Table of Contents Author Guidelines Submit a Manuscript
The Scientific World Journal
Volume 2014, Article ID 301271, 13 pages
http://dx.doi.org/10.1155/2014/301271
Research Article

An Alternate Method to Springback Compensation for Sheet Metal Forming

1Department of Engineering Mechanics, Universiti Tun Hussein Onn Malaysia, Parit Raja, Batu Pahat, 86400 Johor, Malaysia
2Department of Mechanical Engineering, Muhammadiyah University of Surakarta, Pabelan, Kartasura 57162, Indonesia
3Department of Materials Engineering and Design, Universiti Tun Hussein Onn Malaysia, Parit Raja, 86400 Johor, Malaysia
4Faculty of Forestry, Universiti Putra Malaysia, Serdang, 43400 Selangor, Malaysia

Received 20 February 2014; Revised 6 May 2014; Accepted 18 May 2014; Published 11 June 2014

Academic Editor: Hailiang Yu

Copyright © 2014 Waluyo Adi Siswanto et al. This is an open access article distributed under the Creative Commons Attribution License, which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited.

How to Cite this Article

Waluyo Adi Siswanto, Agus Dwi Anggono, Badrul Omar, and Kamaruzaman Jusoff, “An Alternate Method to Springback Compensation for Sheet Metal Forming,” The Scientific World Journal, vol. 2014, Article ID 301271, 13 pages, 2014. https://doi.org/10.1155/2014/301271.