Table of Contents Author Guidelines Submit a Manuscript
Mathematical Problems in Engineering
Volume 2017, Article ID 5867101, 15 pages
https://doi.org/10.1155/2017/5867101
Research Article

Performance Improvement of a Micro Impulse Water Turbine Based on Orthogonal Array

Research Center of Fluid Machinery Engineering and Technology, Jiangsu University, Zhenjiang 212013, China

Correspondence should be addressed to Lingdi Tang; moc.361@dlttalegna

Received 14 May 2017; Accepted 2 November 2017; Published 7 December 2017

Academic Editor: Jian G. Zhou

Copyright © 2017 Lingdi Tang et al. This is an open access article distributed under the Creative Commons Attribution License, which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited.

Linked References

  1. P. Bansal and N. Marshall, “Feasibility of hydraulic power recovery from waste energy in bio-gas scrubbing processes,” Applied Energy, vol. 87, no. 3, pp. 1048–1053, 2010. View at Publisher · View at Google Scholar · View at Scopus
  2. S. Mirza, “Reduction of energy consumption in process plants using nanofiltration and reverse osmosis,” Desalination, vol. 224, no. 1-3, pp. 132–142, 2008. View at Publisher · View at Google Scholar · View at Scopus
  3. H. J. Van Antwerpen and G. P. Greyvenstein, “Use of turbines for simultaneous pressure regulation and recovery in secondary cooling water systems in deep mines,” Energy Conversion and Management, vol. 46, no. 4, pp. 563–575, 2005. View at Publisher · View at Google Scholar · View at Scopus
  4. Y. Junhu, Z. Xuening, Wang X. et al., “Progress in energy recovery hydraulic turbine research,” Chemical Machinery, vol. 38, no. 6, pp. 655–658, 2011. View at Google Scholar
  5. L. Yanpin, N. Haipeng, and C. Dexin, “Performance and type selection of special hydraulic turbine in cooling tower,” Journal of Hydroelectric Engineering, vol. 30, no. 1, pp. 175–179, 2011. View at Google Scholar · View at Scopus
  6. L. Yanpin, K. Wang, N. Haipeng et al., “Nan Haipeng, , The approximate calculation of the flow capacity of special turbine in cooling tower,” Journal of Xian University of Technology, vol. 27, no. 1, pp. 79–82, 2011. View at Google Scholar
  7. Z. Lanjin, C. Dexin, R. Yan et al., “Hydraulic loss analysis of the micro francis turbine of cooling towers,” Journal of North China Institute of Water Conservancy and Hydroelectric Power, vol. 33, no. 1, p. 1, 2012. View at Google Scholar
  8. Z. Lanjin, L. Yang, C. Dexin et al., “Saved-energy analysis of francis turbine on hydraulic cooling tower,” Renewable Energy Resources, vol. 30, no. 7, pp. 123–128, 2012. View at Google Scholar
  9. Z. Fei, Y. Zheng, F. Xiaojuan et al., “Design and numerical simulation of small francis turbine used in cooling tower,” Water Resources and Power, vol. 31, no. 7, pp. 165–168, 2013 (Chinese). View at Google Scholar
  10. Z. Kaining, L. Li, and X. Kaige, “Hydraulic design and numerical simulation of super low specific speed francis turbine runner,” Energy Engineering, vol. 4, pp. 6–9, 2012. View at Google Scholar
  11. L. Zhang, Y. Zheng, C. Zhang, Y. Yin, and J. Liu, “Study on Francis turbine with super-low specific speed applied in cooling towers,” Transactions of the Chinese Society of Agricultural Machinery, vol. 41, no. 1, pp. 39–72, 2010. View at Publisher · View at Google Scholar · View at Scopus
  12. Y. Tang, Z. Xiangyuan, M. Xingxin et al., “performance test of water turbine of JP50 reel sprinkler,” China Rural Water and Hydropower, vol. 2, pp. 26–29, 2014. View at Google Scholar
  13. Y. Shouqi, N. Guoping, T. Yue et al., “Experiment and numerical estimation of performance of hydraulic turbine of JP50 reel sprinkle,” Journal of Drainage and Irrigation Machinery Engineering, vol. 32, no. 7, pp. 553–562, 2014. View at Publisher · View at Google Scholar · View at Scopus
  14. J. Jun, T. Yue, and L. Tang, “Energy consumption analysis of hydraulic turbine of JP75 hose reel irrigator,” Journal of Drainage and Irrigation Machinery Engineering, vol. 34, no. 11, pp. 1008–1012, 2016. View at Publisher · View at Google Scholar · View at Scopus
  15. J. Chen, H. X. Yang, C. P. Liu, C. H. Lau, and M. Lo, “A novel vertical axis water turbine for power generation from water pipelines,” Energy, vol. 54, pp. 184–193, 2013. View at Publisher · View at Google Scholar · View at Scopus
  16. S. Wang, C. F. Porres, M. Zuo et al., “Study of impeller design for pipe flow generator with CFD and RP,” in Proceedings of the 10th Asian International Conference on Fluid Machinery, pp. 265–275, Kuala Lumpur, Malaysia, 2010. View at Publisher · View at Google Scholar
  17. S. Wang and R. Doblado, “Computational and experimental study of a coaxial pipe flow generator,” International Symposium on Computer, vol. 132, no. 42, pp. 435–439. View at Publisher · View at Google Scholar · View at Scopus
  18. L. Song, H.-Z. Liu, and Z.-X. Yang, “Orthogonal analysis based performance optimization for vertical axis wind turbine,” Mathematical Problems in Engineering, vol. 2016, Article ID 6241360, 11 pages, 2016. View at Publisher · View at Google Scholar · View at Scopus
  19. J. H. Yang and S. C. Miao, “Numerical simulation and orthogonal design method research effect of splitter blade's main geometry factors on the performance of pump as turbine,” Applied Mechanics and Materials, vol. 456, pp. 100–105, 2014. View at Publisher · View at Google Scholar · View at Scopus
  20. K.-K. Lee, K.-H. Lee, and S.-H. Han, “Use of an orthogonal array based on the Kriging model to maximize the fatigue life of a turbine blade,” International Journal of Structural Integrity, vol. 2, no. 3, pp. 303–313, 2011. View at Publisher · View at Google Scholar · View at Scopus
  21. J. Tang, G. Gong, H. Su, F. Wu, and C. Herman, “Performance evaluation of a novel method of frost prevention and retardation for air source heat pumps using the orthogonal experiment design method,” Applied Energy, vol. 169, pp. 696–708, 2016. View at Publisher · View at Google Scholar · View at Scopus
  22. Z. Li and O. P. Malik, “An orthogonal test approach based control parameter optimization and its application to a hydro-turbine governor,” IEEE Transactions on Energy Conversion, vol. 12, no. 4, pp. 388–393, 1997. View at Publisher · View at Google Scholar · View at Scopus
  23. J. S. Liu, J. L. Cheng, and Y. Gong, “Study on optimal scheduling methods of urban drainage pumping stations based on orthogonal test,” Applied Mechanics and Materials, vol. 373-375, pp. 2169–2174, 2013. View at Publisher · View at Google Scholar · View at Scopus
  24. F. R. Menter, “Review of the shear-stress transport turbulence model experience from an industrial perspective,” International Journal of Computational Fluid Dynamics, vol. 23, no. 4, pp. 305–316, 2009. View at Publisher · View at Google Scholar · View at Scopus
  25. P. Huang, J. Bardina, and T. Coakley, “Turbulence modeling validation,” in Proceedings of the 28th Fluid Dynamics Conference, Snowmass Village, CO, USA. View at Publisher · View at Google Scholar
  26. I. Korkut and Y. Kucuk, “Experimental analysis of the deviation from circularity of bored hole based on the taguchi method,” Strojniski Vestnik: Journal of Mechanical Engineering, vol. 56, no. 5, pp. 340–346, 2010. View at Google Scholar · View at Scopus