Table of Contents
International Scholarly Research Notices
Volume 2014 (2014), Article ID 828197, 5 pages
http://dx.doi.org/10.1155/2014/828197
Research Article

The Effect of Cerium Oxide Addition on the Properties and Behavior of Y-TZP

Department of Mechanical Engineering, Centre of Ceramic Technology, Universiti Tenaga Nasional, 43000 Kajang, Malaysia

Received 16 June 2014; Revised 28 August 2014; Accepted 2 September 2014; Published 30 October 2014

Academic Editor: Chantara Thevy Ratnam

Copyright © 2014 D. Ragurajan et al. This is an open access article distributed under the Creative Commons Attribution License, which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited.

Linked References

  1. G. A. Gogotsi, V. I. Galenko, S. P. Mudrik, B. I. Ozersky, V. V. Khvorostyany, and T. A. Khristevich, “Fracture behaviour of Y-TZP ceramics: new outcomes,” Ceramics International, vol. 36, no. 1, pp. 345–350, 2010. View at Publisher · View at Google Scholar · View at Scopus
  2. A. H. A. Sabrah, N. B. Cook, P. Luangruangrong, A. T. Hara, and M. C. Bottino, “Full-contour Y-TZP ceramic surface roughness effect on synthetic hydroxyapatite wear,” Dental Materials, vol. 29, no. 6, pp. 666–673, 2013. View at Publisher · View at Google Scholar · View at Scopus
  3. P. M. Kelly and L. R. F. Rose, “The martensitic transformation in ceramics—its role in transformation toughening,” Progress in Materials Science, vol. 47, no. 5, pp. 463–557, 2002. View at Publisher · View at Google Scholar · View at Scopus
  4. K. Matsui, H. Yoshida, and Y. Ikuhara, “Grain-boundary structure and microstructure development mechanism in 2–8 mol% yttria-stabilized zirconia polycrystals,” Acta Materialia, vol. 56, no. 6, pp. 1315–1325, 2008. View at Publisher · View at Google Scholar · View at Scopus
  5. K. Kobayashi, H. Kuwajima, and T. Masaki, “Phase change and mechanical properties of ZrO2-Y2O3 solid electrolyte after ageing,” Solid State Ionics, vol. 3-4, pp. 489–493, 1981. View at Publisher · View at Google Scholar · View at Scopus
  6. C. Schröder, A. Renz, C. Koplin, and A. Kailer, “Assessment of low-temperature degradation of Y-TZP ceramics based on Raman-spectroscopic analysis and hardness indentation,” Journal of the European Ceramic Society, vol. 34, no. 16, pp. 4311–4319, 2014. View at Publisher · View at Google Scholar
  7. M. Keuper, K. Eder, C. Berthold, and K. G. Nickel, “Direct evidence for continuous linear kinetics in the low-temperature degradation of Y-TZP,” Acta Biomaterialia, vol. 9, no. 1, pp. 4826–4835, 2013. View at Publisher · View at Google Scholar · View at Scopus
  8. F. Zhang, K. Vanmeensel, M. Inokoshi et al., “3Y-TZP ceramics with improved hydrothermal degradation resistance and fracture toughness,” Journal of the European Ceramic Society, vol. 34, no. 10, pp. 2453–2463, 2014. View at Publisher · View at Google Scholar · View at Scopus
  9. Z.-K. Wu, N. Li, C. Jian, W.-Q. Zhao, and J.-Z. Yan, “Low temperature degradation of Al2O3-doped 3Y-TZP sintered at various temperatures,” Ceramics International, vol. 39, no. 6, pp. 7199–7204, 2013. View at Publisher · View at Google Scholar · View at Scopus
  10. M. Cattani-Lorente, S. S. Scherrer, P. Ammann, M. Jobin, and H. W. A. Wiskott, “Low temperature degradation of a Y-TZP dental ceramic,” Acta Biomaterialia, vol. 7, no. 2, pp. 858–865, 2011. View at Publisher · View at Google Scholar · View at Scopus
  11. P. Kohorst, L. Borchers, J. Strempel et al., “Low-temperature degradation of different zirconia ceramics for dental applications,” Acta Biomaterialia, vol. 8, no. 3, pp. 1213–1220, 2012. View at Publisher · View at Google Scholar · View at Scopus
  12. L. Borchers, M. Stiesch, F.-W. Bach et al., “Influence of hydrothermal and mechanical conditions on the strength of zirconia,” Acta Biomaterialia, vol. 6, no. 12, pp. 4547–4552, 2010. View at Publisher · View at Google Scholar · View at Scopus
  13. F. Egilmez, G. Ergun, I. Cekic-Nagas, P. K. Vallittu, and L. V. J. Lassila, “Factors affecting the mechanical behavior of Y-TZP,” Journal of the Mechanical Behavior of Biomedical Materials, vol. 37, pp. 78–87, 2014. View at Publisher · View at Google Scholar · View at Scopus
  14. J. Valle, A. Mestra, F. G. Marro, and M. Anglada, “Mechanical properties and resistance to low temperature degradation of surface nitrided 3Y-TZP,” Journal of the European Ceramic Society, vol. 33, no. 15-16, pp. 3145–3155, 2013. View at Publisher · View at Google Scholar · View at Scopus
  15. H. P. Papanagiotou, S. M. Morgano, R. A. Giordano, and R. Pober, “In vitro evaluation of low-temperature aging effects and finishing procedures on the flexural strength and structural stability of Y-TZP dental ceramics,” The Journal of Prosthetic Dentistry, vol. 96, no. 3, pp. 154–164, 2006. View at Publisher · View at Google Scholar · View at Scopus
  16. J. Chevalier, “What future for zirconia as a biomaterial?” Biomaterials, vol. 27, no. 4, pp. 535–543, 2006. View at Publisher · View at Google Scholar · View at Scopus
  17. T. Kosmač, Č. Oblak, and L. Marion, “The effects of dental grinding and sandblasting on ageing and fatigue behavior of dental zirconia (Y-TZP) ceramics,” Journal of the European Ceramic Society, vol. 28, no. 5, pp. 1085–1090, 2008. View at Publisher · View at Google Scholar · View at Scopus
  18. M. Cattani-Lorente, S. S. Scherrer, S. Durual et al., “Effect of different surface treatments on the hydrothermal degradation of a 3Y-TZP ceramic for dental implants,” Dental Materials, 2014. View at Publisher · View at Google Scholar
  19. N. Masahiro, N. Kurizoe, Y. Okamoto, and A. Ueno, “Transformation-induced plastic deformation in Ce-TZP/alumina nanocomposite generated during fatigue tests at room temperature,” Journal of the European Ceramic Society, vol. 34, no. 16, pp. 4337–4345, 2014. View at Publisher · View at Google Scholar
  20. X. Guo and J. He, “Hydrothermal degradation of cubic zirconia,” Acta Materialia, vol. 51, no. 17, pp. 5123–5130, 2003. View at Publisher · View at Google Scholar · View at Scopus
  21. X. Guo and T. Schober, “Water incorporation in tetragonal zirconia,” Journal of the American Ceramic Society, vol. 87, no. 4, pp. 746–748, 2004. View at Publisher · View at Google Scholar · View at Scopus
  22. V. Lughi and V. Sergo, “Low temperature degradation -aging- of zirconia: a critical review of the relevant aspects in dentistry,” Dental Materials, vol. 26, no. 8, pp. 807–820, 2010. View at Publisher · View at Google Scholar · View at Scopus
  23. J. R. Kelly and I. Denry, “Stabilized zirconia as a structural ceramic: an overview,” Dental Materials, vol. 24, no. 3, pp. 289–298, 2008. View at Publisher · View at Google Scholar · View at Scopus
  24. L. Hallmann, P. Ulmer, E. Reusser, M. Louvel, and C. H. F. Hämmerle, “Effect of dopants and sintering temperature on microstructure and low temperature degradation of dental Y-TZP-zirconia,” Journal of the European Ceramic Society, vol. 32, no. 16, pp. 4091–4104, 2012. View at Publisher · View at Google Scholar · View at Scopus
  25. O. Gunduz, C. Gode, Z. Ahmad et al., “Preparation and evaluation of cerium oxide-bovine hydroxyapatite composites for biomedical engineering applications,” Journal of the Mechanical Behavior of Biomedical Materials, vol. 35, pp. 70–76, 2014. View at Publisher · View at Google Scholar · View at Scopus
  26. M. Nawa, K. Yamada, and N. Kurizoe, “Effect of the t-m transformation morphology and stress distribution around the crack path on the measured toughness of zirconia ceramics: a case study on Ce-TZP/alumina nanocomposite,” Journal of the European Ceramic Society, vol. 33, no. 3, pp. 521–529, 2013. View at Publisher · View at Google Scholar · View at Scopus
  27. J. Fischer and B. Stawarczyk, “Compatibility of machined Ce-TZP/Al2O3 nanocomposite and a veneering ceramic,” Dental Materials, vol. 23, no. 12, pp. 1500–1505, 2007. View at Publisher · View at Google Scholar · View at Scopus
  28. R. V. Mangalaraja, B. K. Chandrasekhar, and P. Manohar, “Effect of ceria on the physical, mechanical and thermal properties of yttria stabilized zirconia toughened alumina,” Materials Science and Engineering A, vol. 343, no. 1-2, pp. 71–75, 2003. View at Publisher · View at Google Scholar · View at Scopus
  29. T. Takano, A. Tasaka, M. Yoshinari, and K. Sakurai, “Fatigue strength of Ce-TZP/Al2O3 nanocomposite with different surfaces,” Journal of Dental Research, vol. 91, no. 8, pp. 800–804, 2012. View at Publisher · View at Google Scholar · View at Scopus
  30. K. Kuroda, H. Saka, S. Iio, M. Watanabe, and T. Imura, “Tetragonal-to-monoclinic transformation in ZrO2-Y2O3 ceramics,” in Proceedings of the International Conference on Martensitic Transformations, pp. 1161–1166, The Japan Institute of Metals, 1986.
  31. T. Shigematsu, Y. Nakao, and N. Nakanishi, “Effect of water on the tetragonal to monoclinic phase transition of ZrO2 with Y2O3,” MRS Intl. Mtg. on Adv. Mats, vol. 9, pp. 549–554, 1989. View at Google Scholar
  32. J. Chevalier, J. Loh, L. Gremillard, S. Meille, and E. Adolfson, “Low-temperature degradation in zirconia with a porous surface,” Acta Biomaterialia, vol. 7, no. 7, pp. 2986–2993, 2011. View at Publisher · View at Google Scholar · View at Scopus
  33. S. Ramesh, M. Amiriyan, S. Meenaloshini et al., “Densification behaviour and properties of manganese oxide doped Y-TZP ceramics,” Ceramics International, vol. 37, no. 8, pp. 3583–3590, 2011. View at Publisher · View at Google Scholar · View at Scopus
  34. N. Soltani, M. I. Pech-Canul, and A. Bahrami, “Effect of 10Ce-TZP/Al2O3 nanocomposite particle amount and sintering temperature on the microstructure and mechanical properties of Al/(10Ce-TZP/Al2O3) nanocomposites,” Materials and Design, vol. 50, pp. 85–91, 2013. View at Publisher · View at Google Scholar · View at Scopus
  35. S. N. B. Hodgson and J. Cawley, “The effect of titanium oxide additions on the properties and behaviour of Y-TZP,” Journal of Materials Processing Technology, vol. 119, no. 1–3, pp. 112–116, 2001. View at Publisher · View at Google Scholar · View at Scopus
  36. Zirconium Oxide, ZrO2 Ceramic Properties, Accuratus, http://accuratus.com/zirc.html.
  37. S. Ramesh, S. Meenaloshini, C. Y. Tan, W. J. K. Chew, and W. D. Teng, “Effect of manganese oxide on the sintered properties and low temperature degradation of Y-TZP ceramics,” Ceramics International, vol. 34, no. 7, pp. 1603–1608, 2008. View at Publisher · View at Google Scholar · View at Scopus
  38. S. N. B. Hodgson, J. Cawley, and M. Clubley, “The role of SiO2 impurities in the microstructure and properties of Y-TZP,” Journal of Materials Processing Technology, vol. 86, no. 1–3, pp. 139–145, 1998. View at Google Scholar · View at Scopus