Table of Contents
ISRN Metallurgy
Volume 2012 (2012), Article ID 639319, 5 pages
http://dx.doi.org/10.5402/2012/639319
Research Article

Effect of Artificial Aging on Plane Anisotropy of 6063 Aluminium Alloy

Department of Metallurgical & Materials Engineering, University of Lagos, Akoka, Lagos, Nigeria

Received 15 December 2011; Accepted 11 January 2012

Academic Editor: P. Lukac

Copyright © 2012 S. O. Adeosun et al. This is an open access article distributed under the Creative Commons Attribution License, which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited.

Linked References

  1. S. Kurukuri, Simulation of thermally assisted forming of aluminum sheet, Ph.D. thesis, University of Twente, Tweante, The Netherlands, 2010.
  2. G. Al-Marahleh, “Effect of heat treatment parameters on distribution and volume fraction of Mg2Si in the structural Al 6063 alloys,” American Journal of Applied Science, vol. 3, no. 5, pp. 1819–1823, 2006. View at Google Scholar
  3. N. C. W. Kuijpers, W. H. Kool, P. T. G. Koenis, K. E. Nilsen, I. Todd, and S. Van der Zwaag, “Assessment of different techniques for quantification of α-Al(FeMn)Si and β-AlFeSi intermetallics in AA 6xxx alloys,” Materials Characterization, vol. 49, no. 5, pp. 409–420, 2002. View at Publisher · View at Google Scholar · View at Scopus
  4. R. A. Siddiqui, H. A. Abdullah, and K. R. Al-Belushi, “Influence of aging parameters on the mechanical properties of 6063 aluminium alloy,” Journal of Materials Processing Technology, vol. 102, no. 1, pp. 234–240, 2000. View at Publisher · View at Google Scholar · View at Scopus
  5. A. K. Gupta, D. J. Lloyd, and S. A. Court, “Precipitation hardening in Al—Mg—Si alloys with and without excess Si,” Materials Science and Engineering A, vol. 316, no. 1-2, pp. 11–17, 2001. View at Publisher · View at Google Scholar · View at Scopus
  6. G. Sha, K. O'Reilly, B. Cantor, J. Worth, and R. Hamerton, “Growth related metastable phase selection in a 6xxx series wrought Al alloy,” Materials Science and Engineering A, vol. 304—306, no. 1-2, pp. 612–616, 2001. View at Publisher · View at Google Scholar · View at Scopus
  7. H. Sehitoglu, T. Foglesong, and H. J. Maier, “Precipitate effects on the mechanical behavior of aluminum copper alloys,” Metallurgical and Materials Transactions A, vol. 36, pp. 1–13, 2005. View at Google Scholar