Table of Contents Author Guidelines Submit a Manuscript
Mathematical Problems in Engineering
Volume 2016, Article ID 4280704, 15 pages
http://dx.doi.org/10.1155/2016/4280704
Research Article

Application of Blind Source Separation Algorithms and Ambient Vibration Testing to the Health Monitoring of Concrete Dams

State Key Laboratory Base of Eco-Hydraulic Engineering in Arid Area, Xi’an University of Technology, Xi’an 710048, China

Received 13 August 2016; Revised 5 October 2016; Accepted 20 November 2016

Academic Editor: Yuri Vladimirovich Mikhlin

Copyright © 2016 Lin Cheng and Fei Tong. This is an open access article distributed under the Creative Commons Attribution License, which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited.

Linked References

  1. L. Cheng and D. Zheng, “Two online dam safety monitoring models based on the process of extracting environmental effect,” Advances in Engineering Software, vol. 57, pp. 48–56, 2013. View at Publisher · View at Google Scholar · View at Scopus
  2. H. Sohn, C. R. Farrar, F. M. Hemez et al., A Review of Structural Health Monitoring Literature: 1996–2001, Los Alamos National Laboratory, New Mexico, NM, USA, 2003.
  3. S. W. Doebling, C. R. Farrar, and M. B. Prime, Damage Identification and Health Monitoring of Structural and Mechanical Systems from Changes in their Vibration Characteristics, a Literature Review, Los Alamos National Laboratory, Los Alamos, NM, USA, 1996.
  4. J. Zhao and J. T. DeWolf, “Sensitivity study for vibrational parameters used in damage detection,” Journal of Structural Engineering, vol. 125, no. 4, pp. 410–416, 1999. View at Publisher · View at Google Scholar · View at Scopus
  5. B. Sevim, S. Atamturktur, A. C. Altunişik, and A. Bayraktar, “Ambient vibration testing and seismic behavior of historical arch bridges under near and far fault ground motions,” Bulletin of Earthquake Engineering, vol. 14, no. 1, pp. 241–259, 2016. View at Publisher · View at Google Scholar · View at Scopus
  6. B. Sevim, A. C. Altunişik, and A. Bayraktar, “Earthquake behavior of berke arch dam using ambient vibration test results,” Journal of Performance of Constructed Facilities, vol. 26, no. 6, pp. 780–792, 2012. View at Publisher · View at Google Scholar · View at Scopus
  7. G. R. Darbre, C. A. M. De Smet, and C. Kraemer, “Natural frequencies measured from ambient vibration response of the arch dam of Mauvoisin,” Earthquake Engineering and Structural Dynamics, vol. 29, no. 5, pp. 577–586, 2000. View at Publisher · View at Google Scholar · View at Scopus
  8. C.-H. Loh and T.-S. Wu, “Identification of Fei-Tsui arch dam from both ambient and seismic response data,” Soil Dynamics and Earthquake Engineering, vol. 15, no. 7, pp. 465–483, 1996. View at Publisher · View at Google Scholar · View at Scopus
  9. E. P. Carden and P. Fanning, “Vibration based condition monitoring: a review,” Structural Health Monitoring, vol. 3, no. 4, pp. 355–377, 2004. View at Publisher · View at Google Scholar · View at Scopus
  10. N. A. J. Lieven and D. J. Ewins, “Spatial correlation of mode shapes the coordinate modal assurance criterion,” in Proceedings of the 6th International Modal Analysis Conference, vol. 3, pp. 690–695, 1988.
  11. C. Rainieri and G. Fabbrocino, Operational Modal Analysis of Civil Engineering Structures, Springer, Berlin, Germany, 2014.
  12. L. Cheng and D. Zheng, “The identification of a dam's modal parameters under random support excitation based on the Hankel matrix joint approximate diagonalization technique,” Mechanical Systems and Signal Processing, vol. 42, no. 1-2, pp. 42–57, 2014. View at Publisher · View at Google Scholar · View at Scopus
  13. F. J. Cara, J. Juan, E. Alarcón, E. Reynders, and G. De Roeck, “Modal contribution and state space order selection in operational modal analysis,” Mechanical Systems and Signal Processing, vol. 38, no. 2, pp. 276–298, 2013. View at Publisher · View at Google Scholar · View at Scopus
  14. P. Van Overschee and B. De Moor, Subspace Identification for Linear Systems: Theory-Implementation-Applications, Kluwer Academic Publishers, Dordrecht, The Netherlands, 1996. View at Publisher · View at Google Scholar · View at MathSciNet
  15. H. Sohn, M. Dzwonczyk, E. G. Straser, A. S. Kiremidjian, K. Law, and T. Meng, “An experimental study of temperature effect on modal parameters of the Alamosa Canyon Bridge,” Earthquake Engineering and Structural Dynamics, vol. 28, no. 8, pp. 879–897, 1999. View at Publisher · View at Google Scholar · View at Scopus
  16. A.-M. Yan, G. Kerschen, P. De Boe, and J.-C. Golinval, “Structural damage diagnosis under varying environmental conditions—part I: a linear analysis,” Mechanical Systems and Signal Processing, vol. 19, no. 4, pp. 847–864, 2005. View at Publisher · View at Google Scholar · View at Scopus
  17. A. Deraemaeker, E. Reynders, G. De Roeck, and J. Kullaa, “Vibration-based structural health monitoring using output-only measurements under changing environment,” Mechanical Systems and Signal Processing, vol. 22, no. 1, pp. 34–56, 2008. View at Publisher · View at Google Scholar · View at Scopus
  18. Y. Q. Ni, X. G. Hua, K. Q. Fan, and J. M. Ko, “Correlating modal properties with temperature using long-term monitoring data and support vector machine technique,” Engineering Structures, vol. 27, no. 12, pp. 1762–1773, 2005. View at Publisher · View at Google Scholar · View at Scopus
  19. L. Cheng, J. Yang, D. Zheng, B. Li, and J. Ren, “The health monitoring method of concrete dams based on ambient vibration testing and kernel principle analysis,” Shock and Vibration, vol. 2015, Article ID 342358, 11 pages, 2015. View at Publisher · View at Google Scholar · View at Scopus
  20. J. Wang, Y. Zhang, H. Cao, and W. Zhu, “Dimension reduction method of independent component analysis for process monitoring based on minimum mean square error,” Journal of Process Control, vol. 22, no. 2, pp. 477–487, 2012. View at Publisher · View at Google Scholar · View at Scopus
  21. L. Cai and X. Tian, “A new fault detection method for non-Gaussian process based on robust independent component analysis,” Process Safety and Environmental Protection, vol. 92, no. 6, pp. 645–658, 2013. View at Publisher · View at Google Scholar · View at Scopus
  22. L. F. Cai and X. M. Tian, “A new process monitoring method based on noisy time structure independent component analysis,” Chinese Journal of Chemical Engineering, vol. 23, no. 1, pp. 162–172, 2015. View at Publisher · View at Google Scholar · View at Scopus
  23. S. I. McNeill, “An analytic formulation for blind modal identification,” Journal of Vibration and Control, vol. 18, no. 14, pp. 2111–2121, 2012. View at Publisher · View at Google Scholar · View at Scopus
  24. G. Kerschen, F. Poncelet, and J.-C. Golinval, “Physical interpretation of independent component analysis in structural dynamics,” Mechanical Systems and Signal Processing, vol. 21, no. 4, pp. 1561–1575, 2007. View at Publisher · View at Google Scholar · View at Scopus
  25. A. Belouchrani, K. Abed-Meraim, J.-F. Cardoso, and E. Moulines, “A blind source separation technique using second-order statistics,” IEEE Transactions on Signal Processing, vol. 45, no. 2, pp. 434–444, 1997. View at Publisher · View at Google Scholar · View at Scopus
  26. C. Rainieri, “Perspectives of second-order blind identification for operational modal analysis of civil structures,” Shock and Vibration, vol. 2014, Article ID 845106, 9 pages, 2014. View at Publisher · View at Google Scholar · View at Scopus
  27. J.-F. Cardoso and A. Souloumiac, “Jacobi angles for simultaneous diagonalization,” SIAM Journal on Matrix Analysis and Applications, vol. 17, no. 1, pp. 161–164, 1996. View at Publisher · View at Google Scholar · View at MathSciNet · View at Scopus
  28. S. W. Choi, C. Lee, J.-M. Lee, J. H. Park, and I.-B. Lee, “Fault detection and identification of nonlinear processes based on kernel PCA,” Chemometrics and Intelligent Laboratory Systems, vol. 75, no. 1, pp. 55–67, 2005. View at Publisher · View at Google Scholar · View at Scopus
  29. A. Hyvärinen, “Fast and robust fixed-point algorithms for independent component analysis,” IEEE Transactions on Neural Networks, vol. 10, no. 3, pp. 626–634, 1999. View at Publisher · View at Google Scholar · View at Scopus
  30. E. B. Martin and A. J. Morris, “Non-parametric confidence bounds for process performance monitoring charts,” Journal of Process Control, vol. 6, no. 6, pp. 349–358, 1996. View at Publisher · View at Google Scholar · View at Scopus
  31. P. Miller, R. E. Swanson, and C. E. Heckler, “Contribution plots: a missing link in multivariate quality control,” Applied Mathematics and Computer Science, vol. 8, no. 4, pp. 775–792, 1998. View at Google Scholar · View at MathSciNet
  32. MSC. Marc Vol. A: Theory and User Information, MSC. Software Corporation, Santa Ana, Calif, USA, 2005.