Table of Contents Author Guidelines Submit a Manuscript
Shock and Vibration
Volume 2017, Article ID 6085941, 15 pages
https://doi.org/10.1155/2017/6085941
Research Article

Surrounding Rock Deformation Mechanism and Control Technology for Gob-Side Entry Retaining with Fully Mechanized Gangue Backfilling Mining: A Case Study

1State Key Laboratory for Geomechanics and Deep Underground Engineering, School of Mechanics and Civil Engineering, School of Science, China University of Mining & Technology, Xuzhou, Jiangsu 221116, China
2Department of Mechanical Engineering, Colorado School of Mines, Golden, CO 80401, USA

Correspondence should be addressed to Zhanguo Ma; nc.ude.tmuc@amgz

Received 17 December 2016; Accepted 7 March 2017; Published 14 May 2017

Academic Editor: Yuri S. Karinski

Copyright © 2017 Peng Gong et al. This is an open access article distributed under the Creative Commons Attribution License, which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited.

Linked References

  1. H. Yang, S. Cao, S. Wang, Y. Fan, S. Wang, and X. Chen, “Adaptation assessment of gob-side entry retaining based on geological factors,” Engineering Geology, vol. 209, pp. 143–151, 2016. View at Publisher · View at Google Scholar · View at Scopus
  2. J.-H. Xue and C.-L. Han, “Strata behavior and control countermeasures for the gob-side entry retaining in the condition of large mining height,” Journal of Mining & Safety Engineering, vol. 29, no. 4, pp. 466–473, 2012. View at Google Scholar · View at Scopus
  3. X. He and L. Song, “Status and future tasks of coal mining safety in China,” Safety Science, vol. 50, no. 4, pp. 894–898, 2012. View at Publisher · View at Google Scholar · View at Scopus
  4. G. Vižintin, M. Kocjančič, and M. Vulić, “Study of coal burst source locations in the velenje colliery,” Energies, vol. 9, no. 7, p. 507, 2016. View at Publisher · View at Google Scholar
  5. Y. Qin, W. Liu, C. Yang, Z. Fan, L. Wang, and G. Jia, “Experimental study on oxygen consumption rate of residual coal in goaf,” Safety Science, vol. 50, no. 4, pp. 787–791, 2012. View at Publisher · View at Google Scholar · View at Scopus
  6. J. Ning, P. Ma, X. Liu, J. Zhao, and W. Liu, “Supporting mechanism of ‘yielding-supporting’ beside roadway maintained along the goaf under hard rocks,” Journal of Mining & Safety Engineering, vol. 30, no. 3, pp. 369–374, 2013. View at Google Scholar · View at Scopus
  7. D. Zhang, X. Miao, and X. Mao, “Simulation on roof activities of gob-side entry retaining in fully-mechanized top-coal caving faces,” Journal of China University of Mining & Technology, vol. 30, no. 3, pp. 47–50, 2001. View at Google Scholar
  8. Y. Lu, S. Zuo, Z. Ge, S. Xiao, and Y. Cheng, “Experimental study of crack initiation and extension induced by hydraulic fracturing in a tree-type borehole array,” Energies, vol. 9, no. 7, article 514, 2016. View at Publisher · View at Google Scholar · View at Scopus
  9. Y. Lu, Y. Cheng, Z. Ge, L. Cheng, S. Zuo, and J. Zhong, “Determination of fracture initiation locations during cross-measure drilling for hydraulic fracturing of coal seams,” Energies, vol. 9, no. 5, article 358, 2016. View at Publisher · View at Google Scholar
  10. Z. Zhang, J. Bai, Y. Chen, and S. Yan, “An innovative approach for gob-side entry retaining in highly gassy fully-mechanized longwall top-coal caving,” International Journal of Rock Mechanics and Mining Sciences, vol. 80, pp. 1–11, 2015. View at Publisher · View at Google Scholar · View at Scopus
  11. J. Bai, H. Zhou, C. Hou, X. Tu, and D. Yue, “Development of support technology beside roadway in goal-side entry retaining for next sublevel,” Journal of China University of Mining & Technology, vol. 33, no. 2, pp. 59–62, 2004. View at Google Scholar
  12. C.-L. Han, N. Zhang, G.-C. Li, B.-Y. Li, and H. Wu, “Stability analysis of compound bearing structure of gob-side entry retaining with large mining height,” Chinese Journal of Geotechnical Engineering, vol. 36, no. 5, pp. 969–976, 2014. View at Publisher · View at Google Scholar · View at Scopus
  13. Y. Li and X. Hua, “Mechanical analysis of stability of key blocks of overlying strata for gob-side entry retaining and calculating width of roadside backfill,” Rock and Soil Mechanics, vol. 33, no. 4, pp. 1134–1140, 2012. View at Google Scholar · View at Scopus
  14. Y. Chen, J. Bai, X. Wang et al., “Support technology research and application inside roadway of gob-side entry retaining,” Journal of the China Coal Society, vol. 37, no. 6, pp. 903–910, 2012. View at Google Scholar · View at Scopus
  15. B. Jiang, L. Wang, Y. Lu, S. Gu, and X. Sun, “Failure mechanism analysis and support design for deep composite soft rock roadway: a case study of the yangcheng coal mine in China,” Shock and Vibration, vol. 2015, Article ID 452479, 14 pages, 2015. View at Publisher · View at Google Scholar · View at Scopus
  16. X. Sun, X. Liu, G. Liang, D. Wang, and Y. Jiang, “Key parameters of gob-side entry retaining formed by roof cut and pressure releasing in thin coal seams,” Chinese Journal of Rock Mechanics and Engineering, vol. 33, no. 7, pp. 1449–1456, 2014. View at Google Scholar · View at Scopus
  17. M. Rezaei, M. F. Hossaini, and A. Majdi, “Determination of longwall mining-induced stress using the strain energy method,” Rock Mechanics and Rock Engineering, vol. 48, no. 6, pp. 2421–2433, 2015. View at Publisher · View at Google Scholar · View at Scopus
  18. H. Yang, S. Cao, Y. Li, C. Sun, and P. Guo, “Soft roof failure mechanism and supporting method for gob-side entry retaining,” Minerals, vol. 5, no. 4, pp. 707–722, 2015. View at Publisher · View at Google Scholar · View at Scopus
  19. H. Li, D. Jiang, and D. Li, “Analysis of ground pressure and roof movement in fully-mechanized top coal caving with large mining height in ultra-thick seam,” Journal of the China Coal Society, vol. 39, no. 10, pp. 1956–1960, 2014. View at Publisher · View at Google Scholar · View at Scopus
  20. S.-R. Xie, G.-C. Zhang, S.-S. He et al., “Surrounding rock control mechanism and its application of gob-side retaining entry in deep backfilling with large mining height,” Journal of the China Coal Society, vol. 39, no. 12, pp. 2362–2368, 2014. View at Publisher · View at Google Scholar · View at Scopus
  21. X. Feng, N. Zhang, L. Gong, F. Xue, and X. Zheng, “Application of a backfilling method in coal mining to realise an ecologically sensitive ‘black gold’ industry,” Energies, vol. 8, no. 5, pp. 3628–3639, 2015. View at Publisher · View at Google Scholar · View at Scopus
  22. Z. Ma, R. Gu, Z. Huang, G. Peng, L. Zhang, and D. Ma, “Experimental study on creep behavior of saturated disaggregated sandstone,” International Journal of Rock Mechanics and Mining Sciences, vol. 66, pp. 76–83, 2014. View at Publisher · View at Google Scholar · View at Scopus
  23. Y. Wu, “Effectiveness and development direction of filling mining technology in China's coal mines,” China Coal, vol. 38, no. 6, pp. 5–10, 2012. View at Google Scholar
  24. X. Miao and J. Zhang, “Analysis of strata behavior in the process of coal mining by gangue backfilling,” Journal of Mining & Safety Engineering, vol. 24, no. 4, pp. 379–382, 2007. View at Google Scholar
  25. H. Li, “Optimum of support parameter of soft-rock roadway and engineer practice,” Chinese Journal of Rock Mechanics and Engineering, vol. 19, no. 5, pp. 651–654, 2000. View at Google Scholar
  26. S. Jeon, J. Kim, Y. Seo, and C. Hong, “Effect of a fault and weak plane on the stability of a tunnel in rock—a scaled model test and numerical analysis,” International Journal of Rock Mechanics & Mining Sciences, vol. 41, no. 1, pp. 658–663, 2004. View at Publisher · View at Google Scholar · View at Scopus
  27. D. N. Chapman, S. K. Ahn, D. V. L. Hunt, and A. H. C. Chan, “The use of model tests to investigate the ground displacement associated with multiple tunnel construction in soil,” Tunnelling & Underground Space Technology, vol. 21, no. 3, p. 413, 2006. View at Google Scholar
  28. F. Huang, H. Zhu, Q. Xu, Y. Cai, and X. Zhuang, “The effect of weak interlayer on the failure pattern of rock mass around tunnel—scaled model tests and numerical analysis,” Tunnelling & Underground Space Technology, vol. 35, pp. 207–218, 2013. View at Publisher · View at Google Scholar · View at Scopus
  29. J. Dong, J. Yang, G. Yang, F. Wu, and H. Liu, “Research on similar material proportioning test of model test based on orthogonal design,” Journal of the China Coal Society, vol. 37, no. 1, pp. 44–49, 2012. View at Google Scholar · View at Scopus
  30. S. Chen, H. Wang, J. Zhang, H. Xing, and H. Wang, “Low-strength similar materials for backfill mining: insight from experiments on components and influence mechanism,” Geotechnical Testing Journal, vol. 38, no. 6, pp. 929–935, 2015. View at Publisher · View at Google Scholar · View at Scopus