accounting for tooth-tips and shape of polar pieces,” IEEE Transactions on Magnetics, vol. 48, no. 7, pp. 2121–2137, 2012. View at Google Scholar
  19. S. Ahmed and P. Lefley, “Study of the impact of asymmetrical stator pole arc on the cogging torque for single phase permanent magnet BLDC motor,” in Proceedings of the International Conference on Electric Power and Energy Conversion Systems, pp. 1–4, November 2009. View at Scopus
  20. S. Ahmed, Investigations into the improvement of a single phase permanent magnet brushless dc motor [Ph.D. thesis], University of Leicester, 2011.
  21. C. V. Aravind, M. Norhisam, I. Aris, M. H. Marhaban, and M. Nirei, “Electromagnetic design and FEM analysis of a novel dual air-gap reluctance Machine,” Progress in Electromagnetic Research, vol. 140, no. 5, pp. 523–544, 2013. View at Google Scholar
  22. C. A. Vaithilingam, M. Norhisam, M. R. Zare, I. Aris, and M. H. Marhaban, “Computation of electromagnetic torque in a double rotor switched reluctance motor using energy methods,” Energies, vol. 5, pp. 4008–4026, 2012. View at Google Scholar
  23. R. N. Firdaus, Improvement of magnetic circuit for development of high torque density single phase brushless DC permanent magnet motor [Ph.D. thesis], University Putra Malaysia, 2013.
  24. A. Kameari, “Local force calculation in 3D FEM with edge elements,” International journal of applied electromagnetics in materials, vol. 3, no. 4, pp. 231–240, 1993. View at Google Scholar · View at Scopus