Texture, Stress, and Microstructure

Texture, Stress, and Microstructure / 1988 / Article

Open Access

Volume 8 |Article ID 153838 | https://doi.org/10.1155/TSM.8-9.679

M. Eckhardt, H. Ruppersberg, "Influence of Texture on a(sin2ψ) Curves Obtained From a Cold Rolled Nickel Sheet using Synchrotron Radiation", Texture, Stress, and Microstructure, vol. 8, Article ID 153838, 13 pages, 1988. https://doi.org/10.1155/TSM.8-9.679

Influence of Texture on a(sin2ψ) Curves Obtained From a Cold Rolled Nickel Sheet using Synchrotron Radiation

Received29 Jul 1987
Accepted20 Nov 1987

Abstract

The Two-Axis Diffractometer at HASYLAB was used to measure a(sin2ψ) curves by reflecting synchrotron radiation from five different lattice planes of a cold rolled nickel sheet. We are especially interested in the complex surface state of the specimen and investigated the sample as delivered without further polishing and etching. Strongly non-linear a(sin2ψ) curves were observed. Most of them vary in a non-linear way if external uniaxial stress is applied. In this paper we study the influence of texture using formalism based on the ODF, and evaluated for the Reuss and the Voigt cases, respectively. Texture alone, however, is not sufficient to explain the whole variety of the observed effects.

Copyright © 1988 Hindawi Publishing Corporation. This is an open access article distributed under the Creative Commons Attribution License, which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited.


More related articles

 PDF Download Citation Citation
 Order printed copiesOrder
Views38
Downloads0
Citations