Table of Contents
Journal of Composites
Volume 2013, Article ID 274527, 9 pages
http://dx.doi.org/10.1155/2013/274527
Research Article

Tribological Performance Optimization of Al-7.5% SiCp Composites Using the Taguchi Method and Grey Relational Analysis

Department of Mechanical Engineering, Jadavpur University, Kolkata 700032, India

Received 11 May 2013; Accepted 7 August 2013

Academic Editor: Masamichi Kawai

Copyright © 2013 Shouvik Ghosh et al. This is an open access article distributed under the Creative Commons Attribution License, which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited.

Citations to this Article [9 citations]

The following is the list of published articles that have cited the current article.

  • Rupinder Singh, and Gagandeep Singh, “Investigations of Al–SiC AMC prepared by vacuum moulding assisted stir casting,” Journal of Manufacturing Processes, vol. 19, pp. 142–147, 2015. View at Publisher · View at Google Scholar
  • Ruihong Wang, Liguo Zhang, Lianjie Dong, and Xiuying Lu, “The Development and Application of Crop Evaluation System Based on GRA,” Mathematical Problems in Engineering, vol. 2016, pp. 1–6, 2016. View at Publisher · View at Google Scholar
  • Rupinder Singh, Jagdeep Singh, and Sunpreet Singh, “Investigation of Dry Sliding Wear Properties of Aluminium Matrix Composite Prepared Through FDMAIC Process Using Reinforced Pattern,” Proceedings of the National Academy of Sciences, India Section A: Physical Sciences, 2017. View at Publisher · View at Google Scholar
  • Blaza Stojanovic, Jasmina Blagojević, Miroslav Babic, Sandra Veličković, and Slavica Miladinovic, “Optimization of hybrid aluminum composites wear using Taguchi method and artificial neural network,” Industrial Lubrication and Tribology, pp. 00–00, 2017. View at Publisher · View at Google Scholar
  • Prasanth Achuthamenon Sylajakumari, Ramesh Ramakrishnasamy, and Gopalakrishnan Palaniappan, “Taguchi Grey Relational Analysis for Multi-Response Optimization of Wear in Co-Continuous Composite,” Materials, vol. 11, no. 9, pp. 1743, 2018. View at Publisher · View at Google Scholar
  • Hüsamettin Kus, Gokhan Basar, and Funda Kahraman, “Modeling and optimization for fly ash reinforced bronze-based composite materials using multi objective Taguchi technique and regression analysis,” Industrial Lubrication and Tribology, 2018. View at Publisher · View at Google Scholar
  • B Manjunatha, H.B. Niranjan, and K.G. Satyanarayana, “Effect of amount of boron carbide on wear loss of Al-6061 matrix composite by Taguchi technique and Response surface analysis,” IOP Conference Series: Materials Science and Engineering, vol. 376, pp. 012071, 2018. View at Publisher · View at Google Scholar
  • O O Ojo, and E Taban, “Hybrid multi-response optimization of friction stir spot welds: failure load, effective bonded size and flash volume as responses,” Sādhanā, vol. 43, no. 6, 2018. View at Publisher · View at Google Scholar
  • Ranjitsinha R. Gidde, Anil B. Shinde, Prashant M. Pawar, and Babruvahan P. Ronge, “Design optimization of a rectangular wave micromixer (RWM) using Taguchi based grey relational analysis (GRA),” Microsystem Technologies, 2018. View at Publisher · View at Google Scholar