Table of Contents
Journal of Ceramics
Volume 2014, Article ID 713916, 5 pages
http://dx.doi.org/10.1155/2014/713916
Research Article

Mechanical Behavior of Yttria-Stabilized Zirconia Aqueous Cast Tapes and Laminates

1Graduate Program on Materials Science and Engineering (PGMAT), Federal University of Santa Catarina, 88040-900 Florianópolis, SC, Brazil
2Department of Mechanical Engineering, Federal University of Santa Catarina, 88040-900 Florianópolis, SC, Brazil
3Department of Chemical Engineering, Federal University of Santa Catarina, 88040-900 Florianópolis, SC, Brazil

Received 6 December 2013; Revised 22 January 2014; Accepted 27 January 2014; Published 9 March 2014

Academic Editor: Thomas Graule

Copyright © 2014 V. Moreno et al. This is an open access article distributed under the Creative Commons Attribution License, which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited.

Linked References

  1. F. Doreau, G. Tarì, M. Guedes, T. Chartier, C. Pagnoux, and J. M. F. Ferreira, “Mechanical and lamination properties of alumina green tapes obtained by aqueous tape-casting,” Journal of the European Ceramic Society, vol. 19, no. 16, pp. 2867–2873, 1999. View at Google Scholar · View at Scopus
  2. M. P. Albano and L. B. Garrido, “Influence of the slip composition on the properties of tape-cast alumina substrates,” Ceramics International, vol. 31, no. 1, pp. 57–66, 2005. View at Publisher · View at Google Scholar · View at Scopus
  3. H. Moon, S. D. Kim, S. H. Hyun, and H. S. Kim, “Development of IT-SOFC unit cells with anode-supported thin electrolytes via tape casting and co-firing,” International Journal of Hydrogen Energy, vol. 33, no. 6, pp. 1758–1768, 2008. View at Publisher · View at Google Scholar · View at Scopus
  4. M. P. Albano and L. B. Garrido, “Aqueous tape casting of yttria stabilized zirconia,” Materials Science and Engineering A, vol. 420, no. 1-2, pp. 171–178, 2006. View at Publisher · View at Google Scholar · View at Scopus
  5. M. P. Albano and L. B. Garrido, “Influence of the slip composition on the aqueous processing and properties of yttria stabilized zirconia green tapes,” Ceramics International, vol. 32, no. 5, pp. 567–574, 2006. View at Publisher · View at Google Scholar · View at Scopus
  6. Y. Zhang and J. Binner, “Tape casting aqueous alumina suspensions containing a latex binder,” Journal of Materials Science, vol. 37, no. 9, pp. 1831–1837, 2002. View at Publisher · View at Google Scholar · View at Scopus
  7. J. Feng and F. Dogan, “Aqueous processing and mechanical properties of PLZT green tapes,” Materials Science and Engineering A, vol. 283, no. 1-2, pp. 56–64, 2000. View at Google Scholar · View at Scopus
  8. H. Jantunen, T. Hu, A. Uusimäki, and S. Leppävuori, “Tape casting of ferroelectric, dielectric, piezoelectric and ferromagnetic materials,” Journal of the European Ceramic Society, vol. 24, no. 6, pp. 1077–1081, 2004. View at Publisher · View at Google Scholar · View at Scopus
  9. P. Vozdecky and A. Roosen, “Direct tape casting of nanosized Al2O3 slurries derived from autogenous nanomilling,” Journal of the American Ceramic Society, vol. 93, no. 5, pp. 1313–1319, 2010. View at Publisher · View at Google Scholar · View at Scopus
  10. D. Hotza and P. Greil, “Review: aqueous tape casting of ceramic powders,” Materials Science and Engineering A, vol. 202, no. 1-2, pp. 206–217, 1995. View at Google Scholar · View at Scopus
  11. T. Chartier and A. Bruneau, “Aqueous tape casting of alumina substrates,” Journal of the European Ceramic Society, vol. 12, no. 4, pp. 243–247, 1993. View at Google Scholar · View at Scopus
  12. A. Kristoffersson and E. Carlström, “Tape casting of alumina in water with an acrylic latex binder,” Journal of the European Ceramic Society, vol. 17, no. 2-3, pp. 289–297, 1997. View at Google Scholar · View at Scopus
  13. Y. Zhang, C. Qin, and J. Binner, “Processing multi-channel alumina membranes by tape casting latex-based suspensions,” Ceramics International, vol. 32, no. 7, pp. 811–818, 2006. View at Publisher · View at Google Scholar · View at Scopus
  14. L. Xibao, “Aqueous tape casting of SDC with a multifunctional dispersant,” Journal of Ceramic Processing Research, vol. 13, pp. 324–329, 2012. View at Google Scholar
  15. Y. Cho, J. Yeo, Y. Jung, S. Choi, J. Kim, and U. Paik, “Effect of molecular mass of poly(vinyl butyral) and lamination pressure on the pore evolution and microstructure of BaTiO3 laminates,” Materials Science and Engineering A, vol. 362, no. 1-2, pp. 174–180, 2003. View at Publisher · View at Google Scholar · View at Scopus
  16. V. Moreno, J. L. Aguilar, and D. Hotza, “8YSZ tapes produced by aqueous tape casting,” Materials Science Forum, vol. 727-728, pp. 752–757, 2012. View at Google Scholar
  17. R. Moreno, “The role of slip additives in tape-casting technology, part II: binders and plasticizers,” American Ceramic Society Bulletin, vol. 71, pp. 1647–1657, 1992. View at Google Scholar
  18. Y. Qiao, Y. Liu, A. Liu, and Y. Wang, “Boron carbide green sheet processed by environmental friendly non-aqueous tape casting,” Ceramics International, vol. 38, no. 3, pp. 2319–2324, 2012. View at Publisher · View at Google Scholar · View at Scopus
  19. C. M. Gomes, A. P. N. Oliveira, D. Hotza, N. Travitzky, and P. Greil, “LZSA glass-ceramic laminates: fabrication and mechanical properties,” Journal of Materials Processing Technology, vol. 206, pp. 194–201, 2008. View at Publisher · View at Google Scholar · View at Scopus