Table of Contents Author Guidelines Submit a Manuscript
Modelling and Simulation in Engineering
Volume 2008, Article ID 798395, 6 pages
http://dx.doi.org/10.1155/2008/798395
Research Article

Chaotic Behavior in a Switched Dynamical System

1Laboratoire Toulousain des Technologies et Ingénierie des Systèmes (LATTIS), INSA, 135 Avenue de Rangueil, 31077 Toulouse Cedex 4, France
2LabSIV-FS, University Ibn Zohr, P. O. Box 28/S, Agadir 80000, Morocco
3ESSI, ENSA, University Ibn Zohr, P. O. Box 1136, Agadir 80000, Morocco

Received 4 September 2007; Revised 1 January 2008; Accepted 6 February 2008

Academic Editor: Igor Kotenko

Copyright © 2008 Fatima El Guezar and Hassane Bouzahir. This is an open access article distributed under the Creative Commons Attribution License, which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited.

Linked References

  1. A. El Aroudi, M. Debbat, R. Giral, G. Olivar, L. Benadero, and E. Toribio, “Bifurcations in DC-DC switching converters: review of methods and applications,” International Journal of Bifurcation and Chaos in Applied Sciences and Engineering, vol. 15, no. 5, pp. 1549–1578, 2005. View at Publisher · View at Google Scholar
  2. R. W. Brockett and J. R. Wood, “Understanding power converter chaotic behavior mechanisms in protective and abnormal modes,” in Proceedings of 11th Annual International Power Electronics Conference (Powercon '84), pp. E-14–E-15, Dallas, Tex, USA, April 1984.
  3. D. C. Hamill and D. J. Jeffries, “Subharmonics and chaos in a controlled switched-mode power converter,” IEEE Transactions on Circuits and Systems, vol. 35, no. 8, pp. 1059–1061, 1988. View at Publisher · View at Google Scholar
  4. C. K. Tse, “Chaos from a buck switching regulator operating in discontinuous mode,” International Journal of Circuit Theory and Applications, vol. 22, no. 4, pp. 263–278, 1994. View at Publisher · View at Google Scholar
  5. C. K. Tse, “Flip bifurcation and chaos in three-state boost switching regulators,” IEEE Transactions on Circuits and Systems I, vol. 41, no. 1, pp. 16–23, 1994. View at Publisher · View at Google Scholar
  6. A. El Aroudi, L. Benadero, E. Toribio, and S. Machiche, “Quasiperiodicty and chaos in the DC-DC buck-boost converter,” International Journal of Bifurcation and Chaos in Applied Sciences and Engineering, vol. 10, no. 2, pp. 359–371, 2000. View at Publisher · View at Google Scholar
  7. A. El Aroudi and R. Leyva, “Quasi-periodic route to chaos in a PWM voltage-controlled DC-DC boost converter,” IEEE Transactions Circuits and Systems I, vol. 48, no. 8, pp. 967–978, 2001. View at Publisher · View at Google Scholar
  8. S. Banerjee, P. Ranjan, and C. Grebogi, “Bifurcations in two-dimensional piecewise smooth maps-theory and applications in switching circuits,” IEEE Transactions on Circuits and Systems I, vol. 47, no. 5, pp. 633–643, 2000. View at Publisher · View at Google Scholar
  9. S. Banerjee, D. Kastha, S. Das, G. Vivek, and C. Grebogi, “Robust chaos-the theoretical formulation and experimental evidence,” in Proceedings of the IEEE International Symposium on Circuits and Systems (ISCAS '99), vol. 5, pp. 293–296, Orlando, Fla, USA, June 1999. View at Publisher · View at Google Scholar
  10. S. L. Campbell, J.-P. Chancelier, and R. Nikoukhah, Modeling and Simulation in Scilab/Scicos, Springer, New York, NY, USA, 2006.
  11. J. H. B. Deane and D. C. Hamill, “Instability, subharmonics, and chaos in power electronic systems,” IEEE Transactions on Power Electronics, vol. 5, no. 3, pp. 260–268, 1990. View at Publisher · View at Google Scholar
  12. M. di Bernardo, F. Garefalo, L. Glielmo, and F. Vasca, “Switching, bifurcations and chaos in DC/DC converters,” IEEE Transactions Circuits and Systems I, vol. 45, no. 2, pp. 133–141, 1998. View at Publisher · View at Google Scholar
  13. C.-C. Fang and E. H. Abed, “Harmonics balance analysis and control of period-doubling bifurcation in buck converters,” in Proceedings of IEEE International Symposium on Circuits and Systems (ISCAS '01), vol. 2, pp. 209–212, Sydney, NSW, Australia, May 2001. View at Publisher · View at Google Scholar
  14. E. Fossas and G. Olivar, “Study of chaos in the buck converter,” IEEE Transactions on Circuits and Systems I, vol. 43, no. 1, pp. 13–25, 1996. View at Publisher · View at Google Scholar
  15. Y. Ma, C. K. Tse, T. Kousaka, and H. Kawakami, “Connecting border collision with saddle-node bifurcation in switched dynamical systems,” IEEE Transactions on Circuits and Systems II, vol. 52, no. 9, pp. 581–585, 2005. View at Publisher · View at Google Scholar
  16. G. Yuan, S. Banerjee, E. Ott, and J. A. Yorke, “Border-collision bifurcations in the buck converter,” IEEE Transactions on Circuits and Systems I, vol. 45, no. 7, pp. 707–716, 1998. View at Publisher · View at Google Scholar
  17. R. Nikoukhah, “Scicos: a dynamic systems modeler and simulator,” in Proceedings of the 23rd IASTED International Conference on Modelling, Identification, and Control (MIC '04), pp. 263–268, Grindelwald, Switzerland, February 2004, paper 412–133.
  18. R. Nikoukhah, “Modeling hybrid systems in scicos: a case study,” in Proceedings of the 25th IASTED International Conference on Modeling, Indentification, and Control (MIC '06), pp. 315–319, Lanzarote, Spain, February 2006, paper 500–082.
  19. S. Pettersson and B. Lennartson, “Stability and robustness for hybrid systems,” in Proceedings of the 35th IEEE Conference on Decision and Control (CDC '96), vol. 2, pp. 1202–1207, Kobe, Japan, December 1996. View at Publisher · View at Google Scholar