Journal of Coatings
Volume 2013 (2013), Article ID 613178, 7 pages
http://dx.doi.org/10.1155/2013/613178
Research Article
Friction and Wear Properties of Cold Gas Dynamic Sprayed Composite Coatings
State Key Laboratory of Corrosion and Protection, Institute of Metal Research, CAS, Shengyang 110016, China
Received 21 March 2013; Revised 11 June 2013; Accepted 30 June 2013
Academic Editor: Wenya Li
Copyright © 2013 Jie Wu et al. This is an open access article distributed under the Creative Commons Attribution License, which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited.
Linked References
- B. Sartwell, K. Legg, and J. Sauer, “Validation of WC/Co HVOF thermal spray coatings as a replacement for hard chrome plating on aircraft landing gear, part I: material testing,” Joint Test Report, U.S. Department of Defense, 2002. View at Google Scholar
- J. G. Legoux, B. Arsenault, L. Leblanc, V. Bouyer, and C. Moreau, “Evaluation of four high velocity thermal spray guns using WC-10% CO-4% Cr cermets,” Journal of Thermal Spray Technology, vol. 11, no. 1, pp. 86–94, 2002. View at Publisher · View at Google Scholar · View at Scopus
- R. C. McCune, W. T. Donlon, O. O. Popoola, and E. L. Cartwright, “Characterization of copper layers produced by cold gas-dynamic spraying,” Journal of Thermal Spray Technology, vol. 9, no. 1, pp. 73–82, 2000. View at Google Scholar · View at Scopus
- K. Sakaki and Y. Shimizu, “Effect of the increase in the entrance convergent section length of the gun nozzle on the high-velocity oxygen fuel and cold spray process,” Journal of Thermal Spray Technology, vol. 10, no. 3, pp. 487–496, 2001. View at Publisher · View at Google Scholar · View at Scopus
- R. C. Dykhuizen and M. F. Smith, “Gas dynamic principles of cold spray,” Journal of Thermal Spray Technology, vol. 7, no. 2, pp. 205–212, 1998. View at Google Scholar · View at Scopus
- R. C. Dykhuizen, M. F. Smith, D. L. Gilmore, R. A. Neiser, X. Jiang, and S. Sampath, “Impact of high velocity cold spray particles,” Journal of Thermal Spray Technology, vol. 8, no. 4, pp. 559–564, 1999. View at Publisher · View at Google Scholar · View at Scopus
- T. H. van Steenkiste, “Kinetic spray: a new coating process,” Key Engineering Materials, vol. 197, pp. 59–85, 2001. View at Google Scholar · View at Scopus
- T. H. van Steenkiste, J. R. Smith, and R. E. Teets, “Aluminum coatings via kinetic spray with relatively large powder particles,” Surface and Coatings Technology, vol. 154, no. 2-3, pp. 237–252, 2002. View at Publisher · View at Google Scholar · View at Scopus
- D. L. Gilmore, R. C. Dykhuizen, R. A. Neiser, T. J. Roemer, and M. F. Smith, “Particle velocity and deposition efficiency in the cold spray process,” Journal of Thermal Spray Technology, vol. 8, no. 4, pp. 576–582, 1999. View at Publisher · View at Google Scholar · View at Scopus
- R. S. Lima, J. Karthikeyan, C. M. Kay, J. Lindemann, and C. C. Berndt, “Microstructural characteristics of cold-sprayed nanostructured WC-Co coatings,” Thin Solid Films, vol. 416, no. 1-2, pp. 129–135, 2002. View at Publisher · View at Google Scholar · View at Scopus
- H. Y. Lee, Y. H. Yu, Y. C. Lee, Y. P. Hong, and K. H. Ko, “Cold spray of SiC and Al2O3 with soft metal incorporation: a technical contribution,” Journal of Thermal Spray Technology, vol. 13, no. 2, pp. 184–189, 2004. View at Publisher · View at Google Scholar · View at Scopus
- A. P. Alkhimov, S. V. Klinkov, V. F. Kosarev, and A. N. Papyrin, “Gas-dynamic spraying. Study of a plane supersonic two-phase jet,” Journal of Applied Mechanics and Technical Physics, vol. 38, no. 2, pp. 324–330, 1997. View at Publisher · View at Google Scholar · View at Scopus
- H. Y. Lee, S. H. Jung, S. Y. Lee, Y. H. You, and K. H. Ko, “Correlation between Al2O3 particles and interface of Al-Al2O3 coatings by cold spray,” Applied Surface Science, vol. 252, no. 5, pp. 1891–1898, 2005. View at Publisher · View at Google Scholar · View at Scopus
- Y. Tao, T. Xiong, C. Sun, H. Jin, H. Du, and T. Li, “Effect of α-Al2O3 on the properties of cold sprayed Al/α-Al2O3 composite coatings on AZ91D magnesium alloy,” Applied Surface Science, vol. 256, no. 1, pp. 261–266, 2009. View at Publisher · View at Google Scholar · View at Scopus
- Y. Tao, T. Xiong, C. Sun et al., “Microstructure and corrosion performance of a cold sprayed aluminium coating on AZ91D magnesium alloy,” Corrosion Science, vol. 52, no. 10, pp. 3191–3197, 2010. View at Publisher · View at Google Scholar · View at Scopus