Table of Contents Author Guidelines Submit a Manuscript
Mathematical Problems in Engineering
Volume 2015, Article ID 249293, 14 pages
http://dx.doi.org/10.1155/2015/249293
Research Article

Networked Fault-Tolerant Control Allocation for Multiple Actuator Failures

1Center for ICT & Automobile Convergence, Kyungpook National University, Daegu 702-701, Republic of Korea
2School of Electronics Engineering, Kyungpook National University, Daegu 702-701, Republic of Korea

Received 3 May 2014; Revised 8 August 2014; Accepted 24 August 2014

Academic Editor: Qingsong Xu

Copyright © 2015 Inseok Yang and Dongik Lee. This is an open access article distributed under the Creative Commons Attribution License, which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited.

Linked References

  1. Z. Gao and P. J. Antsaklis, “Stability of the pseudo-inverse method for reconfigurable control systems,” International Journal of Control, vol. 53, no. 3, pp. 717–729, 1991. View at Publisher · View at Google Scholar · View at Zentralblatt MATH · View at MathSciNet · View at Scopus
  2. K. J. Åström and B. Wittenmark, Adaptive Control, Addison-Wesley, Reading, Mass, USA, 2nd edition, 1995.
  3. I. Yang, Y.-J. Kim, and D. Lee, “Actuator failure diagnosis and accommodation using sliding mode control for submersible vehicle,” Journal of Institute of Control, Robotics and Systems, vol. 16, no. 7, pp. 661–667, 2010. View at Publisher · View at Google Scholar · View at Scopus
  4. J. D. Bošković and R. K. Mehra, “A multiple model-based reconfigurable flight control system design,” in Proceedings of the 37th IEEE Conference on Decision & Control (CDC), pp. 4503–4508, IEEE, Tampa, Fla, USA, December 1998. View at Publisher · View at Google Scholar · View at Scopus
  5. D. Enns, “Control allocation approaches,” in Proceedings of the AIAA Guidance, Navigation and Control Conference and Exhibit, pp. 98–108, 1998.
  6. J. Buffington, P. Chandler, and M. Pachter, “On-line system identification for aircraft with distributed control effectors,” International Journal of Robust and Nonlinear Control, vol. 9, no. 14, pp. 1033–1049, 1999. View at Google Scholar
  7. H. Alwi and C. Edwards, “Fault tolerant control using sliding modes with on-line control allocation,” Automatica, vol. 44, no. 7, pp. 1859–1866, 2008. View at Publisher · View at Google Scholar · View at MathSciNet · View at Scopus
  8. K. Ahmed and T. Didier, “Reconfigurable control design for over-actuated systems based on reliability indicators,” in Proceedings of the Conference on Control and Fault Tolerant Systems, Nice, France, October 2010.
  9. I. Yang, D. Kim, and D. Lee, “Fault-tolerant control strategy based on control allocation using smart actuators,” in Proceedings of the Conference on Control and Fault-Tolerant Systems, pp. 377–381, Nice, France, October 2010. View at Publisher · View at Google Scholar · View at Scopus
  10. I. Yang, D. Kim, and D. Lee, “Fault-Tolerant networked control systems using control allocation for failures in multiple control surfaces,” Journal of Institute of Control, Robotics and Systems, vol. 17, no. 11, pp. 1067–1073, 2011. View at Publisher · View at Google Scholar · View at Scopus
  11. Y. Zhang and J. Jiang, “Bibliographical review on reconfigurable fault-tolerant control systems,” in Proceedings of the 5th IFAC Symposium on Fault Detection, Supervision and Safety for Technical Processes, pp. 265–276, Washington, DC, USA, 2003.
  12. D. Lee, Distributed real-time fault-tolerant control using smart actuators and time-triggered communication [Ph.D. dissertation], Department of Automatic Control and Systems Engineering, Sheffield University, Sheffield, UK, 2002.
  13. C. Kambhampati, R. J. Patton, and F. J. Uppal, “Reconfiguration in networked control systems: fault tolerant control and plug-and-play,” in Proceedings of the 6th IFAC Symposium on Fault Detection, Supervision and Safety of Technical Processes, pp. 151–156, Tsinghua University, Beijing, China, 2006.
  14. J. D. Bošković and R. K. Mehra, “Failure detection, identification and reconfiguration in flight control,” in Fault Diagnosis and Fault Tolerance for Mechatronic Systems: Recent Advances, vol. 1, pp. 129–167, Springer, Berlin, Germany, 2003. View at Publisher · View at Google Scholar
  15. K. W. Iliff and K.-S. C. Wang, “Flight-determined subsonic longitudinal stability and control derivatives of the F-18 High Angle of Attack Research Vehicle (HARV) with thrust vectoring,” Tech. Rep. NASA/TP-97-206539, 1997. View at Google Scholar
  16. J. A. Richard, J. M. Buffington, A. G. Sparks, and S. S. Banda, Robust Multivariable Flight Control, Springer, London, UK, 1994.
  17. J. M. Buffington and D. F. Enns, “Lyapunov stability analysis of daisy chain control allocation,” Journal of Guidance, Control, and Dynamics, vol. 19, no. 6, pp. 1226–1230, 1996. View at Publisher · View at Google Scholar · View at Zentralblatt MATH · View at Scopus
  18. D. Enns, D. Bugajski, R. Hendrick, and G. Stein, “Dynamic inversion: an evolving methodology for flight control design,” International Journal of Control, vol. 59, no. 1, pp. 71–91, 1994. View at Publisher · View at Google Scholar
  19. “Military Standard Flying Qualities of Piloted Aircraft,” Mil-STD-1797A, 1990.