Table of Contents Author Guidelines Submit a Manuscript
Modelling and Simulation in Engineering
Volume 2014 (2014), Article ID 376781, 13 pages
http://dx.doi.org/10.1155/2014/376781
Research Article

Dynamic Modeling and Simulation of a Thermoelectric-Solar Hybrid Energy System Using an Inverse Dynamic Analysis Input Shaper

Department of Electrical, Electronic and Systems Engineering, Faculty of Engineering and Built Environment, Universiti Kebangsaan Malaysia (UKM), 43600 Bangi, Selangor, Malaysia

Received 8 February 2014; Accepted 27 May 2014; Published 24 June 2014

Academic Editor: Mingcong Deng

Copyright © 2014 A. M. Yusop et al. This is an open access article distributed under the Creative Commons Attribution License, which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited.

Linked References

  1. N. Smith and R. McCann, “Investigation of a multiple input converter for grid connected thermoelectric-photovoltaic hybrid system,” in Proceedings of the IEEE Green Technologies Conference, April 2012. View at Publisher · View at Google Scholar · View at Scopus
  2. A. R. Jha, Solar Cell Technology and Applications, CRC Press, 2009.
  3. S. Odeh and M. Behnia, “Improving photovoltaic module efficiency using water cooling,” Heat Transfer Engineering, vol. 30, no. 6, pp. 499–505, 2009. View at Publisher · View at Google Scholar · View at Scopus
  4. N. Q. Nguyen and K. V. Pochiraju, “Behavior of thermoelectric generators exposed to transient heat sources,” Applied Thermal Engineering, vol. 51, no. 1-2, pp. 1–9, 2013. View at Publisher · View at Google Scholar · View at Scopus
  5. X. Zhang and K. T. Chau, “Design and implementation of a new thermoelectric-photovoltaic hybrid energy system for hybrid electric vehicles,” Electric Power Components and Systems, vol. 39, no. 6, pp. 511–525, 2011. View at Publisher · View at Google Scholar · View at Scopus
  6. M. M. M. Daud, N. B. M. Nor, and T. Ibrahim, “Novel hybrid photovoltaic and thermoelectric panel,” in Proceedings of the IEEE International Power Engineering and Optimization Conference (PEOCO '12), pp. 269–274, Melaka, Malaysia, June 2012. View at Publisher · View at Google Scholar · View at Scopus
  7. D. Yang and H. Yin, “Energy conversion efficiency of a novel hybrid solar system for photovoltaic, thermoelectric, and heat utilization,” IEEE Transactions on Energy Conversion, vol. 26, no. 2, pp. 662–670, 2011. View at Publisher · View at Google Scholar · View at Scopus
  8. M. N. Sahinkaya, “Input shaping for vibration-free positioning of flexible systems,” Proceedings of the Institution of Mechanical Engineers: Journal of Systems and Control Engineering, vol. 215, no. 5, pp. 467–481, 2001. View at Publisher · View at Google Scholar · View at Scopus
  9. M. N. Sahinkaya, “Inverse dynamic analysis of multiphysics systems,” Proceedings of the Institution of Mechanical Engineers: Journal of Systems and Control Engineering, vol. 218, no. 1, pp. 13–26, 2004. View at Google Scholar · View at Scopus
  10. S. Devasia, “Time-optimal control with pre/post actuation for dual-stage systems,” IEEE Transactions on Control Systems Technology, vol. 20, no. 2, pp. 323–334, 2012. View at Publisher · View at Google Scholar · View at Scopus
  11. P. Häuptle, P. Hubinský, and G. Gruhler, “Harmonic modulated feedback in control to lower oscillations in mechatronic systems,” in Proceedings of the 11th International Conference on Control, Automation and Systems (ICCAS '11), pp. 273–276, IEEE, October 2011. View at Scopus
  12. M. Rahimi and M. B. Ghaznavi-Ghoushchi, “Improvement of timing specifications in second order electronic systems using programmable CMOS Posicast pulse shapers,” in Proceedings of the 20th Iranian Conference on Electrical Engineering (ICEE '12), pp. 309–313, May 2012. View at Publisher · View at Google Scholar · View at Scopus
  13. S. Garrido, M. Abderrahim, A. Giménez, R. Diez, and C. Balaguer, “Anti-swinging input shaping control of an automatic construction crane,” IEEE Transactions on Automation Science and Engineering, vol. 5, no. 3, pp. 549–557, 2008. View at Publisher · View at Google Scholar · View at Scopus
  14. J. R. Huey and W. Singhose, “Design of proportional-derivative feedback and input shaping for control of inertia plants,” IET Control Theory & Applications, vol. 6, no. 3, pp. 357–364, 2012. View at Publisher · View at Google Scholar · View at Scopus
  15. C. La-orpacharapan and L. Y. Pao, “Fast and robust control of systems with multiple flexible modes,” IEEE/ASME Transactions on Mechatronics, vol. 10, no. 5, pp. 521–534, 2005. View at Publisher · View at Google Scholar · View at Scopus
  16. W. E. Singhose, L. J. Porter, T. D. Tuttle, and N. C. Singer, “Vibration reduction using multi-hump input shapers,” Journal of Dynamic Systems, Measurement and Control, Transactions of the ASME, vol. 119, no. 2, pp. 320–326, 1997. View at Google Scholar · View at Scopus
  17. S. S. Gürleyük, Ö. Bahadir, Y. Türkkan, and H. Üsenti, “Improved three-step input shaping control of crane system,” WSEAS Transactions on Systems, vol. 7, no. 6, pp. 652–661, 2008. View at Google Scholar
  18. A. Piazzi and A. Visioli, “Minimum-time system-inversion-based motion planning for residual vibration reduction,” IEEE/ASME Transactions on Mechatronics, vol. 5, no. 1, pp. 12–22, 2000. View at Publisher · View at Google Scholar · View at Scopus
  19. P. Iravani and M. N. Sahinkaya, “Variable-velocity exponential input shaping for position controlled robotic systems,” in Proceedings of the 3rd Annual Dynamic Systems and Control Conference (DSCC '10), pp. 345–351, University of Bath, September 2010. View at Scopus
  20. X. Zhao, L. Zhang, and P. Shi, “Stability of a class of switched positive linear time-delay systems,” International Journal of Robust and Nonlinear Control, vol. 23, no. 5, pp. 578–589, 2013. View at Publisher · View at Google Scholar · View at Scopus
  21. X. Zhao, X. Liu, S. Yin, and H. Li, “Improved results on stability of continuous-time switched positive linear systems,” Automatica, vol. 50, no. 2, pp. 614–621, 2014. View at Publisher · View at Google Scholar
  22. Z. Xudong, Z. Lixian, S. Peng, and H. R. Karimi, “Robust control of continuous-time systems with state-dependent uncertainties and its application to electronic circuits,” IEEE Transactions on Industrial Electronics, vol. 61, no. 8, pp. 4161–4170, 2014. View at Publisher · View at Google Scholar
  23. R. Guo, P. Zhao, and C. Zhang, “Input-to-state stability for a class of switched stochastic nonlinear systems by an improved average dwell time method,” Mathematical Problems in Engineering, vol. 2014, Article ID 154679, 8 pages, 2014. View at Publisher · View at Google Scholar
  24. M. S. Branicky, “Multiple Lyapunov functions and other analysis tools for switched and hybrid systems,” IEEE Transactions on Automatic Control, vol. 43, no. 4, pp. 475–482, 1998. View at Publisher · View at Google Scholar · View at Scopus
  25. W. Ni, D. Cheng, and X. Hu, “Minimum dwell time for stability and stabilization of switched linear systems,” in Proceedings of the 7th World Congress on Intelligent Control and Automation (WCICA '08), pp. 4103–4108, IEEE, June 2008. View at Publisher · View at Google Scholar · View at Scopus
  26. Z. Rymansaib, P. Iravani, and M. N. Sahinkaya, “Exponential trajectory generation for point to point motions,” in Proceedings of the IEEE/ASME International Conference on Advanced Intelligent Mechatronics (AIM '13), 2013.
  27. H.-L. Tsai and J.-M. Lin, “Model building and simulation of thermoelectric module using Matlab/Simulink,” Journal of Electronic Materials, vol. 39, no. 9, pp. 2105–2111, 2010. View at Publisher · View at Google Scholar · View at Scopus
  28. N. Pandiarajan, R. Ramaprabha, and R. Muthu, “Application of circuit model for photovoltaic energy conversion system,” International Journal of Photoenergy, vol. 2012, Article ID 410401, 14 pages, 2012. View at Publisher · View at Google Scholar · View at Scopus
  29. S.S. Mohammed, “Modeling and simulation of photovoltaic module using MATLAB/Simulink,” International Journal of Chemical and Environmental Engineering, vol. 2, no. 5, pp. 350–355, 2011. View at Google Scholar
  30. E. W. Weisstein, “Fourier Series—Sawtooth Wave,” MathWorld—A Wolfram Web Resource, 1999, http://mathworld.wolfram.com/FourierSeriesSawtoothWave.html.
  31. H.-L. Tsai, C.-S. Tu, and Y.-J. Su, “Development of generalized photovoltaic model using MATLAB/SIMULINK,” in Proceedings of the World Congress on Engineering and Computer Science, 2008.