Table of Contents
Journal of Metallurgy
Volume 2012, Article ID 624650, 10 pages
http://dx.doi.org/10.1155/2012/624650
Research Article

Mould Filling Ability Characterisation of Cast Aluminium Alloys Using Design of Experiments

1Department of Metallurgical and Materials Engineering, MGIT, Hyderabad 500075, India
2Special Fabrication Division, DRDL, Hyderabad 500058, India
3Mechanical Engineering Department, M.V.S.R. Engineering College, Hyderabad 501510, India
4National Institute of Technology, Trichy 620015, India

Received 23 February 2012; Revised 1 August 2012; Accepted 21 August 2012

Academic Editor: Brij Kumar Dhindaw

Copyright © 2012 Samavedam Santhi et al. This is an open access article distributed under the Creative Commons Attribution License, which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited.

How to Cite this Article

Samavedam Santhi, S. B. Sakri, Dharwada Hanumantha Rao, and Srinivasan Sundarrajan, “Mould Filling Ability Characterisation of Cast Aluminium Alloys Using Design of Experiments,” Journal of Metallurgy, vol. 2012, Article ID 624650, 10 pages, 2012. https://doi.org/10.1155/2012/624650.