Table of Contents
ISRN Civil Engineering
Volume 2012, Article ID 197170, 7 pages
http://dx.doi.org/10.5402/2012/197170
Research Article

Finite Element Models for Thin-Walled Steel Member Connections

1Structural Engineer, Stantec Consulting Ltd, 7070 Mississauga Road, Mississauga, ON, Canada L5N 7G2
2Department of Civil Engineering, McMaster University, Hamilton, ON, Canada L8S 4L7

Received 30 November 2012; Accepted 19 December 2012

Academic Editors: J. Mohammadi and K. Pilakoutas

Copyright © 2012 Sandesh R. Acharya and K. S. Sivakumaran. This is an open access article distributed under the Creative Commons Attribution License, which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited.

Linked References

  1. A. K. Dhalla, S. J. Errera, and G. Winter, “Connections in Thin Low-Ductility Steels,” Journal of the Structural Division, vol. 97, no. 10, pp. 2549–2566, 1971. View at Google Scholar
  2. L. Fan, J. Rondal, and S. Cescotto, “Finite element modelling of single lap screw connections in steel sheeting under static shear,” Thin-Walled Structures, vol. 27, no. 2, pp. 165–185, 1997. View at Google Scholar · View at Scopus
  3. H. J. Kim and J. A. Yura, “The effect of ultimate-to-yield ratio on the bearing strength of bolted connections,” Journal of Constructional Steel Research, vol. 49, no. 3, pp. 255–269, 1999. View at Publisher · View at Google Scholar · View at Scopus
  4. R. Aceti, G. Ballio, A. Capsoni, and L. Corradi, “A limit analysis study to interpret the ultimate behavior of bolted joints,” Journal of Constructional Steel Research, vol. 60, no. 9, pp. 1333–1351, 2004. View at Publisher · View at Google Scholar · View at Scopus
  5. T. S. Kim and H. Kuwamura, “Finite element modeling of bolted connections in thin-walled stainless steel plates under static shear,” Thin-Walled Structures, vol. 45, no. 4, pp. 407–421, 2007. View at Publisher · View at Google Scholar · View at Scopus
  6. AISI, North American Specification for the Design of Cold-Formed Steel Structural Members, American Iron and Steel Institute, Washington, DC, USA, 2007.
  7. K. P. Chong and R. B. Matlock, “Light-gage steel bolted connections without Washers,” Journal of Structural Division, vol. 101, no. 7, pp. 1381–1391, 1975. View at Google Scholar · View at Scopus
  8. G. Winter, “Tests on bolted connections in light gage steel,” Journal of Structural Division, vol. 82, no. 2, pp. 920-1–920-25, 1956. View at Google Scholar
  9. N. Abdel-Rahman and K. S. Sivakumaran, “Material properties models for analysis of cold-formed steel members,” Journal of Structural Engineering, vol. 123, no. 9, pp. 1135–1143, 1997. View at Google Scholar · View at Scopus
  10. ADINA, ADINA 8.5 User Manual, ADINA R & D Inc, Watertown, Mass, USA, 2009.
  11. K. Bathe, Finite Element Procedures, Prentice Hall, NJ, USA, 1996.