Table of Contents
Journal of Structures
Volume 2014 (2014), Article ID 403916, 20 pages
http://dx.doi.org/10.1155/2014/403916
Research Article

Seismic Behavior of Steel Off-Diagonal Bracing System (ODBS) Utilized in Reinforced Concrete Frame

1Department of Structural Engineering, Aisan Disman Consulting Engineers, 10th Unit, 5th Floor, Boostan Complex, Daneshsara Traffic Light, Saadi Street, Kermanshah 6718783559, Iran
2Department of Civil & Structural Engineering, School of Engineering, Shiraz University, Shiraz, Iran

Received 3 December 2013; Revised 1 April 2014; Accepted 19 April 2014; Published 10 July 2014

Academic Editor: Chris G. Karayannis

Copyright © 2014 Keyvan Ramin. This is an open access article distributed under the Creative Commons Attribution License, which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited.

Linked References

  1. Y. Guan, X. Cheng, and Y. Zhang, “Study on the earthquake disaster reduction information management system and its application,” International Journal of Intelligent Systems and Applications, vol. 1, pp. 51–57, 2011. View at Google Scholar
  2. H. Rastiveis, F. Samadzadegan, and P. Reinartz, “A fuzzy decision making system for building damage map creation using high resolution satellite imagery,” Natural Hazards and Earth System Science, vol. 13, no. 2, pp. 455–472, 2013. View at Publisher · View at Google Scholar · View at Scopus
  3. A. Gourabi and M. Yamani, “Active faulting and quaternary landforms deformation related to the Nain fault,” The American Journal of Environmental Sciences, vol. 7, no. 5, pp. 441–447, 2011. View at Publisher · View at Google Scholar · View at Scopus
  4. A. Amiri and R. Tabatabaei, “Earthquake risk management strategy plan using nonparametric estimation of hazard rate,” American Journal of Applied Sciences, vol. 5, no. 5, pp. 581–585, 2008. View at Google Scholar · View at Scopus
  5. F. Altun and F. Birdal, “Analytical investigation of a three-dimensional FRP-retrofitted reinforced concrete structure's behaviour under earthquake load effect in ANSYS program,” Natural Hazards and Earth System Science, vol. 12, no. 12, pp. 3701–3707, 2012. View at Publisher · View at Google Scholar · View at Scopus
  6. A. Vatani Oskouei and M. H. Rafiee, “Damage modeling in reinforced concrete bending frames originated by quake and its restoration using X-bracing system,” Esteghlal, vol. 28, no. 1, pp. 49–73, 2009. View at Google Scholar
  7. G. Ghodrati Amiri, A. Gholamrezatabar, and S. A. Razavian Amrei, “Evaluation of performance of reinforced concrete frame retrofitted using concentric steel bracing,” Journal of Structure and Steel: Iranian Society of Steel Structures, vol. 4, no. 4, pp. 17–25, 2008 (Persian).
  8. G. R. Kumar, S. R. S. Kumar, and V. Kalyanaraman, “Behaviour of frames with non-buckling bracings under earthquake loading,” Journal of Constructional Steel Research, vol. 63, no. 2, pp. 254–262, 2007. View at Publisher · View at Google Scholar · View at Scopus
  9. S. Sugano and M. Fujimura, “Seismic strengthening of existing reinforced concrete building,” in Proceedings of the 7th World Conference on Earthquake Engineering, vol. 4 of part 1, pp. 449–459, Istanbul, Turkey, 1980.
  10. S. Kawamata and M. Ohnuma, “Strengthening effect of eccentric steel braces to existing reinforced concrete frames,” in Proceedings of the 2nd Seminar on Repair and Retrofit of Structures Conference, NSF, Ann Arbor, Mich, USA, 1981.
  11. A. C. Masri and S. C. Goel, “Seismic design and testing of an RC slab-column frame strengthened by steel bracing,” Earthquake Spectra, vol. 12, no. 4, pp. 645–666, 1996. View at Google Scholar · View at Scopus
  12. T. D. Bush, L. A. Wyllie, and J. O. Jirsa, “Observations on two seismic strengthening schemes for concrete frames,” Earthquake Spectra, vol. 7, no. 4, pp. 511–527, 1991. View at Publisher · View at Google Scholar
  13. A. Tasnimi and A. Masoumi, “study of the behavior of reinforced concrete frames strengthened with steel brace,” in Proceedings of the 3rd International Conference on Seismology and Seismic Engineering, Tehran, Iran, 1999.
  14. A. Kheyroddin, “study of non-linear behavior of reinforced concrete frames retrofitted with steel brace,” in Proceedings of the 1st Concrete and Development Conference, pp. 89–98, Tehran, Iran, 2001.
  15. H. Abou-Elfath and A. Ghobarah, “Behaviour of reinforced concrete frames rehabilitated with concentric steel bracing,” Canadian Journal of Civil Engineering, vol. 27, no. 3, pp. 433–444, 2000. View at Google Scholar · View at Scopus
  16. M. R. Maheri and R. Akbari, “Seismic behaviour factor, R, for steel X-braced and knee-braced RC buildings,” Engineering Structures, vol. 25, no. 12, pp. 1505–1513, 2003. View at Publisher · View at Google Scholar · View at Scopus
  17. H. A. Moghaddam and H. E. Estekanchi, “Seismic behaviour of offcentre bracing systems,” Journal of Constructional Steel Research, vol. 51, no. 2, pp. 177–196, 1999. View at Google Scholar · View at Scopus
  18. H. A. Moghaddam and H. Estekanchi, “On the characteristics of an off-centre bracing system,” Journal of Constructional Steel Research, vol. 35, no. 3, pp. 361–376, 1995. View at Google Scholar · View at Scopus
  19. M. Berberian and I. Navai, “Naghan (Chahar Mahal Bakhtiari-High Zagros, Iran) earthquake of 6 april 1977. A preliminary field report and a seismotectonic discussion,” Annals of Geophysics, vol. 40, no. 1, pp. 51–77, 1977. View at Google Scholar
  20. J. H. Steidl and Y. Lee, “The SCEC Phase III strong-motion database,” Bulletin of the Seismological Society of America, vol. 90, no. 6, pp. S113–S135, 2000. View at Google Scholar · View at Scopus
  21. S. A. R. Amrei, G. G. Amiri, and D. Rezaei, “Evaluation of horizontal seismic hazard of Naghan, Iran,” World Academy of Science, Engineering and Technology, vol. 5, pp. 1456–1458, 2011. View at Google Scholar
  22. M. R. Maheri and H. Ghaffarzadeh, “Connection overstrength in steel-braced RC frames,” Engineering Structures, vol. 30, no. 7, pp. 1938–1948, 2008. View at Publisher · View at Google Scholar · View at Scopus
  23. H. Ghaffarzadeh and M. R. Maheri, “Cyclic tests on the internally braced RC frames,” Journal of Seismology and Earthquake Engineering, vol. 8, no. 2, pp. 177–186, 2006. View at Google Scholar
  24. C. G. Karayannis, M. J. Favvata, and D. J. Kakaletsis, “Seismic behaviour of infilled and pilotis RC frame structures with beam-column joint degradation effect,” Engineering Structures, vol. 33, no. 10, pp. 2821–2831, 2011. View at Publisher · View at Google Scholar · View at Scopus
  25. K. Ramin, Seismic investigation and numerical analysis of RC frame retrofitted by off diagonal steel bracing system (ODBS) [Master of Science Degree], Department of Civil Engineering, Shiraz University, 2009 (Persian).
  26. M. A. Youssef, H. Ghaffarzadeh, and M. Nehdi, “Seismic performance of RC frames with concentric internal steel bracing,” Engineering Structures, vol. 29, no. 7, pp. 1561–1568, 2007. View at Publisher · View at Google Scholar · View at Scopus
  27. C. Uang, “Establishing R (or Rw) and Cd factors for building seismic provisions,” Journal of Structural Engineering, vol. 117, no. 1, pp. 19–28, 1991. View at Google Scholar · View at Scopus
  28. ATC, “Structural response modification factors,” ATC-19 Report, Applied Technology Council, Redwood City, Calif, USA, 1995. View at Google Scholar
  29. I. Anam and Z. N. Shoma, “Nonlinear properties of reinforced concrete structures,” Tech_ Bulletin n & Journal, Department of Civil and Environmental Engineering, The University of Asia Pacific, 2011. View at Google Scholar
  30. Y. Bozorgnia and V. Bertero, Earthquake Engineering: From Engineering Seismology to Performance-Based Engineering, CRC Press, New York, NY, USA, 2004.
  31. M. R. Maheri and A. Hadjipour, “Experimental investigation and design of steel brace connection to RC frame,” Engineering Structures, vol. 25, no. 13, pp. 1707–1714, 2003. View at Publisher · View at Google Scholar · View at Scopus
  32. ANSYS, ANSYS Manual, ANSYS, Canonsburg, Pa, USA, 2009–2015.
  33. ATC, “A critical review of current approaches to earthquake-resistant design,” ATC-34 Report, Applied Technology Council, Redwood City, Calif, USA, 1995. View at Google Scholar