Table of Contents Author Guidelines Submit a Manuscript
Shock and Vibration
Volume 2018 (2018), Article ID 4149212, 18 pages
https://doi.org/10.1155/2018/4149212
Research Article

Seismic Response of Plan-Asymmetric Structures with Diaphragm Flexibility

1Department of Civil Engineering, Science and Research Branch, Islamic Azad University, Tehran, Iran
2International Institute of Earthquake Engineering and Seismology (IIEES), Tehran, Iran

Correspondence should be addressed to Abdolreza S. Moghadam; ri.ca.seeii@madahgom

Received 28 June 2017; Revised 30 October 2017; Accepted 3 December 2017; Published 15 January 2018

Academic Editor: Naveed Ahmad

Copyright © 2018 Hamed Eivani et al. This is an open access article distributed under the Creative Commons Attribution License, which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited.

Linked References

  1. S. K. Kunnath, N. Panahshahi, and A. M. Reinhorn, “Seismic response of RC buildings with inelastic floor diaphragms,” Journal of Structural Engineering (United States), vol. 117, no. 4, pp. 1218–1237, 1991. View at Publisher · View at Google Scholar · View at Scopus
  2. S. H. Ju and M. C. Lin, “Comparison of building analyses assuming rigid or flexible floors,” Journal of Structural Engineering, vol. 125, no. 1, pp. 25–31, 1999. View at Publisher · View at Google Scholar · View at Scopus
  3. V. K. Sadashiva, G. A. Macrae, B. L. Deam, and M. S. Spooner, “Quantifying the seismic response of structures with flexible diaphragms,” Earthquake Engineering & Structural Dynamics, vol. 41, no. 10, pp. 1365–1389, 2012. View at Publisher · View at Google Scholar · View at Scopus
  4. A. K. L. Damian, C. T. Bia, O. Gosa, H. Maniu, and C. S. Dico, “Diaphragm behaviour of the floor with prestressed beam and filler blocks,” in Proceedings of the 12th World Conference on Earthquake Engineering (WCEE 12), Paper No. 0696, Auckland, New Zealand, February 2000.
  5. E. R. Mario, S. Santiago, and R. Meli, “Seismic load tests on two-story waffle-flat-plate structure,” Journal of Structural Engineering (United States), vol. 121, no. 9, pp. 1287–1293, 1995. View at Publisher · View at Google Scholar · View at Scopus
  6. A. Tena-Colunga, K. L. Chinchilla-Portillo, and G. Juárez-Luna, “Assessment of the diaphragm condition for floor systems used in urban buildings,” Engineering Structures, vol. 93, pp. 70–84, 2015. View at Publisher · View at Google Scholar · View at Scopus
  7. M. A. Hadianfard and S. Sedaghat, “Investigation of joist floor diaphragm flexibility on inelastic behavior of steel braced structures,” Scientia Iranica, vol. 20, no. 3, pp. 445–453, 2003. View at Google Scholar · View at Scopus
  8. J. De-La-Colina, “In-plane floor flexibility effects on torsionally unbalanced systems,” Earthquake Engineering & Structural Dynamics, vol. 28, no. 12, pp. 1705–1715, 1999. View at Publisher · View at Google Scholar · View at Scopus
  9. O. A. López and E. Raven, “An Overall Evaluation of Irregular‐Floor‐Plan—Shaped Buildings Located in Seismic Areas,” Earthquake Spectra, vol. 15, no. 1, pp. 105–120, 1999. View at Publisher · View at Google Scholar
  10. P. Somers, D. Campi, W. Holmes, B. E. Kehoe et al., “Unreinforced masonary buildings,” Earthquake Spectra, vol. 12, no. S1, pp. 195–217, 1996. View at Google Scholar
  11. R. Shepherd, W. T. Holmes, B. Lizundia et al., “Buildings,” Earthquake Spectra, vol. 6, no. S1, pp. 127–149, 1990. View at Publisher · View at Google Scholar
  12. H. S. Saffarini and M. M. Qudaimat, “In-plane floor deformations in RC structures,” Journal of Structural Engineering (United States), vol. 118, no. 11, pp. 3089–3102, 1992. View at Publisher · View at Google Scholar · View at Scopus
  13. S.-K. Moon and D.-G. Lee, “Effects of inplane floor slab flexibility on the seismic behaviour of building structures,” Engineering Structures, vol. 16, no. 2, pp. 129–144, 1994. View at Publisher · View at Google Scholar · View at Scopus
  14. H. J. Lee, M. A. Aschheim, and D. Kuchma, “Interstory drift estimates for low-rise flexible diaphragm structures,” Engineering Structures, vol. 29, no. 7, pp. 1375–1397, 2007. View at Publisher · View at Google Scholar · View at Scopus
  15. R. B. Fleischman and K. T. Farrow, “Dynamic behavior of perimeter lateral-system structures with flexible diaphragms,” Earthquake Engineering & Structural Dynamics, vol. 30, no. 5, pp. 745–763, 2001. View at Publisher · View at Google Scholar · View at Scopus
  16. G. Magenes, A. Penna, I. E. Senaldi, M. Rota, and A. Galasco, “Shaking table test of a strengthened full-scale stone masonry building with flexible diaphragms,” International Journal of Architectural Heritage, vol. 8, no. 3, pp. 349–375, 2014. View at Publisher · View at Google Scholar · View at Scopus
  17. I. Senaldi, G. Magenes, A. Penna, A. Galasco, and M. Rota, “The effect of stiffened floor and roof diaphragms on the experimental seismic response of a full-scale unreinforced stone masonry building,” Journal of Earthquake Engineering, vol. 18, no. 3, pp. 407–443, 2014. View at Publisher · View at Google Scholar · View at Scopus
  18. S.-C. Kim and D. W. White, “Nonlinear analysis of a one-story low-rise masonry building with a flexible diaphragm subjected to seismic excitation,” Engineering Structures, vol. 26, no. 14, pp. 2053–2067, 2004. View at Publisher · View at Google Scholar · View at Scopus
  19. Y. Nakamura, H. Derakhshan, G. Magenes, and M. C. Griffith, “Influence of Diaphragm Flexibility on Seismic Response of Unreinforced Masonry Buildings,” Journal of Earthquake Engineering, vol. 21, no. 6, pp. 935–960, 2017. View at Publisher · View at Google Scholar · View at Scopus
  20. T. Paulay, “Seismic response of structural walls: Recent developments,” Canadian Journal of Civil Engineering, vol. 28, no. 6, pp. 922–937, 2001. View at Publisher · View at Google Scholar · View at Scopus
  21. M. J. N. Priestley and M. J. Kowalsky, “Aspects of drift and ductility capacity of rectangular cantilever structural walls,” Bulletin of the New Zealand National Society forEarthquake Engineering and Structural Dynamics, vol. 31, no. 2, pp. 73–85, 1998. View at Google Scholar
  22. T. Paulay, “Seismic torsional effects on ductile structural wall systems,” Journal of Earthquake Engineering, vol. 1, no. 4, pp. 721–745, 1997. View at Publisher · View at Google Scholar · View at Scopus
  23. W. K. Tso and R. S. H. Smith, “Re-evaluation of seismic torsional provisions,” Earthquake Engineering & Structural Dynamics, vol. 28, no. 7-8, pp. 899–917, 1999. View at Publisher · View at Google Scholar · View at Scopus
  24. T. Paulay, “Some design principles relevant to torsional phenomena in ductile buildings,” Journal of Earthquake Engineering, vol. 5, no. 3, pp. 273–308, 2001. View at Publisher · View at Google Scholar · View at Scopus
  25. W. K. Tso and B. Myslimaj, “Effect of strength distribution on the inelastic torsional response of asymmetric structural systems,” in Proceedings of the 12th European Conference on Earthquake Engineering, Paper No. 081, London, UK, September 2002.
  26. A. Aziminejad and A. S. Moghadam, “Fragility-based performance evaluation of asymmetric single-story buildings in near field and far field earthquakes,” Journal of Earthquake Engineering, vol. 14, no. 6, pp. 789–816, 2010. View at Publisher · View at Google Scholar · View at Scopus
  27. Iranian national building code, Part 6. Design Loads for Buildings, Building and Housing Research Center, Tehran, Iran, 2013.
  28. Standard No. 2800, Iranian Code of Practice for Seismic Resistant Design of Buildings, Building and Housing Research Center, Tehran, Iran, 2014.
  29. A. Rutenburg, “EAEE task group 8: Behaviour of irregular and complex structures: progress since 1998,” in Proceedings of the 12th European Conference on Earthquake Engineering, Paper No. 832, London, UK, September 2002.
  30. B. Myslimaj and W. K. Tso, “A strength distribution criterion for minimizing torsional response of asymmetric wall-type systems,” Earthquake Engineering & Structural Dynamics, vol. 31, no. 1, pp. 99–120, 2002. View at Publisher · View at Google Scholar · View at Scopus
  31. B. Myslimaj and W. K. Tso, “A design-oriented approach to strength distribution in single-story asymmetric systems with elements having strength-dependent stiffness,” Earthquake Spectra, vol. 21, no. 1, pp. 197–212, 2005. View at Publisher · View at Google Scholar · View at Scopus
  32. M. De Stefano, G. Faella, and R. Ramasco, “Inelastic response and design criteria of plan‐wise asymmetric systems,” Earthquake Engineering & Structural Dynamics, vol. 22, no. 3, pp. 245–259, 1993. View at Publisher · View at Google Scholar · View at Scopus
  33. ASCE/SEI 7-10, Minimum Design Loads for Buildings and Other Structures, American Society of Civil Engineers, Reston, Va , US, 2010.
  34. M. Silvia, M. Frank, and H. Michael, Open System for Earthquake Engineering Simulation User Manual, Pacific Earthquake Engineering Research Center, University of California, Berkeley, Calif, USA, 2005.
  35. S. Mazzoni, F. McKenna, and G. L. Fenves, OpenSees Command Language Manual, Pacific Earthquake Engineering Center, University of California, Berkeley, Calif, USA, 2005.
  36. M. J. N. Priestley, G. M. Calvi, and M. J. Kowalsky, Displacement-Based Seismic Design of Structures, IUSS Press, Pavia, Italy, 2007.
  37. E. M. Rathje, C. Dawson, J. E. Padgett et al., “DesignSafe: new cyberinfrastructure for natural hazards engineering,” Natural Hazards Review, vol. 18, no. 3, 2017. View at Publisher · View at Google Scholar