Table of Contents Author Guidelines Submit a Manuscript
The Scientific World Journal
Volume 2015 (2015), Article ID 393629, 13 pages
http://dx.doi.org/10.1155/2015/393629
Research Article

R Dump Converter without DC Link Capacitor for an 8/6 SRM: Experimental Investigation

1Department of Electrical and Electronics Engineering, Anna University, Chennai, Tamil Nadu 600025, India
2Department of Electronics and Instrumentation Engineering, RMK Engineering College, Kavaraipettai, Tamil Nadu 601206, India

Received 22 August 2014; Revised 27 November 2014; Accepted 3 December 2014

Academic Editor: Xiangdang Xue

Copyright © 2015 Pasumalaithevan Kavitha and Bhaskaran Umamaheswari. This is an open access article distributed under the Creative Commons Attribution License, which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited.

Linked References

  1. R. Krishnan, Switched Reluctance Motor Drive: Modeling, Simulation, Analysis, Design and Application, Magna Physics Publishing, 2001.
  2. T. J. Miller, Switch Reluctance Motor Drive, Intertec Communications, Ventura, Calif, USA, 1988.
  3. R. Krishnan and P. Materu, “Analysis and design of a low-cost converter for switched reluctance motor drives,” IEEE Transactions on Industry Applications, vol. 29, no. 2, pp. 320–327, 1993. View at Publisher · View at Google Scholar · View at Scopus
  4. R. Krishnan, S.-Y. Park, and K. S. Ha, “Theory and operation of a four-quadrant switched reluctance motor drive with a single controllable switch—The lowest cost brushless motor drive,” IEEE Transactions on Industry Applications, vol. 41, no. 4, pp. 1047–1055, 2005. View at Publisher · View at Google Scholar
  5. M. Ehsani, I. Husain, K. R. Ramani, and J. H. Galloway, “Dual-decay converter for switched reluctance motor drives in low-voltage applications,” IEEE Transactions on Power Electronics, vol. 8, no. 2, pp. 224–230, 1993. View at Publisher · View at Google Scholar · View at Scopus
  6. T. J. E. Miller, “Converter volt–ampere requirements of the switched reluctance motor drive,” IEEE Transactions on Industry Applications, vol. 21, no. 5, pp. 1136–1144, 1985. View at Publisher · View at Google Scholar · View at Scopus
  7. M. Ehsani, J. T. Bass, T. J. E. Miller, and R. L. Steigerwald, “Development of a unipolar converter for variable reluctance motor drives,” IEEE Transactions on Industry Applications, vol. 23, no. 3, pp. 545–553, 1987. View at Publisher · View at Google Scholar · View at Scopus
  8. T. J. E. Miller et al., “Regenerative unipolar converter for switched reluctance motors using one switching device per phase,” U.S.Patent, No. 4, 684,867, August 1987.
  9. S. Mir, I. Husain, and M. E. Elbuluk, “Energy-efficient C-dump converters for switched reluctance motors,” IEEE Transactions on Power Electronics, vol. 12, no. 5, pp. 912–921, 1997. View at Publisher · View at Google Scholar · View at Scopus
  10. E. Afjei, “A new resonant converter circuit for reluctance motor,” International Journal of Engineering, vol. 12, pp. 69–80, 1999. View at Google Scholar
  11. N. Taïb, B. Metidji, T. Rekioua, and B. Francois, “Novel low-cost self-powered supply solution of bidirectional switch gate driver for matrix converters,” IEEE Transactions on Industrial Electronics, vol. 59, no. 1, pp. 211–219, 2012. View at Publisher · View at Google Scholar · View at Scopus
  12. J. Wang, B. Wu, D. Xu, and N. R. Zargari, “Multimodular matrix converters with sinusoidal input and output waveforms,” IEEE Transactions on Industrial Electronics, vol. 59, no. 1, pp. 17–26, 2012. View at Publisher · View at Google Scholar · View at Scopus
  13. E. P. Wiechmann, R. P. Burgos, and J. Rodríguez, “Continuously motor-synchronized ride-through capability for matrix-converter adjustable-speed drives,” IEEE Transactions on Industrial Electronics, vol. 49, no. 2, pp. 390–400, 2002. View at Publisher · View at Google Scholar · View at Scopus
  14. P. W. Wheeler, J. Rodríguez, J. C. Clare, L. Empringham, and A. Weinstein, “Matrix converters: a technology review,” IEEE Transactions on Industrial Electronics, vol. 49, no. 2, pp. 276–288, 2002. View at Publisher · View at Google Scholar · View at Scopus
  15. C. Y. Wu and C. Pollock, “Analysis and reduction of vibration and acoustic noise in the switched reluctance drive,” IEEE Transactions on Industry Applications, vol. 31, no. 1, pp. 91–98, 1995. View at Publisher · View at Google Scholar · View at Scopus
  16. F.-C. Lin and S.-M. Yang, “Instantaneous shaft radial force control with sinusoidal excitations for switched reluctance motors,” IEEE Transactions on Energy Conversion, vol. 22, no. 3, pp. 629–636, 2007. View at Publisher · View at Google Scholar · View at Scopus
  17. X. Liu, Z. Q. Zhu, M. Hasegawa et al., “Performance comparison between unipolar and bipolar excitations in switched reluctance machine with sinusoidal and rectangular waveforms,” in Proceedings of the 3rd Annual IEEE Energy Conversion Congress and Exposition (ECCE '11), pp. 1590–1595, Phoenix, Ariz, USA, September 2011. View at Publisher · View at Google Scholar · View at Scopus
  18. A. S. Goodman, K. J. Bradley, and P. W. Wheeler, “Evaluation of the single sided matrix converter driven switched reluctance motor,” in Proceedings of the 39th IAS Annual Meeting Conference Record of the Industry Applications Conference, pp. 1847–1851, October 2004. View at Scopus
  19. F.-C. Lin and S.-M. Yang, “Self-bearing control of a switched reluctance motor using sinusoidal currents,” IEEE Transactions on Power Electronics, vol. 22, no. 6, pp. 2518–2526, 2007. View at Publisher · View at Google Scholar · View at Scopus
  20. Z. Q. Liu, Z. Q. Zhu, M. Hasegawa et al., “Dc-link capacitance requirement and noise and vibration reduction in 6/4 switched reluctance machine with sinusoidal bipolar excitation,” in Proceedings of the IEEE Energy Conversion Congress and Exposition (ECCE '11), pp. 1596–1603, Phoenix, Ariz, USA, September 2011. View at Publisher · View at Google Scholar
  21. X. Ojeda, X. Mininger, M. Gabni, and M. Lecivain, “Sinusoidal feeding for SRM: application to vibration damping,” in Proceedings of the International Conference on Electrical Machines, 2008.
  22. S.-C. Wang and Y.-H. Liu, “A modified PI-like fuzzy logic controller for switched reluctance motor drives,” IEEE Transactions on Industrial Electronics, vol. 58, no. 5, pp. 1812–1825, 2011. View at Publisher · View at Google Scholar · View at Scopus
  23. J. Xiu and C. Xia, “An application of adaptive fuzzy logic controller for switched reluctance motor drive,” in Proceedings of the 4th International Conference on Fuzzy Systems and Knowledge Discovery (FSKD '07), pp. 154–158, August 2007. View at Publisher · View at Google Scholar · View at Scopus